yOSHIMURA MT-03 Fender Eliminator Kit Installation Guide

yOSHIMURA MT-03 Fender Eliminator Kit

THIS PRODUCT IS NOT DOT-APPROVED

• Yoshimura R&D of America, Inc. is not liable or responsible for any resulting event caused by the installation of this product.
• Check with local laws and regulations for compliance prior to! installation and use.
• This product is not intended for use on public highways.

TOOLS

Assembly Diagram

Removal

1. Remove passenger and rider seats.
2. Remove the two screws securing the plastic tray and remove.
3. Locate and disconnect the license plate light and turn signal wires.
4. While securely supporting the stock fender assembly, remove the four nuts securing the fender assembly to the frame. Carefully remove the stock fender assembly making sure not damage the license plate light and turn signal connectors.
5. Disassemble the stock fender assembly and remove left and right turn signals.
6. Cut the stock license plate light connector from the stock fender assembly. Be sure to cut at least a 6” section of wire from the connector.

Installation

1. Install 070BG-LH-K1, Yoshimura license plate light onto 13330-FEBKT, Yoshimura fender bracket using M4X6BHS, 4mm button head screws provided in the kit.
2. Install H-2158, wire grommet into 13330-FEBKT, fender bracket from below. Make sure to align clips to the fender bracket.
3. Secure 13330-FEBKT, fender bracket to the frame using M6X16BHS, 6mm bolts, and the stock nuts.
4. Using the BN-SSS-22-18, solder shrink connectors provided in the kit, connect
   • Yoshimura license plate light wires to the stock license plate light wires as follows:
   • Red- to-Blue
   • Black- to-Black
   • a) Strip the stock fender light wire ends 1/4” – 1/2” and insert into BN-SSS-22-18, butt connectors provided in the kit.
   • b) Center the spliced wire ends in the middle and using a heat gun or lighter, apply heat evenly on the outer edges of the butt connector to shrink and hold\ wires in place.
   • c) Making sure that the stripped ends are centered, heat the center of the butt connector evenly until the solder begins to liquefy.
   • d ) Allow to cool completely and tug both ends of the wires to verify that the connection is secured Scan for a link to the butt connector instruction video.
5. Install the stock left and right turn signals onto 13992-TSB-L/R, turn signal brackets using the stock hardware.
6. Install 13992-TSB-L/R, turn signal brackets, and 070BG-LPF, license plate frame using M6X16BHS and M6X14BHS, 6mm button head screws as shown.
7. Route the license plate light turn the signal wires under the passenger seat and reconnect.
8. Re-install the plastic tray.
9. Re-install the rider and passenger seats.
10. Check for proper function of the license plate light, turn signals, brake light, and that all brackets and components are secure prior to riding.

• RESEARCH&DEVELOPMENT OF AMERICA, INC 5420 DANIELS STREET STE A, CHINO CA., 91710
• 800-634-9166 · 909-628-4722
• FAX 909-591-2198 www.yoshimura-rd.com .

Documents / Resources

| yOSHIMURA MT-03 Fender Eliminator Kit [pdf] Installation Guide
MT-03 Fender Eliminator Kit, MT-03, Fender Eliminator Kit, Eliminator Kit, Kit
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>