CROWNFUL IMB1000-UL Portable Ice Makers User Manual

: June 15, 2024
: Crownful

Table of Contents

IMPORTANT SAFEGUARDS
GETTING TO KNOW YOUR ICE MAKER
CONTROL PANEL
SPECIFICATIONS
BEFORE FIRST USE
OPERATING INSTRUCTIONS
CARE & MAINTENANCE
WARRANTY INFORMATION
CUSTOMER SERVICE
Read User Manual Online (PDF format)
Download This Manual (PDF format)

CROWNFUL IMB1000-UL Portable Ice Makers User Manual

IMPORTANT SAFEGUARDS

To reduce the risk of fire, explosion, electric shock, or injury when using your ice maker, follow these important safety instructions:

Before using check that the voltage power corresponds to the one shown on the appliance nameplate.
Do not remove any safety, warning, or product information labels from your ice maker
Plug the ice maker into an exclusive grounded power outlet. No other appliance should be plugged into the same outlet. Be sure that the plug is fully inserted into the receptacle
This appliance must be grounded. It is equipped with a power cord having a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded
void the use of an extension cord because it may overheat and cause a risk of fire. However, if it is necessary to use an extension cord:
Use only extension cord with grounding plug.
The marked rating of an extension cord must be equal to or greater than the rating of this appliance
It should be positioned such that it does not drape over the counter or tabletop where it can be pulled on by children intentionally.
Do not operate any appliance with a damage cord or plug or after the appliance malfunc- tion or has been damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair or adjustment
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
Do not let cord hang over edge of table or counter.
Do not place on or near a hot gas or electric burner, or in a heated oven.
Place power cord in such a way it cannot be pulled on by children or cause a tripping hazard.
Place power cord in such a way that it is not in contact with hot surfaces.
The use of attachment not recommended or sold by manufacturer may cause fire, electric shock or injury.
Do not touch the evaporator when using the ice maker or making ice to avoid being suffer from frostbite.
Do not immerse any part of the product in water.
To disconnect, turn any control to “OFF”, then remove plug from wall outlet.
Do not plug or unplug product with wet hands
Unplug the product before cleaning, maintaining and when not in use.
Do not use with water that is microbiologically unsafe or of unknown quality.
Do not clean your ice maker with any flammable fluids. The fumes may create a fire hazard or explosion.
Do not overturn the ice maker. If the ice maker is overturned accidentally, make it stand steadily for 2 hours before power it on again.
If the ice maker is brought in from outside in wintertime, do not use for a few hours,
allowing the unit to warm up to the room temperature before operating,
Never put flammable, explosive and corrosive articles into the ice maker.
Never use the ice maker when there is flammable gas leakage.
Never store or use gas and other flammable articles near the ice maker to avoid any fire.
Unplug the ice maker before moving it to avoid damaging the refrigerating system.
Do not attempt to disassemble, repair, modify, or replace any part of your product
This appliance is not intended for used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Close supervision is necessary when any appliance is used by or near children.
Do not leave the appliance unattended while in use
Do not use outdoors.
Do not use the appliance for other than intended use.
Please abandon the ice maker according to local regulators as it uses flammable blowing gas and refrigerant.
Please follow the local regulations regarding disposal of the appliance as it has flammable refrigerant and blowing gas.

SAVE THESE INSTRUCTIONS HOUSEHOLD USE ONLY

GETTING TO KNOW YOUR ICE MAKER

PRODUCT DIAGRAM

Control panel
Top lid
Viewing window
Back housing
Front housing
Infrared light-receiving diode
Infrared light-emitting diode
Filter
“MAX” water level
Drain plug
Evaporator
Ice shovel
Ice tray
Ice basket
Ice spoon

CONTROL PANEL

Start or stop the appliance.
Standby mode: “ ” indicator is blinking. Working mode: “ ” turns solid.
The indicator lights up when large ice is selected.
The indicator lights up when small ice is selected.
“ “indicator lights up when the ice basket is full.
“ ” indicator lights up when the water reservoir lacks water.
“ ” indicator lights up when the machine is in cleaning mode.
You can select “” “ ” or “ ” ‘under standby mode. Under working mode, only ice size “S” or “L” can be selected

