1MORE EF606 Fit SE S30 Open Ear Wireless Bluetooth Headphones User Manual
- June 14, 2024
- 1more
Table of Contents
1MORE EF606 Fit SE S30 Open Ear Wireless Bluetooth Headphones
- To change a song or control volume, please set up on 1MORE MUSIC APP or operate on paired mobile phone or device.
- Above functions are available for either earbud in individual or stereo mode. Custom setup is available on the APP.
- Above functions may vary with different devices.
Extra Functions
-
If only one earbud can be connected to the device, please put the two &arbuds back into the case and triple tap the pairing button, then dick “!MORE Fit SE” in the device pairing list to connect to your device.
-
Clear The Pairing Records
Put both Lek and Right earbuds into the case, press.and hold the pairing button for 8seconds, the pairing records will be cleared. -
OTA Firmware Update:
It can be synchronously upgraded via the. lMORE MUSIC APP while the L?and RlghtE>arbuds areconnected to each other with at least 50% baruiry.
• Functions of the lMORE MUSIC APP m.ayvarywith d·1fferent devices or operating systems. Far more details, pl,eas.econtactour customer service.
Tips
- Please read this instruction manual carefully and retain for future reference.
- Please fully charge the battery before first use.
- If the headphones have been unused for more than 3 months, we recommend that you charge them. This will improve battery capacity.
- Only use chargers that are FCC (Federal Communications Ccmmissiori) approved.
- In dry environments, static electricity may numb your ear. This is not related ta the quality of the product
Safety Information
- Never disassemble the headphones. There are no user-sentlceable parts Inside.
- Do not expose the headphones to temperatures below 32 .,F (0 ?c) or temperatures above 113 °’F (45 °C).
- Do not use headphones in a thunderstorm storm. This could prevent the headphones from working properly, and also increase your chance of being electrically shocked.
- Do not use oil or any volatile liquid to clean this product.
- Do not listen to high volumes for e-xtended periods.
- Do not use headphones In traffic. Do not use the heaidphones any time It would be dangerous to be unaware of noises around you.
- Adult supervision is required for children of age 6 and under
FCC
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This device complies with Part 15 of the FCC Rules, Operation is subject to
the following two conditions: (I} this device may not cause harmful
interference, and (2} this device must accept any interference received,
including
interference that may cause undesired operation.
Caution!
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction Federal
Communication Commission (FCC) Radiation.
NOTE: This eQuipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and. if not installed and used in
accordance with the instructions. may cause harmful interference to radio
communications. l-lowever. there is no guarantee that interference will not
occur in a particular installation If this equipment does cause ham1ful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment intc an outlet on a circuit different from that to which the receiver is ccnnected
- Consult the dealer or an experienced radio/TV technician for help,
FAQ
-
Why the headphones cannot be turned on?
Check if your headphones have enough battery life. If not, please charge them for at least 30 minutes. -
Why the headphones cannot connect to my cellphone, or take a long time to connect?
-
If headphones cannot pair normally when power on. Open the case, triple tap the pairing button to initial searching for Left & Right pairing, and then click “IMORE Fit SE” in the device pairing list. 2
-
To pair the headphones to a new device, simply place them into the charging case and triple tap the pairing button. Then click “IMORE Fit SE” in the new device pairing list to connect.
-
Why the headphones cannot play music after successfully connecting to my Android device?
After pairing successfully, on the Bluetooth menu of your device, tap the icon on the right of your device name and make sure the “Media Audio” option is on. -
Why there is no sound from the headphones while making phone calls after successfully connecting to my Android device?
After pairing successfully, on the Bluetooth menu of your device, tap the icon on the right of your device name and make sure the “Phone Audio” option is on. -
Why the Bluetooth connection is not stable and causes some interruptions?
- Try shortening the distance between your headphones and device. Avoid solid barriers in between.
- Please keep away from strong interference sources such as Wi-Fi and GPRS
- Please make sure the Bluetooth antenna of your device is not blocked.
- Why some control functions do not m.atc;h those in the man1.1al while using third party music/video player APOi?
Your operating system and the third party music/video player apps may have different settings for the control functions. We recommend that you use the music/video player apps that your device has originally provided.
WEEE
All products bearing this symbol are waste electrical and electronic equipment
(WEEE as in directive 2012/19/EU) which should not be mixed with unsorted
household waste. Instead, you should protect human health and the environment
by handing over your waste equipment to a designated collection point for the
recycling of waste electrical and electronic equipment, appointed by the
government or local authorities. Correct disposal and recycling will help
prevent potential negative consequences to the environment and human health.
