Guangzhou Kinouwell Technology RF433mhz Gateway Module User Manual
- June 15, 2024
- Guangzhou Kinouwell Technology
Table of Contents
Guangzhou Kinouwell Technology RF433mhz Gateway Module
Interface Description
The interface mainly includes Power interface, RS232 interface, RJ45interface,
RF433 antenna interface, etc.
Mounting Accessories
Connect the RF433 antenna and the network cable to the network port
Connect the power cord
At the power interface (Power interface), connect the AC220Vpower cord. Note that the red line is the positive pole of the power supply, and the blueline’s the negative pole of the power supply. Please do not connect it wrongly!
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.