Trust ACDB-9000C Portable Wireless Doorbell User Manual
- June 13, 2024
- Trust
Table of Contents
START-LINE
RECEIVER ACDB-9000C
Item 71271 Version 1.0
Always read the instructions before using this product
PORTABLE DOORBELL
ACDB-9000C PORTABLE DOORBELL
Components
- LED indicator doorbell
- Pair button
- Volume button
- Melody button
Wireless control
The wireless doorbell can be operated wirelessly with a minimum of 1 and a
maximum of 32 Trust Smart Home transmitters of your choice. For example, you
can play a desired melody using a push button. In addition, you can also have
a melody play when movement is detected and/or when a window or door is
opened. For each Trust Smart Home transmitter you can set a separate melody to
hear exactly whether someone presses the push button or whether a door or
window is opened.
Insert batteries
A Open the battery compartment of the doorbell by turning the bottom towards
the open lock icon.
B Insert two 1.5V AA alkaline batteries (not included). Pay attention to the
correct polarity of the batteries (place the plus and minus on the right
side).
C Place the bottom back on the doorbell.
When placing the bottom back on the doorbell, make sure that the line on the
bottom is lined up with the open lock icon. Then turn the bottom to the closed
lock icon.
Select desired volume
Press the volume button to select the desired volume level. There are 4
levels:
High, Medium, Low and Disabled (LED Only indication
This volume level applies to all registered channels. You can change this
volume level if desired.
Select desired melody
Then press the melody button to select 1 of the 6 melodies. You can set a separate melody per transmitter (push button, motion detector, door/window sensor) by selecting it beforehand.
Pair transmitter(s) to the doorbell
A Do not press the pair button for more than 1 second to activate the learning
mode. The learning mode will be active for 10 seconds and the LED indicator on
the doorbell will flash slowly.
B While the LED indicator is flashing, send an ON signal with a Trust Smart
Home transmitter to link it to the doorbell. For example, while the LED
indicator is flashing, you can press the push button (ACDB-8000A) to pair it
C As soon as the transmitter has been paired, the wireless doorbell will give
2 short beeps. The transmitter, melody and volume are now linked to the
transmitter. The wireless doorbell is now ready for use.
The doorbell can store 32 different transmitters in its memory. If you want to
link multiple transmitters, you need to repeat steps 2 to 4 C .
Unpair a Trust Smart Home transmitter
A Press the pair button for 1 second. The learning mode will be active for 10
seconds and the LED indicator on the receiver will flash slowly.
B While the learning mode is active, send an ON signal with the associated
channel of the Trust Smart Home transmitter you want to remove.
C To confirm, the wireless doorbell will give 2 short beeps Repeat this
procedure to delete multiple transmitters.
Clear Memory
A Press and hold the pair button (approx. 8 seconds) until the LED indicator
flashes quickly. The reset mode will be active for 10 seconds and the LED
indicator on the receiver will flash quickly.
B While in reset mode, press the learn button again for 1 second to confirm
that you want to completely erase the memory.
C To confirm, the wireless doorbell will give 2 short beeps
Safety Instructions
Product support: www.trust.com/71271. Warranty
conditions: www.trust.com/warranty
To ensure safe handling of the device, follow the safety advice on:
www.trust.com/safety
The Wireless range is strongly dependent on local conditions such as the
presence of HR glass and reinforced concrete Never use Trust Smart Home
products for life-support systems. This product is not water-resistant. Do not
attempt to repair this product. Wire colors may vary per country. Contact an
electrician when in doubt about wiring. Never connect lights or equipment that
exceed the maximum load of the receiver. Exercise caution when installing a
receiver voltage may be present, even when a receiver is switched off. Radio
transmission frequency range: 433,92 MHz
Disposal of packaging materials – Dispose of packaging materials which are no
longer needed in accordance with applicable local regulations. The packaging
materials have been selected for their environmental friendliness and ease of
disposal and are therefore recyclable.
Disposal of the device – The adjacent symbol of a crossed-out wheelie bin
means that this device is subject to Directive 2012/19/EU. his directive
states that this device may not be disposed of in normal household waste at
the end of its usable life, but must be handed over to specially set-up
collection locations, recycling depots or disposal companies. This disposal is
free of charge for the user.
Disposal of batteries – Used batteries may not be disposed of in household
waste. Only dispose of batteries when they are fully discharged. Dispose of
batteries according to local regulations. Cover the poles of partially
discharged batteries with tape to prevent short circuits.
Trust Electronics Ltd. declares that item number 71271/71271-02 is in
compliance with Directive Electromagnetic Compatibility Regulations 2016,
Radio Equipment Regulations 2017. The full text of the declaration of
conformity is available at the following internet address:
www.trust.com/compliance
Trust International B.V. declares that item number 71271/71271-02 is in
compliance with Directive 2014/53/EU – 2011/65/EU.
The full text of the EU declaration of conformity is available at the
following web address:
www.trust.com/compliance
Declaration of Conformity
Trust International B.V. declares that this Trust Smart Home-product:
Model: | ACDB-9000C PORTABLE Doorbell |
---|---|
Item number: | 71271/71271-02 |
Intended use: | Indoor |
is in compliance with the essential requirements and other relevant provisions
of the following directives:
ROHS 2 Directive (2011/65/EU)
RED Directive (2014/53/EU)
The full text of the EU declaration of conformity is available at the
following web address:
www.trust.com/compliance
TRUST SMART HOME
LAAN VAN BARCELONA 600
3317DD DORDRECHT
NEDERLAND
www.trust.com
Trust Electronics Ltd.,
Sopwith Dr, Weybridge, KT13 0NT, UK.
All brand names are registered trademarks of their respective owners.
Specifications are subject to change without prior notice. Made in China.
TECHNICAL SPECIFICATIONS
Codesystem | Automatic |
---|---|
Memory Adresses | 32 |
Melodies | 6 |
Volume levels | 4 |
Power | 2x 1,5V AA Alkaline batteries |
Size | HxBxL: 108 x 65 x 68 mm |
References
- Trust.com - Contact & Support - Compliance
- Trust.com - Home
- Trust.com - Home
- Trust.com - ACDB-9000C Portable wireless doorbell
- Trust.com - Contact & Support - Compliance
- Trust.com - Contact & Support - Safety information
- Trust.com - Contact & Support - Warranty conditions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>