Electrolux 15 Inch x 27 Inch Universal Laundry Pedestal User Manual
- June 9, 2024
- Electrolux
Table of Contents
- Electrolux 15 Inch x 27 Inch Universal Laundry Pedestal
- Installation Instructions
- Materials and Tools Needed for Installation
- Prepare Appliance For Mounting
- Prepare Pedestal Before Mounting
- Attach Mounting Brackets
- Attach Pedestal to Appliance
- Installing or Re-installing Appliance
- Warranty and Registration
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Electrolux 15 Inch x 27 Inch Universal Laundry Pedestal
Installation Instructions
WARNING
- Failure to disconnect from power source before stacking could result in personal injury or even death.
- Improper installation of dryer venting could result in personal injury or damage to property.
- To avoid back or other injury, have more than one person move or lift the washer or dryer.
- Do not stack a dryer on top of washer already installed on pedestal.
Materials and Tools Needed for Installation
Kit components:
- A 2 Front brackets
- B 2 Rear brackets
- C 14 #10 (16 x .500) screws
IMPORTANT
Total weight IN closed drawer or combination of IN and ON TOP OF open drawer
should not exceed 65 lb. (29.5 kg).
Prepare Appliance For Mounting
- If washer or dryer is new and has not been installed yet, skip to step 4.
- If dryer is already installed, disconnect dryer from electrical and gas connections and exhaust venting. On models with Steam Option, turn off cold water supply and disconnect water supply hose to dryer.
- If washer is already installed, disconnect washer from electrical connection. Turn off hot and cold water supply and disconnect hot and cold water supply hoses from water supply outlets. Disconnect drain hose from drain pipe.
- Protect floor and unit with cardboard or rug and carefully lay the appliance on its LEFT and screw each leg completely into the base.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person move or lift the
appliance.
NOTE
Due to higher center of gravity of appliance on pedestals, some side-to-side
rocking is normal during operation. Vibration can be minimized by assuring
appliance is installed properly, including being level and solid on all four
(4) legs by following these directions.
IMPORTANT
If feet are not completely screwed in, mounting holes in appliance will not
align to mounting holes in brackets.
IMPORTANT
Prepare Pedestal Before Mounting
- Locate pedestal to within a few inches of its final location.
- Level the pedestal front-to-back and side-to-side by adjusting each leveling leg. Keep leg extension to a minimum.
- Rock the pedestal from corner-to-corner to check for stability. Repeat leveling and rocking until all four (4) feet are sturdy on the floor and pedestal is level.
- Without turning the rubber foot, lock each pedestal leg in place by tightening its lock nut tight against the pedestal base.
NOTE
Allow for approximately 5 in. (12.5 cm) behind the pedestal for clearance of
back of washer or dryer to the wall. Allow an additional 3/4 in. (2 cm) for
water inlet on Steam Model Dryers and additional space if venting dryer upward
or downward.
Attach Mounting Brackets
Attach front mounting brackets
- Attach each front bracket to front two holes with 2 screws. Attach the rear brackets to the area shown below, inserting tab A into the long center slot.
Attach rear mounting brackets
Each rear bracket has tabs marked “A” and “B” and 2 arrows indicating bracket direction when mounted on the pedestal.
- Determine your appliance type (washer or dryer).
- Orient rear brackets for your particular model.
- Attach each bracket with 2 screws through the holes that line up on pedestal.
Dryer:
Tab A into center slot with arrow pointing to back.
Washer:
Tab A into center slot with arrow pointing to front.
Attach Pedestal to Appliance
- Turn pedestal on its LEFT side to match orientation to appliance.
- Slide pedestal up to appliance and line up holes in mounting brackets with holes in appliance base.
- Attach rear and front brackets to appliance base with supplied screws into aligning holes – one in each front bracket and two in each rear bracket.
- Using more than one person, carefully return appliance and pedestal to upright position.
- After retuning appliance upright, loosen each mounting screw going into appliance base. Allow the appliance to settle in the brackets and retighten each mounting screw.
NOTE
There may be slight resistance BEFORE screw is completely seated. Make sure
screw is completely tightened before running appliance. A loose connection can
lead to vibration noise.
Installing or Re-installing Appliance
Washer on pedestal:
- Slide washer/pedestal into place.
- Check for levelness and rock all four (4) legs again. Repeat until level and solid.
- Refer to Washer Installation Instructions for complete details on installing water, drain, or electrical.
Dryer on pedestal:
- Slide dryer/pedestal into place.
- Check for levelness and rock all four (4) legs again. Repeat until level and solid.
- Refer to Dryer Installation Instructions for complete details on installing electrical, gas, or exhaust venting.
Warranty and Registration
Warranty
Your pedestal is covered by a two year limited warranty. For two years from
your original date of purchase, Electrolux will repair or replace any parts of
this pedestal that prove to be defective in materials or workmanship when such
appliance is installed, used, and maintained in accordance with the provided
instructions.
Exclusions
This warranty does not cover the following:
- Service calls which do not involve malfunction or defects in materials or workmanship, or for appliances not in ordinary household use or used other than in accordance with the provided instructions.
- Any Labor or in-home service costs.
- Damages to the finish of appliance or home incurred during transportation or installation, including but not limited to floors, cabinets, walls, etc.
- Damages caused by: services performed by unauthorized service companies; use of parts other than genuine Electrolux parts or parts obtained from persons other than authorized service companies; or external causes such as abuse, misuse, inadequate power supply, accidents, fires, or acts of God.
If You Need Service
Keep your receipt, delivery slip, or some other appropriate payment record to
establish the warranty period should service be required. Service under this
warranty must be obtained by contacting Electrolux at the addresses or phone
numbers listed in your Use and Care manual. This warranty only applies in the
USA, Puerto Rico and Canada. In the USA and Puerto Rico, your appliance is
warranted by Electrolux Major Appliances North America, a division of
Electrolux Home Products, Inc. In Canada, your appliance is warranted by
Electrolux Canada Corp. Electrolux authorizes no person to change or add to
any obligations under this warranty. Obligations for service and parts under
this warranty must be performed by Electrolux or an authorized service
company. Product features or specifications as described or illustrated are
subject to change without notice.
Product Record
In the space below, record the date of purchase and model number of the product.
- Model No.:____
- Date of Purchase:_____
Save these instructions and your sales receipt for future reference.
Para obtener asistencia en los Estados Unidos: 1-877-4ELECTROLUX (1-877-435-3287) o visite www.electroluxappliances.com. Para obtener asistencia en Canadá: 1-800-265-8352 o visite www.electroluxappliances.ca.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>