cultsport Exerciser Bicycle Owner’s Manual

: June 14, 2024
: Cultsport

Table of Contents

IMPORTANT SAFETY PRECAUTIONS
parts list
EXPLODED DRAWING
ASSEMBLY INSTRUCTIONS
OPERATION
MAINTENANCE
FUNCTIONS AND OPERATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

cultsport Exerciser Bicycle

IMPORTANT SAFETY PRECAUTIONS

WARNING : To reduce the risk of serious injury, read the following important precautions before using this Bicycle Exerciser.

It is the responsibility of the owner to ensure that all users of the exerciser are adequately informed of all warnings and precautions.
Read all instructions in this manual before using the exerciser. Use the exerciser only as described.
Place the exerciser on a level surface. Cover the floor beneath the exerciser to protect the floor of carpet.
Inspect and tighten all parts regularly. Make sure that the chain is properly adjusted. Replace any worn parts immediately.
Keep children under age 12 and pets away from the exerciser at all times.
The exerciser should not be used by persons weighing more than 100 kgs or 250 pounds.
Keep hands and feet away from the chain wheel, link chain and other moving parts.
Do not wear loose clothing that could become caught on the exerciser. Always wear athletic shoes for foot protection. Adjust the pedal straps to keep your shoes from slipping away. Rubber soled shoes and athletic socks are recommended. NEVER operate without wearing the shoes.
When adjusting the seat, insert the seat knob through one of the holes in the seat post. Do not Insert the seat knob under the seat post.
If you feel faint, dizzy, or short of breath while exercising, stop immediately and begin cooling down.
The exerciser is intended for home use only. Do not use the exerciser in any commercial, rental or institutional setting
WARNING: Before beginning this or any exercise program, consult your physician. This is especially important for persons over the age of 35 or persons with pre-existing health problems. Read all instructions before using. We assumes no responsibility for personal injury or property damage sustained by through the use of this product.

parts list

Main Frame
Rear Foot Pipe
Front Foot Pipe
Seat Piller (1 & 2)
Seat
Seat Piller Knob
Handle Bar (L&R)
Bolt Foot Pipe (Back Side)
Computer
Tension Belt
Fan Wheel
Paddle (L&R)
Chain / Belt
Rotation Rod
Rowing Arm (L & R)
Plastic Bush
Bolt Foot Pipe
Sleeve Seat Piller
Rached
Shoe W/Steps
Shoe Round
Chain Cover
Crank
Chain / Belt Whee
Trianale Knob

EXPLODED DRAWING

cultsport-Exerciser-Bicycle-fig-1

ASSEMBLY INSTRUCTIONS

Remove the parts and bike from the carton and identify them using the expanded illustration

Step 1. Attach the rear foot pipe. Slide rear foot pipe (part B) into the rear of the main frame (part A), screw in 4 Phillips screws, securing rear foot pipe to main frame.

Step 2. Mount the front foot pipe. Place front strut (part C) into saddle bracket at the front of the frame. The square holes must be placed in down position. Align the holes in the front foot pipe with the holes in the bracket and put 2 carriage bolts through the holes. Place 2 washers on bolts and screw on 2 dome nuts and tighten.

Step 3. Attach the handlebars. Remove the screw, nuts and washers from the rotation rod (part N). Slide handlebar rotation rod though the linkage tube at the top of main frame. The rod may
need a little lubricant to easy slide through the bushings at either end of the linkage tube. Center the rod and rotate it until the set hole inthe rod aligns with the hole in the center of the linkage tube. Screw the fixing screw into the aligned hole and secure it.Attach the left handle (part D), the left handle is marked with an ” L”. Put the handlebar pivot housing on the left side of the rotation rod. Slide the rotation rod’s thread stem through pivot housing bushings. Place the plastic end cap you can find it in the screw pack onto nutafter final tightening. Attach the right handle (part E in the samemanner. Slide the foam grips (part M) on to the handlebars. A small amount of liquid soap will ease installation.

Step 4. Install the pedals. The right pedal (part R) is marked with an “R”. The left pedal (part L) is marked with an “L”. It is important that each pedal goes on the proper side.

Select the right the pedal. Slide a two step bushing on to pedal stem first then put on a washer next to the bushing.
Rotate the handlebar’s link arm to meet the pedal. Bring the “C” slot on the linkarm up from the bottom to hock on the bearing.
Put the pedal stem through the ball bearing and screw it through the pedal arm.right pedal tightens clockwise.
Screw on a lock nut (SILVER) onto the pedal step and tightens it clockwise. Install left pedal in the same manner except left pedal tightens counter – clockwise.
VERY IMPORTANT : Please follow the Figure step by step. The pedal stem must be secure tightly, the lock nut got to be secured tightly . Check them from time to time to insure a longer time for using this equipment.

cultsport-Exerciser-Bicycle-fig-5

Step 5. Remove nuts and washers from studs on bottom of seat (part F: Place seat onto seat post (part G) and replace washers and nuts Secure tightly. Select seat height adjust knob (part K),
Slide seat post into main frame aligning a set of holes in the seat post with the seat height screw hole. Screw in seat post knob, secure tightly.

