HAVAI BLU LB-FS08-DC X 40cm Standing Mist Fan User Manual

HAVAI BLU LB-FS08-DC X 40cm Standing Mist Fan

PLEASE READ AND RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY

GENERAL SAFETY WARNING:

1. Read carefully all instructions before using.
2. When using electrical appliances basic safety precautions should always be followed.
3. Connect to a main power supplier of 220-240V~ 50 Hz only.
4. This appliance is intended for domestic use only.
5. Indoor use only.
6. Only operate the product when it is fully assembled.
7. Do not operate the product if it is dropped, damaged or showing signs of product malfunction. Do not operate the product with a damaged plug or cord.
8. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understands the hazards involved.
9. Children should be supervised to ensure that they do not play with the appliance.
10. Cleaning and maintenance shall not be made by children without supervision
11. Do not operate this fan with a damaged plug or cord, after a malfunction or after being dropped or damaged in any way.
12. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
13. Do not insert anything through the grid when the fan is in use.
14. Always operate on a stable flat horizontal surface.
15. The fan should be away from any heat source and corrosive gas surroundings.
16. Don’t use in conjunction with or directly next to an air freshener or similar product.
17. To protect against electrical shock, do not immerse the fan, plug or cord in water or any other liquid or spray with liquids.
18. Do not leave hair, tissue, tablecloths, clothes or curtains near all openings of the fan, they could be sucked into the fan and be taken within the internal moving parts that could cause injury or damage.
19. Ensure the appliance is switched OFF before connecting to the mains power supply.
20. Always ensure that hands are dry before operating or adjusting any switch on the product or touching the plug and mains supply connections.
21. Do not leave this appliance unattended when it’s in use. Turn off and disconnect the appliance when you leave the room for an extended period.
22. Switch off the appliance and unplug from the mains socket when not in use, before filling, cleaning or other maintain.
23. Be aware that high humidity levels may encourage the growth of biological organisms in the environment.
24. Do not permit the area around the appliance to become damp or wet. If dampness occurs, turn the output of the humidifier down. If the humidifier output volume cannot be turned down, use the appliance intermittently. Do not allow absorbent materials, such as carpeting, curtains, drapes, or tablecloths, to become damp.
25. Unplug the appliance during filling and cleaning.
26. Never leave water in the reservoir when the appliance is not in use.
27. Empty and clean the humidifier before storage, clean the humidifier before next use.
28. Micro-organisms that may be present in the water or in the environment where the appliances is used or stored, can grow in the water reservoir and be blown in the air causing very serious health risks when the water is not renewed. To prevent nucleation, remove residual water from the equipment and water tank every time after three days of use.
29. Empty the tank and refill it every 72 hours, before refilling, clean it with fresh tap water or cleaning agents if required by the manufacturer. Remove and scale, deposits, or film that has formed on the sides of the tank or on interior surfaces. And wipe all surfaces dry.
30. Warning! Never use without the guards in place. After assembly, do not remove the guards during use or cleaning.

GETTING STARTED

Before using the mist fan for the first time:

• Carefully unpack the misting fan and remove all the packing materials.
• See P.1, Image I, Please check whether there are any missing parts, and the mist fan can be assembled only when the parts are complete.
• Use a soft cloth to remove any dust on the surface that may happen during packing and transport.
• Place the mist fan on a flat and stable surface.

ASSEMBLY INSTRUCTIONS

1. See P.1, Image I, Cover the metal rod of the 5 wheels(7) with the 5 black plastic sleeves and insert them in the holes under the base(5).
2. Put the base cover (4) onto the support tube (3), put the support tube (3) onto the base (5) and fix it with the screw (6).
3. Connect the fan body (1) to the support tube (3) and finally fasten them with the screw (2).

FILLING THE WATER TANK

1. See P.2, Image IV, Turn the tank lock(3) to the on-lock position(2)take off the water tank(4) from the fan body, and unscrew the lid(5) of the water tank.
2. Fill the tank with cold and clean water, making sure not to overfill it.
3. Put the water tank back on the back of the fan body, ensuring it is appropriately seated in the recess.
4. Turn the tank lock(3) to the off-lock position(1) to secure the tank.

ATTENTION!

