amazon basics B0B9RSRKKV Outdoor Solar Yard Pathway Light Instruction Manual

: June 14, 2024
: amazon basics

Table of Contents

Important Safeguards
Battery Warnings
Intended Use
Before First Use
Product Description
Setting up the Product
Installation
Operation
Cleaning and Maintenance
Frequently Asked Questions
Symbols Explanation
Supplier’s Declaration of Conformity
Canada IC Notice
Disposal (for Europe only)
Battery Disposal
Specifications
Read User Manual Online (PDF format)
Download This Manual (PDF format)

amazon basics B0B9RSRKKV Outdoor Solar Yard Pathway Light Instruction Manual

Important Safeguards

Read these instructions carefully and retain them for future use. If this product is passed to a third party, then these instructions must be included.

When using electrical products, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons including the following:

CAUTION Risk of eye damage! LEDs emit bright light. Avoid looking directly into the light source for prolonged periods

Decide on a suitable position for the solar panel so that it receives the maximum amount of sunlight. It is recommended not to install the solar panel near a bush or beneath trees where the solar radiation might be diminished and cause significant
reduction in light output at night.
An outdoor location where the solar panel can receive at least 6-8 hours of direct sunlight each day will be ideal for normal functioning of the product.
The solar light should not be placed near other light sources such as street lights that might cause the light to turn off even at night due to the light sensor.
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
This product contains no user serviceable parts and requires little maintenance. Leave any servicing or repairs to qualified personnel only.
Do not attempt to repair the product yourself. In case of malfunction, repairs are to be conducted by qualified personnel only.
Do not open the product housing. Do not insert any foreign objects into the inside of the housing.

Battery Warnings

WARNING

KEEP OUT OF REACH OF CHILDREN

This product contains a small ingestible battery. Swallowing can lead to chemical burns, perforation of soft tissue, and death. Severe burns can occur within 2 hours of ingestion. Seek medical attention immediately

Always take care to install your replacement batteries correctly observing the “+” and “-” marks on the battery and the product. Batteries that are incorrectly placed into some equipment may be short-circuited, or charged. This can result in a rapid temperature rise causing venting, leakage, rupture and personal injury.
Store unused batteries in their original packaging and away from metal objects. Unpacked batteries could be jumbled or get mixed with metal objects. This can cause battery short- circuiting which may result in venting, leakage and rupture and personal injury; one of the best ways to avoid this happening is to store unused batteries in their original packaging.
Never dispose of batteries in fire. When batteries are disposed of in fire, the heat build-up may cause rupture and personal injury. Do not incinerate batteries except for approved disposal in a controlled incinerator.
Never short circuit batteries as this may lead to high temperatures, leakage, or rupture. When the positive (+) and negative (-) terminals of a battery are in electrical contact with each other, the battery becomes short-circuited. This may result in venting, leakage, rupture and personal injury.
Never heat batteries in order to revive them. When a battery is exposed to heat, venting, leakage and rupture may occur and cause personal injury.
Never attempt to disassemble, crush, puncture or open batteries. Such abuse may result in venting, leakage, and rupture, and cause personal injury.
Immediately seek medical attention if a cell or battery has been swallowed. Also, contact your local poison control center.
Always purchase the correct size and grade of battery most suitable for the intended use.
Clean the battery contacts and also those of the product prior to battery installation.
Switch the product OFF before replacing the battery.
Remove batteries from product that is not to be used for an extended period of time.

Intended Use

This product is intended to be used in outdoor areas only.
This product is intended for residential use only.
This product can be used to provide general purpose lighting in a variety of locations around the back and front yard.

Before First Use

DANGER Risk of suffocation! Keep any packaging materials away from children and pets – these materials are a potential source of danger, e.g. suffocation.

Remove all the packing materials.
Remove and review all components before installation.
Check the product for transport damages.
Remove the protective film off the solar panel before use

Product Description

Setting up the Product

Gently remove the top housing form the lamp cover by rotating it counter-clockwise.
Set the ON/OFF switch to ON.
Fit the top housing back onto the lamp cover.
Insert the lamp cover into the mounting pole. Insert the mounting pole onto the ground stake.

Installation

NOTICE

Do not use hammer or press on the solar panel when installing the product (Fig. 1).
Always hold the mounting pole when installing the product (Fig. 1).
If the ground is too hard, use a hand trowel (not included) to loosen the ground before installing the product.

To loosen up the ground, apply a small amount of water to the area of installation (Fig. 2).
Insert the product fully assembled into the ground keeping each light approximately 2 ft (60 cm) apart (Fig. 3).
Allow the product to charge for 8-10 hours in full sunlight for optimum performance (Fig. 4)

NOTICE

Battery performance and the actual operation of Cloudy or rainy days result in less Overall hours
A fully charged last up to 8 hours. the product are affected by charging time on the solar panel thus, fewer performance of the product can be affected drastically. to run weather and temperature. of operation. battery can
Allow the product capacity of the performance, avoid installing at least 5 to 8 entire charging and discharging cycles to areas and within close proximity reach
Keep the maximum dirt and snow off the solar panel to allow the battery to recharge fully.
To maximize the products to street lamps (Fig. 5).