Please contact the installer or local authorities for more information about
the location as well as terms and conditions of such collection points. Your
IMORE retailer will advise you of the correct way of disposal in your country.
Safety Caution
Do not expose batteries or battery packs to excessive heat such as sunshine,
fire or the like.
Tinlab Corporation hereby declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU and all other applicable EU directive requirements.The full text of the EU declaration of conformity is available at the following internet address:www.1more.com
Hereby, Tinlab Corporation declares that the radio equipment type EF606 is in compliance with Radio Equipment Regulations 2017. The full text of the UKCA declaration ofconformity is available at the following internet address:www.1more.com
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. The Qi logo is a registered trademark of the Wireless Power Consortium.
Warning
Replacement of a battery with an incorrect type that can defeat a safeguard
(such as catching fire, explosion, leakage of corrosive electrolyte etc);
Disposal of a battery into fire or a hot oven, or mechanically crushing or
cutting of a battery, that can result in an explosion; Leaving a battery in an
extremely high temperature surrounding environment that can result in an
explosion or the leakage of flammable liquid or gas; and A battery subjected
to extremely low air pressure that may result in an explosion or the leakage
of flammable liquid or gas. = – = The symbol indicates DC voltage.
IC
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:(1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device. Cet
appareil est conforme ave Industrie Canada RSS exemptes de licence
standard(s). This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada. Radiation Exposure Statement: The product comply with the Canada
portable RF exposure limit set forth for an uncontrolled environment and are
safe for intended operation as described in this manual. The further RF
exposure reduction can be achieved if the product can be kept as far as
possible from the user body or set the device to lower output power if such
function is available.
- Name: Wireless Earphones
- Model: EF606
- Earbud Weight: 10 g
- case Weight: 59.7 g
- Product Weight: 79.7 s
- Earbud Size: 44.92 x 47.11 x 21.97 mm
- Case Size: 704.8 x 54.6 x 30.0 mm
- Earbud Battery Capacity: BS mAh
- Case Battery Capacity: 600 mAh
- Earbud Charging Time: 90 mins
- Case Charging Time: 120 mins•
- Earbud Playtime (Fully Charged): 10 hrs•
- Earbud w/ Case Playtime (Fully Charged): 30 hrs•
- Impedance; 16 n
- Wireless Range: 10 m
- Bluetooth: Bluetooth111 5.3
- Bluetooth Protocol: HFP / A2DP / AVRCP
- Input: 5V=0.5A
- Working Temperature: o DC – 45 ‘C
- Frequency Sand:2.402 GHZ-2.480 GHZ
1MORE (1) Year Limited Warranty
1MORE warrants to the original retail purchaser that this product is to be free from defective materials and workmanship for a period of one year from the date of purchase if it is properly used and maintained. If this product proves defective in either material or workmanship, MORE, at its option, will (a) repair the product with new or refurbished parts, or (b) replace the product with an equivalent new or refurbished product, at no charge for parts or labor. If the product model is no longer available and cannot be repaired effectively or replaced with an identical model, MORE at its sole option may replace the unit with a current model of equal or greater value. In some cases, modification to the mounting surface may be required where a new model is substituted. MORE assumes no responsibility or liability for such modification. TO OBTAIN A REPAIR OR REPLACEMENT UNDER THE TERMS OF THIS WARRANTY, PLEASE RETURN TO THE ORIGINAL DEALER FIRST AND THE ORIGINAL DEALER SHALL REPAIR THE PRODUCT WITH NEW OR REFURBISHED PARTS OR REPLACE THE PRODUCT WITH AN EQUIVALENT NEW OR REFURBISHED PRODUCT. You will be required to submit a proof of purchasing details, including but not limited to a receipt or sales invoice. Return shipping for exchanges/repairs is the sole responsibility of the original retail purchaser. Limitations:
- This limited warranty does not cover the failure of the product resulting from improper installation, misuse, abuse, accident, neglect, mishandling, or wear from ordinary use or environmental deterioration.
- This limited warranty does not cover cosmetic damage, including paint damage, or consequential damage to other components or premises which may result for any reason from the failure of the product.
- This limited warranty is null and void for products not used in accordance with 1MORE’s instructions.
- This limited warranty is null and void for products with altered or missing serial numbers and for products not purchased from an AUTHORIZED dealer.
- This limited warranty terminates if you sell or otherwise transfer this product to another party.
We Appreciate Your Business
We know you will enjoy new MORE headphones as much as we do. At MORE, we value
your satisfaction. If you would like more details on this product or any of
our other products, please visit us online by scanning the QR code. Go to
www.lmore.com and sign up for VIP, and MORE will treat you like one.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>