Trust 71278 Waterproof Socket Dimmer Instruction Manual

June 14, 2024
Trust

Trust 71278 Waterproof Socket Dimmer

Trust-71278-Waterproof-Socket-Dimmer-PRODUCT

INSTALLATION INSTRUCTION

Trust-71278-Waterproof-Socket-Dimmer-FIG-1 Trust-71278-Waterproof-Socket-Dimmer-FIG-2 Trust-71278-Waterproof-Socket-Dimmer-FIG-3

Place Dimmer

  • Connect the lamp to the dimmer and place the dimmer in a socket outlet.
  • B The dimmer pairing mode will be activated. The pairing mode lasts for 6 seconds.

Pairing the dimmer with a transmitter

  • Send an ON signal within 6 seconds with a Trust Smart Home transmitter during pairing mode. The dimmer can store up to 32 different transmitters in its memory. The paired transmitters are kept if the dimmer is moved to another socket outlet.

Control the dimmer

  • Press the ON button with the assigned channel on the paired transmitter to turn on the dimmer/lamp. Do not exceed the maximum load: of 200W.
  • B Press the OFF button with the assigned channel on the paired transmitter to turn off the dimmer/lamp.
  • Should your lights vibrate check whether your lamp is dimmable or try another dimmable lamp.
Set dimming range
  • Each type of lamp (incandescent lamp, halogen, or dimmable LED lamp) has a different dimming range.
  • Therefore you can set the lowest dimming value for the type of lighting that is connected.
  • Put the dimmer in pairing mode. (See chapter 1)
  • B During pairing mode, press and hold the ON button for 3 seconds. (for the ACCT-510 and ACST-9900 the ON-OFF button).
  • C The lamp will flash 2x to confirm that the dimming range can be set
  • Give an ON signal with the paired transmitter to increase the dim level 1 step. Give an OFF signal to decrease the dim level 1 step.
  • E When the desired dimming range has been selected, press and hold the ON button for 3 seconds. (for the ACCT-510 and ACST-9900 the ON-OFF button)
  • F The connected lighting will flash 2x and dim to the lowest dim level as confirmation that the dimming range has been saved

Activate dimming sequence

  • Press the ON button of a paired transmitter to turn on the receiver.
  • B Press ON again to start the dimming sequence and activate
  • C Press ON a third time to lock the desired dimming level.
  • The dimming sequence will stop and lock automatically at the highest or lowest point when no signal is given to a transmitter.

Optional: Remove the transmitter from the dimmer

  • Remove the dimmer from the socket outlet. After 6 seconds, plug the dimmer back into the socket outlet.
  • B The pairing mode will be activated for 6 seconds. Send an OFF signal within 6 seconds with a paired channel of the Trust Smart Home transmitter to unpair it.
  • C The connected lamp will flash 2x to confirm unpairing.

Optional: Clear memory

  • Remove the dimmer from the socket outlet. After 6 seconds, plug the dimmer back into the socket outlet.
  • B The pairing mode will be activated for 6 seconds. Send a GROUP OFF signal within 6 seconds with a paired channel of the Trust Smart Home transmitter to clear the memory.
  • C The connected lamp will flash 2x to confirm unpairing.

Safety Instructions

  • Product support: www.trust.com/71278. Warranty conditions: www.trust.com/warranty
  • To ensure the safe handling of the device, follow the safety advice on: www.trust.com/safety
  • The Wireless range is strongly dependent on local conditions such as the presence of HR glass and reinforced concrete Never use Trust Smart Home products for life-support systems. This product is water-resistant. Do not attempt to repair this product. Wire colors may vary per country. Contact an electrician when in doubt about wiring. Never connect lights or equipment that exceed the maximum load of the receiver. Exercise caution when installing a receiver voltage may be present, even when a receiver is switched off. Radio transmission frequency range: 433,92 MHz
  • Disposal of packaging materials – Dispose of packaging materials that are no longer needed under applicable local regulations. The packaging materials have been selected for their environmental friendliness and ease of disposal and are therefore recyclable.
  • Disposal of the device – The adjacent symbol of a crossed-out wheelie bin means that this device is subject to Directive 2012/19/EU. his directive states that this device may not be disposed of in normal household waste at the end of its usable life, but must be handed over to specially set-up collection locations, recycling depots, or disposal companies. This disposal is free of charge for the user.
  • Disposal of batteries – Used batteries may not be disposed of in household waste. Only dispose of batteries when they are fully discharged. Dispose of batteries according to local regulations. Cover the poles of partially discharged batteries with tape to prevent short circuits.
  • Trust Electronics Ltd. declares that item number 71278/71278-02 complies with Directive Electromagnetic Compatibility Regulations 2016, and Radio Equipment Regulations 2017. The full text of the declaration of conformity is available at the following internet address: www.trust.com/compliance
  • Trust International B.V. declares that item number 71278/71278-02 complies with Directive 2014/53/EU – 2011/65/EU. The full text of the EU Declaration of Conformity is available at the following web address: www.trust.com/compliance

Declaration of Conformity

Trust International B.V. declares that this Trust Smart Home-product:

  • Model: AGC-200 WATERPROOF SOCKET DIMMER
  • Item number: 71278/71278-02
  • Intended use: Outdoor complies with the essential requirements and other relevant provisions of the following directives:
  • ROHS 2 Directive (2011/65/EU)
  • RED Directive (2014/53/EU)
  • The full text of the EU Declaration of Conformity is available at the following web address: www.trust.com/compliance
  • TRUST SMART HOME
  • LAAN VAN BARCELONA 600
  • 3317DD DORDRECHT
  • NEDERLAND
  • www.trust.com
  • Trust Electronics Ltd.,
  • Sopwith Dr, Weybridge, KT13 0NT, UK.
  • All brand names are registered trademarks of their respective owners.
  • Specifications are subject to change
  • without prior notice. Made in China.

TECHNICAL SPECIFICATIONS

Code system Automatic
Memory Addresses 32
Max Wattage 200 Watt (LED bulbs Max 100 Watt)
Power 220-240VAC 50 Hz
Size HxBxL: 53 x 53 x 70 mm
IP-Rating IP-44

SUPPORTED LOAD

Incandescent and halogen lamps 20-200W
12V halogen lamps with electronic transformer 20-200W
12V halogen lamps with iron core transformer 40-200W
Dimmable ESL/LED 3-100W

www.trust.com

Documents / Resources

| Trust 71278 Waterproof Socket Dimmer [pdf] Instruction Manual
71278 Waterproof Socket Dimmer, 71278, Waterproof Socket Dimmer, Socket Dimmer, Dimmer
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals