Cornesty A9 Portable Blender User Manual

: June 14, 2024
: Cornesty

Table of Contents

Cornesty A9 Portable Blender User
Product Information
Cautions
Your First Blend
Procedure
Tips
Warranty
Malfunction Analysis and Troubleshooting
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

Cornesty A9 Portable Blender User

Product Information

Specifications :

Model: A9
Jar Capacity: 600ml
Jar Material: AS (Food Grade)
Base Material: ABS
Blade Material: 304 Stainless Steel
Blending Voltage: 7.4V
Charging Voltage / Current: 5V / 1A
Battery Type / Capacity: 18650 / 2000mAh*2
Motor Speed: 18000rpm
Charging Time: About 3 to 5 hours
Single blend time of Blend mode: 30-second cycle
Maximum blend time of Pulse mode: 30 seconds

Product Usage Instructions

Your First Blend:

Before using the blender for the first time, follow these steps:

Check whether all indicator lights are green to ensure the blender is fully charged.
Tighten the body and base until the magnet is aligned with the power button.
Remember to clean the blender immediately after use.

Pro Tips:

BLEND MODE: Perfect for smoothies, shakes, and mixed drinks.
PULSE MODE: Perfect for salsa, jams, small ice-cubes, frozen fruits, and extra tough ingredients.

Procedure:

Cut fruits into small pieces before adding them to the blender, filling up about 60% of the jar capacity.
Add some drinkable liquid until it reaches 80% of the jar capacity.
Tighten the lid and tilt down the blender to make sure fruit pieces are not stuck under the blades.
For Blend Mode: Click once on the power button to start blending. The green lights will turn on. Slightly tilt the blender back and forth while blending if desired.
For Pulse Mode: Double-click the power button to enter pulse mode. The yellow lights will turn on. Press and hold the power button repeatedly to pulse. Pulse mode will automatically end after 5 seconds of inactivity, and the yellow lights will turn off.

Cautions:

The USB port is waterproof, but avoid soaking the stand in water or putting it into the dishwasher for a long time to prevent damage to the battery or motherboard after water ingress.
Do not blend hard-shelled fruits, nuts, or large pieces of frozen fruits. It is recommended to cut fruits or vegetables into small pieces (approximately 1 inch/CM) to avoid jamming of the blade and blocking protection.

FAQ

Q: What should I do if all indicator lights are in red or there is no light, and the blender is unable to start?

A: This could indicate that the blender has run out of battery. Charge it for 3 to 5 hours to ensure it gets a full charge.

Q: What should I do if all indicator lights flicker in red andgreen alternately, and the blender is unable to start?

A: The jar is not tightened to the base. Tighten the jar and base, making sure the magnet is aligned with the power button.

Q: What should I do if the blender stops working after 5 seconds and all indicator lights flicker in red for 8 seconds?

A: This could indicate leakage or the blender being empty. Add ingredients into the blender to start blending.

Q: What should I do if the ingredient is too thick or theM volume is too big, and the motor overload protection stops the blender from working?

A: Add some liquid or cut ingredients into smaller pieces, or shift into Pulse Mode, then restart the blender.

Q: What should I do if there is a problem with the seal or the jar/cap is cross-threaded?

A: Check the seals and thread alignment when screwing on the jar/cap.

Cautions

DO NOT remove the lid or add in something rigid in your blender when it is blending.
DO NOT submerge the base into water to prevent base elements from damaging and make sure it is off before cleaning.
DO NOT disinfect your blender in microwave or hot water above 80°C.
DO NOT put your blender in freezer.
DO NOT clean your blender with any kind of metallic spiral ball to prevent parts from scratching or damaging.
DO NOT clean your blender with a dishwasher machine.
DO NOT charge your blender when it is wet.
DO NOT repair or disassemble it by yourself otherwise your warranty will be void. If malfunction occurred, kindly contact us.

Your First Blend

Make sure your blender is fully charged by checking whether all indicator lights are green before your first blend. Tighten the body and base until the magnet is aligned
with the power button.
Remember to clean it immediately after use.

Pro Tips

BLEND MODE: Perfect for smoothies, shakes and mixed drinks.
PULSE MODE：Perfect for sala, jams,small ice-cube, frozen fruits and extra tough ingredients.

Check Battery Level

1%- 17%：no lights
18%-33% : 2 green lights on
34%-50% : 4 green lights on
51%-67% : 6 green lights on
68%-83% : 8 green lights on
84%-99% : 10 green lights on
Fully charged, all green lights on, red light off

Procedure

Cut fruits into small pieces before adding into the blender to fill up about 60% of the jar capacity.
Add some drinkable liquid until it reaches 80% of jar capacity.
Tighten the lid and tilt down the blender to make sure fruit pieces are not stuck under the blades.
Blend Mode: Click once power button to start blending and green lights on.Slightly tilt it back and forth while blending if desired. Pulse Mode: Double-click power button to enter into pulse mode and yellow lights on. Press and hold the power button repeatedly to pulse. Pulse mode will automatically end after 5S of inactivity and yellow lights off.

Tips

Pulse Mode
Double click to switch pulse mode, orange light will be on.
Bottom cover

The USB port is waterproof. It is prohibited to soak the stand in water or put it into the dishwasher for cleaning for a long time to avoid damage to the battery or motherboard after water ingress.
Do not mix with hard shelled fruits, nuts, and large pieces of frozen fruits. It is recommended that fruits or vegetables be cut into small pieces of 1 inch/CM to avoid jamming of the blade and blocking protection.

Overview

PORTABLE BLENDER

Imported Environmental-friendly Materials CE, ROHS, FCC Approval

Warranty

We offer 12 months warranty on all our products for fault or product quality.Accidental damage or damage as a result of misuse is not covered under this warranty.

Malfunction Analysis and Troubleshooting

Malfunction	Analysis	Troubleshooting
All indicator lights in red or no light, unable to start.

Ran out of battery.

| Charge it for 3 to 5 hours to make sure that it gets a full charge.
All indicator lights flicker in red and green alternately, unable to start.|

The jar is not tighten to the base.

| Tighten the jar and base, make sure the magnet is aligned with the power button.

Stop working after 5 seconds.

|

Blender is empty.

| Add ingredients into blender to start blending.
Stop working, all indicator lights flicker in red for 8 seconds.| Ingredient is too thick or volume too big, motor overload protection.| Add some liquid or cut ingredients into smaller pieces or shift into Pulse Mode, then restart it.

Leakage.

| The seal is not placed properly; jar/cap is cross-threaded.| Check seals; check thread alignment when screwing on jar/cap.

NOTE

Product is suitable for USB Type-C cable. Suitable for power bank charging as well.
When not been used for a long time, charge it fully first to keep battery in high voltage state in order to prevent from damage.