SPECIFICATIONS

Model:	IM BT000—UL
Voltage / Frequency:	120V G0Hz
Rated power:	105W
Refrigerant:	R600a
Refrigerant amount:	23F
Foaming agent:	C5 H3
Net weight:	14.11 lbs
Unit size (DXWXH):	11.1 x 9.J x 11.3 in
Ice basket capacity:	1.Tlbs (0.5kg}
Water reservoir capacity:	T.2L (0.32ga I}
Daily capacity:	26fbs per day

BEFORE FIRST USE

Unpack the appliance, then check and make sure that all the accessories include an ice basket and ice scoop etc are complete. Please contact customer service department it some accessories are missing
Please ensure the ice maker is level and on a stable table or surface to avoid malfunction.
The incline angle of the ice maker cabinet should not exceed 45 during transportation or use. Do not tum the ice maker upside down. Doing so could cause the compressor or refrigerating system to operate incorrectly. Please allow time for the fluids in the compres- sor to settle after the ice maker is moved or transported. Before using the ice maker for the first time, please wait for 2 hours after the unit has been leveled and positioned in the proper place
Do not fill the water reservoir with hot water. This may damage the ice maker. It is best to fill the water reservoir with water of room temperature or lower.
Do not use the appliance at a very cold environment (lower than 5°C)
Clean the appliance by following the operation of “CLEANING AND MAINTENANCE” before operate.
The appliance must be placed on a dry and level surface with sufficient ventilation, far from heat sources such as ovens, heaters and corrosive gases.

NOTE: Leave about a 6-inch (15cm) clearance on all sides of the ice maker for proper ventilation.

OPERATING INSTRUCTIONS

Ensure that the drain plug at the bottom of water reservoir is closed well.
Plug the ice maker into the wall outlet, the “indicator blinks.
NOTE: Let the ice machine rested for 30 minutes before plugging it in if it has been moved.
Open the top lid and remove the ice basket.
Fill the water reservoir with drinking water,
NOTE: Do not fill above the “MAX” water level mark.
Replace the ice basket and close the top lid.
Press the “SELECT” key to select the ice size, then press “ON/OFF” Key into working mode: NOTE: Under working mode, you can reselect the ice size. The mode curently set only changes the next and subsequent ice making cycle.
The ice-making cycle will last approximately 7-15 minutes, depending on the ambient temperature and water temperature.
The ice-making cycle starts with water being pumped into the ice tray situated below the evaporator. Over the next 7-15 minutes ice forms on the evaporator. Once this has completed, the ice tray will tilt backwards and the remaining water in the ice tray is drained back into the water reservoir. The ice cubes are then dropped from the evaporator and pushed forward into the ice basket by the ice shovel. The ice tray will automatically move back into position under the evaporator and start the next cycle.
The “” indicator will light up when the ice basket is full and then the ice maker will stop the ice-making cycle automatically. Gently remove the ice from the ice basket with the ice scoop. About 75 seconds later, the ice maker will restart its ice-making function automatically.
The “” indicator will light up when the water reservoir lacks water and the ice-making cycle will stop automatically. At that time, remove the ice basket and add water to the water reservoir, and then press “ON/OFF” key again to restart the ice-making cycle. The appliance will start working automatically after about 20 minutes if the operator forgets to restart the appliance after refilling
When you have got your desired amount of ice, stop the ice making cycle by pressing the “ON/OFF key and unplug the unit from the wall outlet.
Open the top lid and transfer the ice to a freezer,
Allow the ice maker to reach room temperature
Suggest replacing the water every week. Please empty the water reservoir if the ice maker will not be used for a long time

CARE & MAINTENANCE

To keep your ice tasting fresh and your ice maker looking great, we recommend cleaning your ice maker once a week.

