EZFIX 1080P Wired Security Camera Instruction Manual

**EZFIX 1080P Wired Security Camera Instruction Manual

**

Warnings

• Proper configuration of all passwords and other security seings is the responsibility of the installer and/or end-user.
• In the use of the product, you must be in strict compliance with the electrical safety regulations of the nation and region. Please refer to technical specifications for detailed information.
• Input voltage should meet both the SELV ( Safety Extra Low Voltage) and the Limited Power Source with 12V DC according to the IEC60950-1 standard. Please refer to technical specifications for detailed information.
• Do not connect several devices to one power adapter as adapter overload may cause overheating or a fire hazard.
• Please make sure that the plug is firmly connected to power socket.
• If smoke, odor or noise rise from the device, turn o the power at once and unplug the power cable, and then please contact the service center.

Get 24/7 Assistance at Use camera of QR scanner to scan

Dy Visit: https: We fix .after service vip

Introduce the Cameras

Technical Parameters

8MP:3840(H)×2160(V)
Warm Light Range| 15~20 m
Video Output Mode| AHD/CVI/TVI/CVBS Optional
Day/Night| Colo
Video Frame Rate| 1080P:25fps(50Hz),30fps(60Hz) 4MP:25fps(50Hz),30fps(60Hz) 5MP:12.5fps,20fps 8MP:12.5fps,15fps
Led on of Min Illumination| Color: 3 Lux @ (F1.0/F1.6/F2.1, AGC ON) with warm light
S/N Ratio| >520dB
Shuer Time| 1/25s(1/30s)~1/100,000s
White Balance| Auto/Manual
AGC| Yes
Operating Conditions| -20℃~+50℃,Humidity 90% or less (non-condensing)
Power Supply| DC12V(±10%)
Weather Proof| IP66

Note: The 1080P analog camera should work with 1080P DVR together.

The 5MP analog camera should work with 5MP DVR together.

This device is only camera without power supply, BNC cable and DVR

The analog camera should work together with 1080P/5MP DVR through BNC cable.

Ceiling Mounting for Camera

Proper configuration of all passwords and other security seings is the responsibility of the installer and/or end-user.

Steps:

1. Drill the screw holes in the ceiling according to the bracket.

2. Connect the corresponding power cable and video cable.

3. Fix the camera to the ceiling with the supplied screws.
   **Fix Camera to the Ceiling

   ---

4. 04/ Adjust the surveillance angle

1. Loosen No.3 adjusting screw to adjust the panning
   ition (0°～360°) 2) Tighten No.3 adjusting screw.

5. Loosen the No.2 adjusting screw to adjust the tilting position (0°～90°)
6. Tighten No. 2 adjusting screw
7. Loosen No.1 adjusting screw to adjust the azimuth angle of the image (0°～360°)
8. Tighten No.1 adjusting screw.

3-axis Adjustment

Manufacturer and Brand Owner: Relog Intelligent Security Co., Ltd Address: F10a, 3rd floor, Jeannine Plaza, Chuffing Road,
Renmin South Road, Lihou Community,
Nanmu Street, Lihou District, Shenzhen

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>