Step 6. Mount monitor (part H). Insert batteries into battery holder being sure to follow battery diagram, Check to be sure monitor shows a display. If does not, check batteries and battery installation. Plug monitor cable (part J coming from main frame into back of monitor. Slide monitor on to the main frame

OPERATION

LEVELING THE BICYCLE EXERCISER. Place the BICYCLE EXERCISER in the location it will be used. The floor should be hard and flat and the bike should sit firmly on the floor. If the bike is not stable, turn the end caps on the front foot pipe (part C) until the bike is stable. Turn one end cap at a time as it may only be neCeSSArtO adiust one
ADJUSTING THE TENSION The BICYCLE EXERCISER has a tension control knob on the main frame that can be turned to increase or decrease the tension. Turn clockwise to increase. counter-clockwise to decrease. The tension range can be increase or decrease by adjusting he tension strap (part 1). Turn the tension knob counter-clock wise until it stop. Pull the tension strap through the strap’s buckle at the top of the main frame to make the strap tighter around the fan disk increasing the strength of the tension range. Loosen the strap to decrease it. Use the tension knob to further
Wear the proper clothing. Clothes that are not restrictive and are comfortable. NOTE: When wearing long pants, be sure the legs are not too flopping so that they will not get caught in the chain sprocket.
Wear suitable footwear, adjust the pedal strap to kee your shoes from slipping away. Rubber soled shoes and athletic socks are recommended. NEVER operate without wearing the shoes.
Place the exercise bike on a hard flat surface in a convenient area. Be sure there is good air circulation at its location. It is recommended that the surface be ease to clean so that any residual from using, such as perspiration, may be cleaned without a problem.
The bike should not be used by children or handicapped persons without a qualified person in attendance.
Diet is as important as exercising for good physical conditioning. The practice of good nutrition is essential to your fitness program.
DO NOT OVER DO IT. Set goals you can achieve without overexertion.
Always do a warm-up and cool-down period when exercising. Start slow and finish slow.
Consult with a physician before starting any exercise program or diet.
HOW TO MAKE THE HANDLEBARS STATIONARY The handlebars can be made stationary by unlocking the rowing arms from the pedal stems and hooking onto the pegs on the main frame’s front uprights. Loosen the pedal stem first. Drop the rowing arms (part w) drown from the pedal. When free from the pedal, swing the rowing arms forward and hock notch in the edge of rowing arms onto the peg, located on the main frame’s front upright. Be sure it is hooked firmly. Screw back the pedal stem firmly. Do the other side in the same manner.

WARNING: Consult your physician before beginning any exercise program or diet. Good physical conditioning requires good nutrition as well as an exercise program. children or handicapped persons should not use any exercise equipment without a qualified person in attendance.

MAINTENANCE

Check pedal and its lock nut, be sure they are always secured tightly.
Periodically lubricate the moving parts with a light weight household lubricant.
Check all nuts, bolts and clamp assemblies to be sure they are tight and secure.
Check tension strap for wear.
Check monitor batteries.

THE EXERCISE MONITOR

cultsport-Exerciser-Bicycle-fig-11

This monitor is equipped with an auto on/ auto off function. You can view the progress of any function when using the The monitor will come on automatically if the exercise bike is
bike by simply pressing the mode button until the function in motion. If stop exercising for over 4 minutes, monitor will you want to observe is displayed. turn itself off.

FUNCTIONS AND OPERATIONS

SCAN Press the button until the ARROW point to SCAN, (or press the button until SCAN appears) monitor will automatically cycles between SPEED, DISTANCE, TIME & CALORIES every 6 seconds.
SPEED Press the button until the ARROW points to SPEED, the monitor will display the current speed.
DISTANCE Press the button until the ARROW points to DISTANCE and it will display the trip distance you are traveling.
TIMER Press the button until the ARROW points to TIME to count up your up your exercise time.
CALORIES Press the button until the ARROW points to CALORIES to accumulate the calories consumption. An average calorie burn will be accumulated when pedaling the bike and it will be displayed when this function is selected. The calculation is based on length of pedaling time and speed. There is no accumulation when when there is no pedaling action. The calorie count will be cleared each time the unit shuts off. Calories burned are for reference only. User’s age, weight and other factors help to determine actual calories burned.
RESET By pressing the button for 2 seconds, all the functional values will be reset to zero.

Thank you for buying Cultsport Product