moofit CS8 Cycling Cadence Speed Sensor User Manual
- June 14, 2024
- moofit
Table of Contents
moofit CS8 Cycling Cadence Speed Sensor
Speed sensor
Product Introduction
Thank you for purchasing our wireless dual-mode cycling sensor. This
product is one of the bicycle peripheral products of our company, one is speed
sensor and the other is cadence sensor. This user manual will help you better
use the product, please keep it for reference.
Product Accessories
Basic Parameters
Product size: 38 x 30 x lD mm| Communication:
ANT+ /Sm
BLE/l0m
---|---
Product net weight: 9g
Electrical source: CR2032 220mAh
Battery life:
320h for speed mode
| Measurement of extreme value:
l20km/h for speed
Waterproof grade: IP67| Outer case: ABS
Working temperature: -20C~60C| Coloc Black and orange
Remove the insulation sheet before use
Twist the battery door with a coin in OPEN direction, open the battery
door, remove the battery. After putting in the battery, the light goes on.
Installation for speed mode
Buckle the curved rubber mat onto the back of the sensor, then bind the sensor
with the large rubber band onto the wheel axle.
Compatible with various App
Note: The copyrights of the App icons showed above reserved by the App
development corporation.
Disclaimer
- The information in this manual is for your reference only. The product described above may be subject to alteration owing to the manufacturer’s continuing research and development plans, without making an announcement in advance.
- We shall not make any statement or warranty with respect to this manual or the products described herein.
- We shall not bare any legal responsibility for any direct or indirect, accidental or special damages, losses and expenses arising from or in connection with this manual or the products described herein.
Cadence sensor
Product Introduction
Thank you for purchasing our wireless dual-mode cycling sensor. This product
is one of the bicycle peripheral products of our company, one is speed sensor
and the other is cadence sensor. This user manual will help you better use the
product, please keep it for reference.
Product Accessories
Basic Parameters
Product size: 38 x 30 x 1 O mm| Communication:
ANT+ /Sm
BLE/lOm
---|---
Product net weight 9g
Electrical source: CR2032 220mAh
Battery I ife:
320h for cadence mode
| Measurement of extreme value:
300rpm for cadence
Waterproof grade: IP67| Outer case: ABS
Working temperature: -20 C ~60 C| Color: Black and orange
Remove the insulation sheet before use
Twist the battery door with a coin in OPEN direction, open the battery
door, remove the battery. After putting in the battery, the light goes on.
Installation for cadence mode
Buckle the flat rubber mat onto the back of the sensor, then bind the sensor
with the small rubber band onto the pedal crank.
Compatible with various App
Note: The copyrights of the App icons showed above reserved by the App
development corporation.
Disclaimer
- The information in this manual is for your reference only. The product described above may be subject to alteration owing to the manufacturer’s continuing research and development plans, without making an announcement in advance.
- We shall not make any statement or warranty with respect to this manual or the products described herein.
- We shall not bare any legal responsibility for any direct or indirect, accidental or special damages, losses and expenses arising from or in connection with this manual or the products described herein.