amazon basics 5l Pressure Sprayer User Manual

5l Pressure Sprayer
User Manual

5l Pressure Sprayer

Important Safety Instructions

Read these instructions carefully and retain them for future use. If this product is passed to a third party, then these instructions must be included.
When using the product, basic safety precautions should always be followed to reduce the risk of injury including the following:
WARNING Risk of injury!
To reduce exposure to spraying agents, wear approved personal protection equipment (PPE), such as respiratory protection, safety goggles, gloves and protective clothing.

• Avoid any direct contact with spraying agents. In case of contact with spraying agents, immediately rinse the affectedbody parts with plenty of clean water. Seek medical advice if needed.
• If inhaling toxic chemicals or substances, immediately leave the toxic environment and take rest in a ventilated area if skin and eyes are irritated, wash immediately with dean water;
• if airways are irritated, get into fresh air straight away and seek medical advice promptly;
• if swallowed, drink plenty of water or warm water with salt to induce vomiting, and seek medical advice promptly.
• Keep children, pets and other bystanders away from the product while operating.
• Do not spray on persons or animals.
• Do not spray into wind, water or drinking water sources.
• Do not operate the product with an empty tank.
• Keep pressurized product out of the direct sunlight.
• Never use the product in a room where there is a danger of explosion or in the vicinity of flammable Liquids or gases.
• Check all parts before using the product. Do not use the product if any parts of the product is damaged, especially the spray lance and nozzle.
• Do not use the product while tired, ill or under influence of alcohol or other drugs or medicaments.
• Always direct the spray lance downwind from the operator during operation.
• Only operate the product when it is in ar upright position.
• Before using spraying agents with this product read the label and all the warnings on the original container thoroughly and follow all the manufacturer directions. Do not change the recommended dilution ratios. Incorrect mixtures
• may produce toxic fumes or explosive solutions.
• Mix and fill only in areas where spills can be easily contained. Avoid contaminating the environment, the mains water supply and/or public sewer systems with spraying agent. Havenough spare rags available to adsorb any spills immediately.
• Any unused leftovers of spraying agents must always be collected in a suitable container and disposed of via approved by local or national regulatory authorities to avoid contaminating the environment. Do not dump unused  spraying agent into the fields, rivers, wells, streams and similar.
• Release the residual pressure in the tank by pulling the pressure relief valve upwards, after each use and especially before unscrewing the tank cap.
• Do not under any circumstances modify the product. All servicing and maintenance, other than listed in this user manual, should be performed by an authorised service centre.

Product Description

A Pump handle
B Tank cap
C Pump
D  Hose
E Carrying strap
F Tank
G Trigger
H Handle
I Pressure relief valve
H Spray lance
K Nozzle
L End cap (for replacement)
M Small O-ring, x2 (for replacement)
N Medium 0-ring (for replacement)
O Large O-ring (for replacement)

Intended Use

• This product is intended for spraying water or mild cleaning agents in the home, garden and greenhouses. This product is not suitable for flammable, caustic, corrosive, acid or oxidizing chemicals including bleaches.
• This product is intended for private use only.

Before First Use

Danger Risk of suffocation !
Keep any packaging materials away from children and pets — these materials are a potential source of danger,
Caution risk of injury!
Always pull the pressure relief valve (l) upwards to release any residual pressure in the tank (F) before unscrewing the tank cap (B).

• Remove all the packing materials.
• Remove and review all components before starting use.
• Check the product for transport damages.

Setup

5.1 Assembly

1. Attach the spray lance (J) to the connector of the handle (H) firmly (Fig. 1)
2.  Slide the securing nut on the connector of the handle and tighten it in a clockwise direction for a secured connection (Fig. 1). Do not remove the O-ring seated at the end of the spray lance (j).

5.2 Filling the tank
NOTICE

• Always read and observe the instructions and warnings on the original container of the spraying agents.
• Do not mix the spraying agent5 directly in the tank (F). Mix the spraying agents in a separate container (not included).
• Dilute the spraying agent with water properly. Solution to be sprayed must be as thin as water. Thicker solution cannot be sprayed out properly.

1. Pull the pressure relief valve (I) upwards to release any residual pressure in the tank (F) (Fig. 2)
2. With the pump handle (Al pushing down entirely, unscrew the tank cap (B) in anti-clockwise direction (Fig. 3).
3. Take the pump (Cl out of the tank (Fl by lifting the pump handle (A) (Fig. 4).
4. Fill the tank (Fl with only the amount of solution needed for the particular spraying session. Do not overfill the tank (F) (Fig. 5).
5. Insert the pump (C) back into the tank (F).
6. Push the pump handle (A) down entirely and turn it clockwise to tighten the tank cap {B).