CLEANING STEPS:

Stop the ice-making cycle by pressing the “ON/OFF” key, unplug the ice maker from the wall outlet and allow it to warm up to room temperature.
If residual water is found in the ice tray, gently push the ice tray back so that all water drains into the water reservoir
Move the appliance forward to a place 60mm away from the surface and open the drain plug to drain out excess water (see Fig. 1, Fig. 2 and Fig. 3).
Check and make sure the drain plug must be closed well. Fill the water reservoir with clean water, press “SELECT until the indicator flashes and then press the “ON/OFF” key. The pump will start to pump water and keep running for 5 minutes and it will enter into standby condition. After running for 5 minutes, open the drain plug and empty the water.
Remove the ice basket.
Clean the ice maker interior with a soft cloth soaked with warm water and vinegar, then rinse with clean water and drain all the water.
Replace the drain plug well in position. Wash the ice basket and ice scoop in warm soapy water. Rinse and dry
Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing soap it necessary,

NOTE:

Do not use organic solvent, boiled water, detergent, strong acid and strong alkall etc. for cleaning
Do not clean the evaporator.
Please empty the water reservair and dry it for storage if the ice maker will not be used for a long time.

PROBLEM	POSSIBLE CAUSES	SOLUTION
“ ” indicator turns on.

Low water level or lack of water
The water screen at the bottom of the water reservoir is blocked.
Pump malfunction

|

Stop making ice, refill water and then press the “ON/OFF key to restart the ice-making cycle
Do cleaning
Contact customer service.

“ ” indicator lights up.|

Ice basket is full and the infrared light is blocked by the ice.
Infrared light-emitting dinde & light-receiving diode do not work.

|

Remove the ice from the ice basket.
a.Wipe up the foreign objects on the infrared light-emitting diode & light-receiving diode and restart the ice maker,
b.Contact customer service.

The ice collects together.| Making ice takes too much time.
The water temperature in the reservoir is too low| Stop making ice and restart the ice-making cycle after the ice meltsFill the water reservoir with water ranges between 46°F and 77°F.
The ico-making cycle seems normal but no ice is produced.| The ambient temperature or water temperature is too high.| Start the Ice-making cycle in an environment with an ambient temperature less than 89°F and fill the water reservoir with some cold water.
Refrigerating system leaks.| Call customer service.
Refrigerating system blocks.| Call customer service.
Poor ice-making result|

Poor heat dissipation.
The water temperature is too high
The ambient temperature is too high

|

Leave a 6-inch clearance on all sides of the ice maker for proper ventilation.
Fill the water reservoir with water ranges between 46″F and 77″F.
Operate the ice maker at a environment with an ambient temperature between 50°F and 89°F.

Water pumps do not work or produce noise|

Water pump is damaged
The apparatus has not been cleaned for a long time, resulting in the formation of mucus-like substances at the water inlet of the pump and poor water pumping. There is air in the water pipe, and resonance noise will be generated when pumping water

|

Contact customer service.
The appliance should be cleaned once a week or every two weeks with neutral cleaning agents (optional)

Can not select cleaning mode.| The ice maker is under working mode. The ” indicator lights solid| During making ice, you can press “ON/OFF” key to stop making ice. The ice maker enters the standby mode and the “” indicator blinks. Under standby mode, you can press”SELECT” key to choose cleaning mode.

WARRANTY INFORMATION

We grant 1 year warranty on the product commencing on the date of purchase. Within the guarantee period, we will eliminate any defects in the appliance resulting from faults in materials or workmanship.
Please contact us at: support@crownful.com to launch a warranty claim.

This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that have a negligible effect on the value or operation of the appliance.
The guarantee becomes void if repairs are undertaken by unauthorized persons and if original product parts are not used.

CUSTOMER SERVICE

If you have any product questions or concerns, please don’t hesitate to contact us directly at support@crownful.com or visit our website at: www.crownful.com.
We have a hassle-free warranty and customer service team for satisfactory solutions to any issue you might have.

Thanks for trusting CROWNFUL for your household and kitchen needs!
(May you have a FANTASTIC ice experience with your new CROWNFUL ice maker

Icon Keep your favorite beverages cold and your foods fresh.

SUBSCRIBE to our newsletter to get yourself updated with latest great deals, gifts and valuable information about CROWNFUL products. Https://www.facebook.com/crownful.official