SEIDO MY22 Rigid Fork MGV Carbon Instructions
- June 4, 2024
- SEIDO
Table of Contents
SEIDO MY22 Rigid Fork MGV Carbon
FORK DATA SHEET
MATERIAL
- Full UD
- Carbon fiber
STEERER
- Tapered,
- 1-1/8”–1-1/2”, 300 mm length
S.H.I.S. DIMENSIONS
- 28.6 | 40 mm
- (Steerer
- tube top Ø | Crown Race Ø)
OFFSET
- 53 mm
- AXLE TO
- CROWN
- 410 mm
OLD
- 100 mm
- BRAKE
MOUNT TYPE
- Flat Mount 160,
- applicable rotor
- 160–180 mm
CABLE ROUTING
- Brake internally
(also for fully internal routing), Dynamo Cable internally
TIRE CLEARANCE
- 58—622 (29“× 2.25“) / 64—584 (27.5“— 2.5“)
THROUGH AXLE TYPE
- TA,12 × 100 mm
THROUGH AXLE LENGTH TOTAL
- 120 mm
THROUGH AXLE THREAD
- M12 × 1.5 MIN.
THREAD LENGTH
- 14 mm
MAX. LOADS AND TORQUE
EXPANDER
- 8 Nm
STEM
- 5—6 Nm
THROUGH AXLE
- 10 Nm
BRAKE MOUNT BOLTS
- 8 Nm
RACK AND CAGE MOUNTS1
- 5 Nm
THREAD INSERT THROUGH AXLE
- 2 Nm
MAX. LOAD TRIPLE CAGE2
- 4.5 Kg
MAX. LOAD PER CAGE MOUNT
- 1.5 Kg
MAX. LOAD LOWRIDER RACK MOUNTS3
- 5 Kg
introduction
- Always use a medium strength thread lock compound for rack / cage bolts as these tend to vibrate and can work the bolts loose.
- Applicable for cages that are mounted with three bolts.
- Lowrider mounts at the dropout and middle eyelet of the triple cage mount. Max load of 20 Kg applies when using a lowrider rack that is connected to both sides of the fork and mounted to all 4 eyelets. When using single-sided individual lowrider racks each side can support max. 10 Kg.
Seido Components require installation by a professional bike mechanic or other
appropriately trained person. Instructions for installation, usage, and
maintenance can be found at: seido-components.com
Fully read and follow the manual before installation or use.
Not following the appropriate installation methods, directions for use, or
correct follow-up maintenance that leads to subsequent damages cannot be
covered under our warranty.