• Ensure the product is unplugged from the mains before filling or refilling the water tank.
• Only use water in the water tank. Do not add any chemicals, oils, or other additives.
• The water must not be warmer than 50°C.

OPERATION ON THE FAN

When connected to the power supply, the fan is under standby mode. It can be controlled with the control buttons or remote.

OPERATION INSTRUCTIONS

See P.2, Image IV.

4. Remote control signal receiving

Indicator Lights:

1. OSC
2. Timer 0.5H/1H/2H/4H
3. Speed(1,2,3) Low
4. -(4,5,6)Medium -(7,8,9)High
5. Mist Max
6. Mist Medium
7. Mist Minimum
8. Mode Normal
9. Mode Natural
10. Mode Sleep

Control Buttons:

A. OSC
B. Mode
C. ON/OF
D. Wind Speed
E. Mist
F. Timer

A: MIST BUTTON

1. Press the “Mist” button to switch the ultrasonic mist on or off. Adjust the mist volume (Max-Medium-Minimum) by pressing the “Mist” button several times.
2. When the mist function is selected, the corresponding mist volume indicator light will be illuminated.
3. If the water tank is empty (or short of water), the 3 mist indicator light will be flash continuously at the same time.
4. The mist function and fan function can be worked independently or together.

B: TIMER BUTTON

Press the “Timer” button when the fan is on. The indicator will show the time remaining until the fan is due to switch off. You can select the length of time the fan will be in operation from spans ranging from 0.5 to 7.5 hours in 0.5-hour increments. Press the TIMER button repeatedly, and the sum of the values of the lights is the remaining time until shut down.

C: WIND SPEED BUTTON

1. Press the Power “ON/OFF” button to switch the fan ON.
2. Set the fan speed from 9 options (1,2,3)Low speed-(4,5,6)Medium speed-(7,8,9)High speed by pressing the “WIND SPEED” button several times. The LED light will show low speed, Medium speed and high speed Correspondingly.

D: MODE BUTTON

1. The wind mode can be adjusted by pressing the “MODE” button.
2. Normal: The fan will operate in High, Medium or Low mode as set.
3. Natural: The fan will operate at low, medium and high speeds in different patterns to provide a wind flow that replicated natural airflow.
4. Sleep: Sleep mode can operate at low, medium and high speeds. In sleep mode, the wind speed will decrease in set patterns before operating at a low speed until shut down.

E: ON/OFF BUTTON

1. Press the “ON/OFF” button to switch the fan on or off.
2. Every 72 hours, the control panel lights flash to indicate that the water tank needs to be cleaned. Press the “ON/OFF” button 5 seconds to reset.

F: OSCILLATING BUTTON

When you press the “OSC ” button, the mist fan head will move continuously from side to side. Pressing the button again will stop the oscillation of the mist fan.

G: REMOTE CONTROL

The above functions can be controlled using the remote control by pressing the corresponding function buttons. See P.3, Image V. To use the remote control, insert two AAA 1.5V batteries in the battery housing in the remote.

CLEANING AND MAINTENANCE

1. Always unplug the fan before cleaning it.

2. Clean the water tank and water every 72 hours to prevent the formation of scale, algae, or bacteria.

3. If you do not intend to use the fan for an extended period, empty the water tank and dry the water unit with a microfiber cloth.

4. See P.1, Image II, put a container(1) at the drain to catch the water that comes out pulling out the rubber stopper(2) from the drain outlet(3) to drain the water from the humidifier base.
   
   

5. If the fan will be placed in storage for a more extended period of time (over winter , etc), keep it safe and away from dust or damage.

6. To avoid damaging the plastic and indicators, do not use any abrasive cleaning agents or chemicals.

7. The fan must not be opened by unauthorized persons.
   CAUTION: Unplug the fan from the electrical supply source before cleaning. After servicing, any safety device (including grilles and blades) it must be reinstalled or remounted as previously installed. Use a soft damp cloth then wipe with a dry cloth. Do not use harmful detergents.

Do not bend the blades.

TECHNICAL SPECIFICATIONS

DESCRIPTION OF THE SYMBOLS

| In accordance with European directives applicable to this product.
---|---
| Cass II symbol: this appliance is designed with double insulation. It is not necessary to connect it to earth connection.
| Clean the water tank every 72 hours
| The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>