ynVISION DESIGN YN-ONE-ADJ Height Adjustable Floor Stands Instruction Manual
- June 14, 2024
- ynVISION DESIGN
Table of Contents
ynVISION DESIGN YN-ONE-ADJ Height Adjustable Floor Stands Instruction
Manual
Read the entire Instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.
CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury.
- Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
- Safety gear and proper tools must be used. This product should only be installed by professions
- Make sure that the supporting surface will solely support the combined weight of the equipment and all attached hardware and components.
- Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
- This product contains small items that could be a choking hazard if swallowed. Keep these items away from children. This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
IMPORTANT Ensure that you have received at parts according to the component checklist prior to installation, any parts are missing or fifty, contact your place of purchase for a replacement
MAINTENANCE: Check that the product is secure and sale to use at regular intervals (at least every three months
Package Content
Assembly Instruction
Note: This nail is for carpet surface.
Note: Remove the pre-assembled screw on the lower column as shown, then
lift the upper part of the column to the desired height and tighten the screws
found on the lower column to hold the column in the new position.
