PROfezzion PMSW-SW1 2 in 1 for MagSafe Wallet Stand User Manual
- June 14, 2024
- PROfezzion
Table of Contents
PROfezzion PMSW-SW1 2 in 1 for MagSafe Wallet Stand
PMSW-SWl
Manual
Magnetic Wallet
Package List
- Magnetic Wallet xl
- Safety String xl
- Transparent Part xl
- 3M Adhesive Metal Ring x2
- Clear Protective Film x2
- Wet Cleaning Wipe x2
- Metal Ring Positioning
- Operation Instruction xl
- Instruction Manual xl
Parts
- Magnetic Wallet
- Silicone Pad
- Ergonomic Locking Design
- String Hole
- Safety String
- Transparent Part
Specifications
| Item | Specifications |
|---|---|
| Material | ABS+ Silicone +Metal/ |
| Magnetic Force | 2.0 lbs/ 0.9 kg |
| Product Dimension | 4.0×2.7×0.5″ 100.4×68.0xll .5 mm |
| Compatibility |
- Mobile Phone or Phone Case with Massif;
- Non-Mag Safe Phone or Phone Case Using the Included Metal Rin g
Note: If your phone or phone case is not MagSafe-compatible, please stick the included 3M adhesive metal ring onto the back. For details about installing the 3M adhesive metal ring, please read the Metal Ring Positioning Operation Instructions in the package.
- Critical Information for the Sticky Metal Ring
- Only adhere well to a flat plastic, metal, glass or hard material surface. @ Does not adhere to the soft and uneven leather, vinyl, rubber or any other soft material surface.
- Clean & dry the surface, press it down firmly for 30s and let it sit 24 hours before use.
- One-time use only. Once removed, it cannot be re-mounted.
Guide
- Use as a Magnetic Wallet
- Use as a Phone Stand
Attach the Safety String
If your magnetic phone case has a string hole on the side, please refer to
the following steps for installation:
- Rotate counterclockwise to disconnect both ends of the safety string.
- Assemble one end to the wallet string hole.
- Assemble the other end to the phone case string hole.
- Install your mobile phone onto the magnetic phone case.
- Rotate clockwise to connect both ends of the safety string, then place the magnetic wallet onto the back of the magnetic phone case.
If your magnetic phone case has no string hole, please install it with the included transparent part. Below steps are for your reference:
- Assemble one end of the safety string to the magnetic wallet, and install the other end to the transparent part.
- Pass the string end connecting with the transparent part through the bottom socket of the magnetic phone case, and then install your phone onto the phone case to pin down the transparent part.
- Rotate clockwise to connect both ends of the safety string, then place the magnetic wallet onto the back of the magnetic phone case.
Insert & Take out Cards
- Insert : Open the ergonomic locking system and insert your card between the silicone pad and the shell. CD You can store two cards within each compartment respectively.
- Take out : Slide the card out with your thumb.
Other MagSafe Products Compatible
PROfezzion PMSW- SWl Series Magnetic Wallet is directly compatible with
Profession PPS Series MagSafe Magnetic Car Mount and Profession MRH-MSl Series
MagSafe Magnetic Ring Holder (sold separately).
- No need to remove for the PROfezzion MagSafe Magnetic Car Mount& Magnetic Ring Holder
- Instant removal for the MagSafewireless charger
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>