AQUA CONTROL C4110 Programmer Digital Full Vision User Manual

June 15, 2024
AQUA CONTROL

AQUA CONTROL C4110 Programmer Digital Full Vision

AQUA-CONTROL-C4110-Programmer-Digital-Full-Vision-
product

JUMP OVER THE MANUAL AND HAVE A DIRECT LOOK AT SETTINGS

Once in your hands

Check that all components are includedAQUA-CONTROL-C4110-Programmer-Digital-
Full-Vision-fig-2

Setting and programming

Put 2 alkaline batteries on the battery compartmentAQUA-CONTROL-C4110
-Programmer-Digital-Full-Vision-fig-3

FOLLOW THESE STEPS

AQUA-CONTROL-C4110-Programmer-Digital-Full-Vision-
fig-6

Special Functions

AQUA-CONTROL-C4110-Programmer-Digital-Full-Vision-
fig-8

  • SCREEN LOCK

Special FunctionsAQUA-CONTROL-C4110-Programmer-Digital-Full-Vision-
fig-10

  • DELAY OF IRRIGATION

Special FunctionsAQUA-CONTROL-C4110-Programmer-Digital-Full-Vision-
fig-10

  • MANUAL IRRIGATION

Special FunctionsAQUA-CONTROL-C4110-Programmer-Digital-Full-Vision-
fig-12

  • SCREEN LOCK

PRECAUTIONS

  • This Product is exclusively for outdoor use.
  • Do not install it horizontally.
  • Do not put it underwater or expose it high amount of dust.
  • Under 3°C, remove from the hose faucet and store indoors to avoid potential freeze damage.
  • Store in a dry place and keep away from extreme temperatures.
  • Pressure is needed in your water network for the product to function properly.
  • Make sure the filter (included) does not accumulate too much dirt. Clean it if you notice that it is dirty.
  • When replacing batteries, make sure it’s compartment is completely dry.
  • Operating temperature: 3°C – 45°C
  • Replace the batteries when the symbol appears on the screen.

THE SCREEN DOES NOT SHOW ANY INFORMATION WHEN THE BATTERIES ARE SET
Check if:

  • The batteries used are two new AA alkaline batteries.
  • The batteries have been installed with the poles in the correct position THE THREAD OF THE TIMER IS DRIPPING.

Check if:

  • The rubber gasket is in good conditions and placed correctly.
  • The tap thread is the European BSP standard style.

TROUBLESHOOTING

THE TIMER DOES NOT ALLOW TO MODIFY ITS DATA.
Check if:

Security lock is active.

Press “Rain Delay” for 3 second to turn if off.

  • Timer is OFF.
  • Press ESC/OFF for 3 second to turn if on.

THE WATER DOES NOT COME OUT AT THE PRESET TIME

Check if:

  • The current time is exactly what appears in the timer
  • The watering time has been set correctly.
  • Rain delay is activated. Turn it off.
  • The programmer is off. Activate it.
  • The tap is closed. Open it.
  • The battery is dead. Replace it.

Thank You!

  • Altadex S.A. – A80406135
  • info@altadex.com.
  • 28770. Colmenar Viejo. Madrid. Spain

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals