GTS T20200601 Rechargeable Professional Pet Clippers Instruction Manual

June 14, 2024
GTS

T20200601 Rechargeable Professional Pet Clippers

GTS-T20200601-Rechargeable-Professional-Pet-Clippers-product-
image

Instructions

  • Powerful cutting performance for all kinds of dog/cat.
  • Running time over 300 minutes in a fully charge.
  • Detachable ceramic blades for cleaning or replacement easily.
  • Little noise prevent form frightening pet during trimming.
  • Indication light for recharging or using.
  • Ergonomic design provide an easily grip.
  • Cord/cordless using.

USAGE

  • The appliance is just for trim

The usage of direct plugging in

  1. Insert the wired plug of the charge into the rabbet in the electric hair cutter.
  2. Insert the plug of the charge into the outlet after you turn off the clipper.
  3. Turn on and use the clipper.

GTS-T20200601-Rechargeable-Professional-Pet-Clippers-
image-5

The usage of charging

  1. Insert the wired plug of the charge into the rabbet in the electric hair cutter.
  2. Insert the plug of the charge into the outlet after you turn off the clipper.
  3. Pull out plug after it’s fully charged and then you can turn on and use the clipper.

Charge description

  1. The best environment temperature to use the charge is 5 °C to 40°C
  2. Just need to charge it about 3 hours. After you fully charge and discharge or 4 times, the battery capacity will reach its optimal state.
  3. If the charging idle timeout is Too long, the service life of the batteries will be shorten.
  4. Just charge it for low battery or low battery caused by the lack of use.
    It will influence battery performance that you charge it when it’s fully charged. * Because of the initial purchase please charge it before you use it.

THE PREPARATION OF SHAVING

  • Groom the pet fully with the comb.

  • If the pet is dirty or there are something in the body please clean up the pet, drying and groom for it (Pay attention: it will shorten life of the bit tool if you shave the hair with the sand or in moist).

  • Unlock a part of clotted hair. If they can’t be unlocked shave apart of that hair.

THE INSTALLATION AND UNINSTALLATION METHOD OF COMB

  • The installation method of the comb Grasp two side of the comb aim at the button placement and then impel (Pay attention: the comb should be tight)
  • The uninstallation Shove two side of the comb which are buckled (Pay attention: Do not press the broach of the comb. which will damage it.

THE DIRECTION OF SHEARING WITH A COMB

  1. Use the clipper to shave in suitable pets hair direction showed by the arrow.
  2. Cleanup the remaining hair surrounding the combat any moment (The remaining hair may affect the shearing effect)

THE SHEARING METHODS OF DIFFERENT PARTS

  • The head
1. Shave in the negative direction
2. The coagulated hair should be pulled up to shave (you should grasp its mouth to keep the pet steady)
  • The Abdomen
1. Shave from bottom to top. Be careful of the chest (the nipple) or the reproductive organ.

GTS-T20200601-Rechargeable-Professional-Pet-Clippers-
image-2

  • The Foot
1. Shave in the direction of the pet’s ankle in the instep around the foot.
2. In the heel you should shave slowly with the arc.
3. Pay attention to the glabrous part between to toe (showed in the picture) in order to be hurt.
  • The anus
1. Shave lightly from the anus center to outward.
2.  **Pay attention:** shave in the opposite direction of the pet’s hair.  

GTS-T20200601-Rechargeable-Professional-Pet-Clippers-
image-3

CLEAN METHOD

  • Shove with the thumb and then take out the bit tool

  • Clean up the bit tool with cleaning brush like the over picture, you should press the top of knife rest to clean up the remaining hair between the upper blade and lower knife (please do not disassemble the spring in the bit tool in order to cause malfunction).

  • After clean it up you should drop in 3-4 drops of lubricating oil and then enclose the removed bit tool again. ( Do remember: you must aim at slot position when you hear click. you can make sure that they have assembled correctly).

PAY ATTENTION

  1. Do not disassemble the product by yourself.
  2. Do not clear the product with water or keep it in damp places.
  3. Please clear it with a little wet cloth or mild soap solution.
  4. Do not charge it above 40°C heat source or in the sub-zero temperature.
  • It’s normal that the product is overheated when it’s charged
  • Do not use it to shave the damp hair (it will lead to a short circuit and shorten the service life of tool bit)

The disposal of batteries
Rechargeable Nickle cadmium batteries are built in the product so please take out the battery before you throw it away and put it on the place designated by the government or recycling units with a environ mental friendly method.

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

GTS User Manuals

Related Manuals