Operation

Switching on/off

To switch the product on, remove the top housing from the lamp cover and set the ON/OFF switch to ON.
To switch the product off, remove the top housing from the lamp cover and set the ON/OFF switch to OFF.

NOTICE

Once the product has been switched ON, the light will then switch on and off automatically.
The operating time depends on the charging performance in a daytime and could be affected by the weather conditions and installation location.

Replacing the battery

CAUTION Risk of battery explosion or leak!

Do not install primary (non-rechargeable) batteries.

Remove the top housing from the lamp cover and set the ON/OFF switch to OFF.
Remove the 3 screws from the battery compartment and carefully lift the cover off making sure not to detach any cables (Fig. 6).
Remove the old battery the same type (Ni-MH and replace it with a suitable new rechargeable battery of 2/3 AAA 200 mAh 1.2 V) (Fig. 7).

onto the battery compartment and fix the 3 screws back (Fig. 8).
Fit the cover back
Fit the top housing back onto the lamp cover.

Cleaning and Maintenance

NOTICE

Switch the product off before cleaning.
During cleaning do not immerse the electrical parts of the product in water or other liquids. Never hold the product under running water.

Cleaning

To clean the product, wipe with a soft, slightly damp cloth.
Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product.

Store the product in its original packaging in a dry area. Keep away from children and pets.

Frequently Asked Questions

Problem

The product does nonswitch on.

| Solution

The product is installed close to other light sources such as street lights. Re-install the product further away from light sources and keep each light approximately 2 ft (60 cm) apart.

---|---

Replace the rechargeable battery with a new one of the same type (Ni-MH 2/3 AAA 200 mAh 1.2 V) as it may be weak or worn out.

The product does not starlit for long.|

The product is not charging adequately. Re-install the product in another location where the solar panel can receive at least 6-8 hours of direct sunlight each day.
Replace the rechargeable battery with a new one of

the same type (Ni-MH 2/3 AAA 200 mash 1.2 V) as it may be weak or worn out.

Clean the solar panel with a soft, slightly damp cloth.

The product does nonswitch on after it has been used for 8 —12 months.| Replace the rechargeable battery with a new one of the same type (Ni-MH 2/3 AAA 200 mAh 1.2 V) as it may beweep or worn out.

Symbols Explanation

This symbol stands for “Conformity Euro penne”, which declares “Conformity with EU directives, regulations and applicable standards”. With the CE- marking, the manufacturer confirms that this product complies with applicable European directives and regulation.

This symbol stands for “United Kingdom Conformity Assessed”. With the UKCA- marking, the manufacturer confirms that this product complies with applicable regulations and standards within Great Britain

Supplier’s Declaration of Conformity

Unique Identifier: BOB9RSRKKV, BOB9RVGFVY- Outdoor Solar Yard Pathway Lights
Responsible Party: Amazon.com Services LLC.
U.S. Contact Information: 410 Terry Ave N. Seattle, WA 98109 USA
Telephone Number : 206-266-1000

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Canada IC Notice

This Class B digital apparatus complies with Canadian CAN ICES-005(B) / NMB-005(B) standard.

Disposal (for Europe only)

The Waste Electrical and Electronic Equipment (WEEE) laws aim to minimize the impact of electrical and electronic goods on the environment and human health, by increasing re-use and recycling and by reducing the amount of WEEE going to landfill. The symbol on this product or its packaging signifies that this product must be disposed separately from ordinary household wastes at its end of life. Be aware that this is your responsibility to dispose of electronic equipment at recycling centers in order to conserve natural resources. Each country should have its collection centers for electrical and electronic equipment recycling. For information about your recycling drop off area, please contact your related electrical and electronic equipment waste management authority, your local city office, or your household waste disposal service.

Battery Disposal

Do not dispose of used batteries with your household waste. Take them to an appropriate disposal/collection site.

To learn more about recycling batteries, visit: call2recycle.org/what- can-i-recycle

Specifications

Model number : BOB9RSRKKV, BOB9RVGFVY
Battery type : Ni-MH 2/3 AAA 200 mAh 1.2 V
Battery operation: up to 8 hours
Color temperature: 3000 K
Luminous flux: 3

Importer Information

For EU
Postal: Amazon EU S.à r.l., 38 avenue John F. Kennedy, L-1855 Luxembourg
Business Reg.: 134248 For UK
Postal: Amazon EU SARL, UK Branch, 1 Principal Place, Worship St, London EC2A 2FA, United Kingdom
Business Reg.: BR017427

Feedback and Help

We would love to hear your feedback. To ensure we are providing the best customer experience possible, please consider writing a customer review. Scan QR Code below with your phone camera or QR reader:
QR Code