Govee H6072X82 LED Floor Lamp User Guide
- June 14, 2024
- Govee
Table of Contents
Govee H6072X82 LED Floor Lamp
In the Box
- Metal Slot 1 (Top with a cover)
- Metal Slot 2 (With 4 symmetrical holes)
- Metal Connecting Parts
- Remote Controller
- Remote Controller Holder
- Screwdriver
- Short Screw x12 (2 extra)
- Power Adapter
- Silicone Strip Light
- Lamp Base
Installation Step
-
Assemble the lamp pole: Align the three metal slots in the correct sequence and connect them with the 2 metal connecting parts. Use the screws in the corresponding holes to secure each connecting part to the metal slots.
-
Connecting the lamp pole and lamp base: Insert the connected lamp pole into the lamp base. Use the screws to secure the final connecting part via the two holes on the base.
-
Straighten the silicone strip light. Connect the wires on the silicone strip light to the wires in the port of the lamp base (wires should be connected by color).
-
Ensure the exposed wires are inside the lamp base.
Attach the silicone strip light by following the image above. Finally press the strip light from the middle outwards to the two ends. -
Connect the adapter to the cable of the lamp base and plug the adapter into a socket. Then you can start using the product.
Optional:
Attach the holder to the lamp pole and then the remote controller. Rotate the
holder to detach it from the lamp pole if you need to remove it.
Troubleshooting
The silicone light strip is too long.
• Take out the strip from the pole;
• Follow step 4 to reinstall.
Note: To avoid deforming the silicone light strip, please press from the top and bottom first, and then press the middle.
Caution : Do not cut the strip short otherwise it will be damaged.
After installing all the poles, the gap between them is large or they are skewed.
- Remove the screws and connecting pieces;
- Follow step 1 to step 2 to reinstall.