OKP Life K2P Robot Vacuum Cleaner Instructions
- June 14, 2024
- OKP Life
Table of Contents
Instructions
K2P Robot Vacuum Cleaner
Congratulations on the purchase of your OKP ROBOTS!
We hope it brings you satisfaction. We trust your purchase will keep your home
clean and provide you a high-quality life.
Should you encounter situations that have not been properly addressed in this
User Manual, please contact our Customer Service Center, we will solve your
specific problem.For more information, please visit the OKP ROBOTICS official
website:
www.okplife.com or send email to the following email
address : support-us@okprobot.com.
The Company reserves the right to make technological and/or design changes to
this product for continuous improvement.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Read all safety warnings and instructions. Failure to follow the
warnings and instructions may result in electric shock, fire or serious
injury.
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.
For Household use only
When using an electrical appliance, basic precautions should always be
followed, including the following:
-
The robot must be used in accordance with the directions in this User Manual. Our company cannot be held liable or responsible for any damages or injuries caused by improper use.
-
Do not allow to be used as a toy. Close attention is necessary when used by or near children.x
Do not allow children to sit on the vacuum. -
Clear the area to be cleaned. Remove power cords and small objects from the floor that could entangle the Robot. Tuck rug fringe under the rug base, and lift items such as curtains and table cloths off the floor.
-
If there is a drop off in the cleaning area due to a step or stairs, you should operate the Robot to ensure that it can detect the step necessary to place a physical barrier at the edge to keep the unit from falling. Make sure the physical barrier is not a trip hazard.
-
Only use as described in this manual. Only use attachments recommended or sold by the manufacturer.
-
Please make sure your power supply voltage matches the power voltage marked on the Docking Station.
-
Do not handle or plug appliance with wet hands.
-
Non-rechargeable batteries are prohibited.
-
Do not use without dust bin and/or filters in place.
-
Do not operate the robot in an area where there are lit candles or fragile objects on the floor to be cleaned.
-
Do not use and store in extremely hot or cold environments (below -5°C /23°F or above 40°C/104°F). Please charge the robot in temperature above 0°C/32°F and below 40°C/104°F. Follow all charging instructions and do not charge the battery pack or appliance outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the battery and increase the risk of fire.
-
Keep hair, loose clothing, fingers, and all parts of body away from any openings and moving parts.
-
Do not operate the robot in a room where an infant or child is sleeping.
-
For INDOOR use ONLY. Do not use the robot in outdoor, commercial or industrial environments. Do not use Appliance on wet surfaces or surfaces with standing water.
-
Do not allow the robot to pick up large objects like stones, large pieces of paper or any item that may clog the robot.
-
Do not use the robot to pick up flammable or combustible materials such as gasoline, printer or copier toner, or use in areas where they may be present.
-
Do not use the robot to pick up anything that is burning or smoking, such as cigarettes, matches, hot ashes, or anything that could cause a fire.
-
Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
-
Take care not to damage the power cord. Do not pull on or carry the robot or the Docking Station by the power cord, use the power cord as a handle, close a door on the power cord, or pull power cord around sharp edges or corners. Do not run the robot over the power cord.Keep power cord away from hot surfaces. Do not unplug by pulling on cord, To unplug, grasp the plug, not the cord.
-
If the power cord is damaged, it must be replaced by the manufacturer or its service agent in order to avoid a hazard.
-
Do not use the Docking Station if it is damaged.
-
Do not use the robot or the Docking Station if it is not working properly, has been dropped, damaged, left outdoors, or come in contact with water. It must be repaired by the manufacturer or its service agent in order to avoid a hazard.
-
Turn OFF the power switch before cleaning or maintaining the robot. Turn off all controls
-
The plug must be removed from the receptacle before cleaning or maintaining the Docking Station.
-
Remove the robot from the Docking Station, and turn OFF the power switch to the Appliance before removing the battery for disposal of the robot.
-
The battery must be removed and discarded according to local laws and regulations before disposal of the robot.
-
Please dispose of used batteries according to local laws and regulations.
-
Do not incinerate the robot even if it is severely damaged. The batteries can explode in a fire.
-
When not using the Docking Station for a long period of time, please unplug it.
-
Prevent unintentional starting. Ensure the switch is in the off position before connecting to battery pack, picking up or carrying the appliance. Carrying the robot with your finger on the switch or energizing the robot that have the switch on invites accidents.
-
When battery pack is not in use, keep it away from other metal objects, like paper clips, coins,keys, nails, screws,ect, that can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or a fire.
-
Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns.
-
Do not use a battery pack that is damaged or modified.
Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury. -
Do not expose a battery pack or appliance to fire or excessive temperature. Exposure to fire or temperature above 130°C/265°F may cause explosion.
-
Have servicing performed by a qualified repair person using only identical replacement parts.
-
Do not modify or attempt to repair the robot or the battery pack (as applicable) except as indicated in the instructions.
-
Do not operate the robot in a room that has lit candles on furniture that the vacuum may accidentally hit or bump into.
-
Recharge only with the charger specified by the manufacturer.
A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. -
Use the robot only with specifically designated battery packs.
Use of any other battery packs may create a risk of injury and fire. -
The robot contains batteries that are only replaceable by skilled persons. To replace the robot’s battery, please contact Customer Service.
-
If the robot is not going to be used for a long time, fully charge the robot, power it OFF, and unplug the Docking Station.
SAVE THESE INSTRUCTIONS
To satisfy RF exposure requirements, a separation distance of 20 cm or more
should be maintained between this device and persons during device operation.
To ensure compliance, operations at closer than this distance is not
recommended. The antenna used for this transmitter must not be co-located in
conjunction with any other antenna or transmitter.
| Short-circuit-proof safety isolating transformer
---|---
| Switch mode power supply
| For indoor use only
| Direct current
| Alternating current
| detachable supply unit
Correct Disposal of this Product
This marking indicates that this product should not be disposed of with other
household waste throughout the EU. To prevent possible harm to the environment
or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To recycle your used
device, please use the return and collection systems or contact the retailer
where the product was purchased. They can safely recycle this product.
Federal Communications Commission (FCC) Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generate, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user 5s authority to operate this equipment.
RF exposure warning
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.This equipment must be installed and operated in
accordance with provided instructions and the antenna(s) used for this
transmitter must be installed antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons
and must not be collocated or operating in conjunction with any other antenna
or transmitter.
IC Caution:
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
RF exposure statement:
The equipment complies with IC Radiation exposure limit set forth for
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>