MOOFIT HR6 Heart Rate Monitor Chest Strap User Manual
- June 14, 2024
- moofit
Table of Contents
MOOFIT HR6 Heart Rate Monitor Chest Strap
Thank you for using this product as your sports fitness product of choice. The
product is a sensor-type heart rate monitor that will track your real-time
heart rate and send heart rate data to the Smart phone. This manual contains
important safety and care information and provides step by step instructions
for using this product. Read it thoroughly, and keep the manual in a safe
place in case you need to refer to it later.
IMPORTANT This product is for sports purposes only and it is not meant to
replace any medical advice.
Unpacking the product
-
How to use the heart rate monitor Wet the conductive pads on the rear of the chest belt with a few drops of water, Saliva, or conductive gel to ensure solid contact.
-
Strap the heart rate chest belt across your chest. To ensure an accurate heart rate signal, adjust the strap until the belt fits snugly below your (chest) pectoral muscles.
-
Attach the transmitter to the strap, marked ‘L’ towards the left.
WARNING Inaccurate heart rate data will be detected if the device is worn in the wrong direction.
To run software on a smart smartphone, receive the heart rate data. ATTENTION Please KEEP wearing the heart rate monitor when you pair it with your fitness app or smart device.
- WARNING
- Cleaning of the transmitter and strap in a washing machine or dryer is strongly prohibited.
- Before hand washing the device, detach the transmitter of the Heart Rate Monitor where the electrodes are located, This part is not washable.
- While washing the straps, make sure the water is no higher than 30 C.
- Ironing, bleaching, or heating is prohibited.
Batteries
The transmitter use a CR2032 3V battery. The battery is already installed. The
battery typically lasts one year. Using a coin, twist the battery door
counterclockwise until it clicks out of place. To run software on a smart
smartphone, receive the heart rate data. Remove the old battery and insert the
new battery with the +side upwards. Replace the battery door by twisting it
clockwise until it is firmly in place.
IMPORTANT
- Non-rechargeable and rechargeable batteries must be disposed of properly. For this purpose, special containers are provided for battery disposal at communal collection centers.
- Batteries are extremely dangerous when swallowed! Therefore, keep batteries and small articles away from children.
- The batteries supplied must not be recharged, reactivated by any other means, dismantled, put into fire, or short-circuited.
Data transmission
ANT+&BLE Sports System is supported to achieve reliable data transmission by
this HRM.
For Bluetooth 4.0 LE System
- This device is a Bluetooth Smart device, compatible and applicable with many devices, including
- iPhone 4S and later version
- The New iPad and later version
- iPod Touch 5
- SmartPhone with Android 4.4 or later (Like Samsung Galaxy S4 S5) In addition, this device is also recommended to work with the following APP.
For ANT+ System
Pairing
If the HRM is not paired with the ANT+ compatible receiver, it has to be
activated and paired.
- Ensure that the HRM battery is not drained. Replace the battery if needed.
- Ensure there are no other ANT+ transmitting devices within 50 m range, other devices may affect pairing.
Ready to use If your device is successfully paired, it’s ready for use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>