5.3 Building up the operating pressure

1. Push the pump handle (A) down entirely and turn It clockwise to tighten the tank cap (BJ.
2. Unlock the pump handle {Al by fitting its edge into the slot of the pump (C. Raise the pump handle (A) for pumping (Fig. 6)
3. Move the pump handle (A) up and down for no more than 25 repetitions to build up the operating pressure (Fig. 7).

NOTICE
The pressure in the tank (F) should not exceed 2.5 bar. Pull the pressure relief valve (I) upwards to release excessive pressure in the tank (F).

Operation

6.1 Trial run
When operating the product for the first time, perform a trial run with the tank (F) filled with clean water only. Check at each connection joint for Irregularities or leaks before using the product with spraying agents.
6.2 Spraying
NOTICE
Always keep the product in an upright position. The product works properly only in this orientation.

1. Wear the carrying strap (E) over the shoulder and hold the handle (H) (Fig. 8).

6.2 Spraying
NOTICE
Always keep the product in an upright position. The product works properly only in this orientation.

1. Wear the carrying strap (E) over the shoulder and hold the handle (H) (Fig. 8).

2. Aim the nozzle (K) directly at the plants or objects to be sprayed.5

3.  Squeeze the trigger (G) to start spraying (Fig. 9). NOTICE
   when spraying for an  xtended period of time, squeeze the trigger {G) and push it forward (Fig. 10). To unlock, push the trigger {G) backward.

4. Adjust the spray pattern by slightly turning the tip of the nozzle (K) (Fig. 11). Turn it anti-clockwise for acne spray (1), or turn clockwise for a  concentrated stream (2). NOTICE
   Do not turn the tip of the nozzle {Kl over 180 degree when adjusting the spray pattern. The nozzle {K) becomes loose and can cause water leakage.

5. Release the trigger (G) to stop spraying (Fig. 12). NOTICE
   Push the trigger (G) forward to prevent the trigger {G) from being accidentally squeezed (Fig. 13). To unlock, push the trigger (G) backward.

Cleaning and Maintenance

**CAUTION Risk of injury!
Always pull the pressure relief valve (I) upwards to release any residual pressure in the tank (F) before unscrewing the tank cap (B)
Notice
**

• Empty the tank (F) and clean all parts after each use. Do not leave residue or spraying agents in the tank (F).
• Thoroughly wash your face and hands with soap, as well as the protective clothing.
• Never use corrosive detergents, wire brushes abrasive scourers, metal or sharp utensils to lean the product.

7.1 Cleaning

1. Drain all the water from the tank (F), hose (D) and spray lance ( D )
2. Rinse the parts with water. Use mild detergent for stubborn dirt If needed.
3.  To unclog the nozzle (K), insert a needle (not Included) Into the nozzle opening and move It back and forth
4. Leave the tank (F) open in an open area to eliminate the Odour of the spraying agents. Wipe the parts dry with a soft cloth.

NOTICE
If any of the O-rings or end cap is removed for cleaning, refit them properly after cleaning (Fig. 13).
7.2 Storage

• Drain all the water from the tank (F), hose (D) and spray lance (J).
• Store the product and its accessories in a frost­ free room.
• Do not store the product in a area with ambient temperature below.0° C
• Clip the spray lance (J) onto the holder {Fig. 14).
• Store in a cool and dry place away from children and pets.

7.3 Maintenance

• Check the product regularly to make sure it is free of visible damage
• Apply silicone lubricant on the O-rings once a year to prevent them from cracking. Replace with the new O-rings (M/ N/ O) when necessary (Fig. 15)
• Check the end cap for defects regularly. Replace with the new end cap (L) when necessary (Fig. 15).

Frequently Asked Questions

pressure in the tank using the pump.
Apply silicone lubricant on the O-rings on the pump handle and pump.
Fully tighten the pressure relief valve and hose on the tank.
The product does not spray.| Clean and unclog the nozzle.
Refill the tank with adequate amount of the solution.
Spray solution is too thick. Check the possibility of diluting with water,
following the ratio Indicated on the original container of the spraying agents.

Disposal

Dispose of the product according to local regulations. If In doubt, consult your local authorities.

Specifications

10.1 Importer Information

| For EU
---|---
Postal:| Amazon EU S.~ rl., 38 avenue John F. Kennedy, L-1855 Luxembourg
Business Reg.:| 134248
Postal:| For UK Amazon EU SARL, UK Branch, 1 Principal Place, Worship St, London EC2A 2FA, United Kingdom
Business Reg.:| BR017427

Feedback and Help

We would love to hear your feedback. To ensure we are providing the best customer experience possible, please consider writing a customer review.

amazon.co.uk/review/review-your-purchases#
lf you need help with your Amazon Basics product, please use the website or number below.
amazon.co.uk/gp/help/customer/contact- us
amazon.com/AmazonBasics
MADE IN CHINA
v02-07/23

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>