Guzoea WLL5.12 Wireless Lavalier Lapel Microphone User Manual

Guzoea WLL5.12 Wireless Lavalier Lapel Microphone

Safety information

•  This device does not have a power adapter. When charging is required, please use a power adapter that has obtained the CCC certificate and complies with relevant standards.
• Please use this equipment within the temperature range of O ·c-40 ·c, and store the equipment and accessories within the temperature range of -20 t:­+45 t:. When the ambient temperature is too high or too low, it may cause equipment failure.
• Do not expose the device to high temperatures or around heating devices, such as sunlight, heaters, microwave ovens, ovens or water heaters, etc.
• When charging is complete or not charging, please disconnect the charger from the device and unplug the charger from the power.
• The device is equipped with a non-removable built-in battery, please do not replace the battery yourself to avoid damage to the device.
• Please dispose of this equipment, batteries and related accessories in accordance with local regulations, and do not dispose of them as domestic waste.

Warning: The battery ( battery pack or assembled battery ) must not be exposed to such as sunlight, fire or similar overheating environment;

Notice: If the battery Is improperly replaced,there Is a danger of explosion. Only the sametype or equivalent type of battery can be used toreplace It.

Packing list

1. Wireless microphone transmitter 2pcs
2. Wireless microphone receiver 1pcs
3. User manual (including warranty card) 1pcs
4. USB Charging cable 1pcs
5. Blowout Preventer Sponge 4pcs
6. Storage bag 1pcs

Function Description

1. Windbreak
2. Microphone clip (360° rotatable)
3. Power Switch
4. USB Charging port
5. Microphone indicator
6. Receiver indicator
7. Lightning plug
8. Mobile phone charging port

Indicator light description

Microphone transmitter:

1. Power-on but disconnected state: the red light and green light on the front flash alternately;
2. Power-on and connected state: the green light on the front is always on;
3. Connected but recording paused: the green light on the front flashes and by pressing the button very softly, it will stop flashing and the recording will continue
4. Low battery: red light flashes on the front;
5. Charging status: the front red light is always on; the front red light is off when fully charged;

Receiver:

1. Power-on but disconnected state: green light flashes; 2, Power on and connected state: green light is always on

Instructions

1. First, insert the USB plug of the receiver into the corresponding USS port of the mobile phone, and the green light of the receiver indicator flashes at this time.
2. Press and hold the power switch on the transmitter for 3 seconds, the microphone is turned on,and the green light on the front is on at the same time, it means that the power is turned on and the connection is successful.
3. At the same time, the green light on the receiver is steady on, indicating that the connection is successfully paired, and the phone can use the microphone to receive the sound by turning on the camera, voice recorder, and live video APP.
   Note: In order to ensure the effective use of the connection, there should be no obstacles between the microphone and the receiver.
   When wearing the microphone for recording or live video broad casUng, It Is recommended to face the receiver, otherwise the signal may be Interrupted.

Charging

1. When the red light on the front of the microphone transmitter flickers, it is a low-power prompt for the device.
   At this time, in order to ensure normal use, please charge in time: Use the large end of the USB charging cable delivered with the machine to insert it into the USB interface of the computer or charger, and then insert the small end of the USS charging cable into the USB interface of the microphone.
   When charging, the front red light on the microphone transmitter will be on, and the front red light will go out when it is fully charged.

2. When the device is in use, when the battery of the mobile phone is low and needs to be charged,the mobile phone can be charged through the USB interface of the receiver. Use the USB cable of themobile phone charger to directly plug into the USBport of the receiver to charge the mobile phone!

Technical specifications

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>