HILTI S-BT-MR Screw In Stud Steel Threaded Studs and Standoffs Installation Guide
- June 13, 2024
- HILTI
Table of Contents
HILTI S-BT-MR Screw In Stud Steel Threaded Studs and Standoffs
Product Information
- Product Name: S-BT-MR M8/M10/W10 SN 6 HL
- Equivalent to A4 standard
- Material: 316 Stainless Steel
- Corrosion Resistance Level: 4
- Operating Range: 0-1km
- Manufacturer: Hilti Corporation
- Manufacturer Address: Feldkircherstrasse 100, FL-9494 Schaan, Liechtenstein
- Product Certification: ETA-23/0001, EAD 333037-00-0602, 0672-CPR
- Product Website: www.hilti.group
Product Usage Instructions
To use the S-BT-MR M8/M10/W10 SN 6 HL threaded studs for connection of materials to structural steel and aluminum members, follow these steps:
- Select the appropriate hex nut with flange based on the required size:
- M8-A4 for M8 studs
- M10-A4 for M10 studs
- W10-A4 for W10 studs
- Insert the threaded stud into the pre-drilled hole in the structural steel or aluminum member.
- Tighten the hex nut with flange using a torque wrench to the recommended torque of 16 Nm (11.8 ft-lb).
- Repeat the above steps for each threaded stud required for the connection.
WARNING
DIMENSION
PARTS
USAGE INSTRUCTION
Hilti Corporation, Feldkircherstrasse 100, FL-9494 Schaan, Liechtenstein
Hilti-SF-DoP-044
ETA-23/0001
EAD 333037-00-0602 0672-CPR
Threaded studs for connection of materials to structural steel and aluminium
members
www.hilti.group
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>