ARDESTRP IH Series Infrared Heater Instruction Manual

IH Series Infrared Heater
Instruction Manual

IH-2000-Q1S/IH-2500-Q1S/IH-3000-Q1S

WARNING

The infrared heater is designed for safe operation. Nevertheless, installation, maintenance, and operation of the heater can be dangerous for a careless operator. For your safety and the safety of others, please read the instructions in this USER MANUAL and follow these safety practices in order to prevent damage or injury.

1. Check that the mains voltage corresponds to the rating of the appliance before operating.
2. Do not touch hot surfaces.
3. Place on a flat stable surface for use if with a tripod stand.
4. Indoor used, and outdoor with covering. For dry location only.
5. Do not use near or in the immediate vicinity of a bath or swimming pool or any source of liquid
6. Unplug from socket outlet when not in use.
7. To protect against electric shock, do not immerse the cord or plug in water or any other liquid.
8. The use of accessory attachments not recommended by the appliance manufacturer may cause injury.
9. Allow adequate safe spacing around the heater for cooling and ventilation to avoid any hazards.
10. Never place flammable objects or clothing on top or near the heater.
11. Do not operate this appliance in the vicinity or near any flammable liquids or flammable material to avoid a fire hazard such as curtains, furniture, shelves, etc.
12. Do not allow the cord to overhang the countertop where it can be easily pulled by children.
13. Do not use this appliance for anything else other than its intended use.
14. Do not put fingers or foreign objects into the grill while in operation.
15. Do not leave the appliance unattended when in use.
16. To remove the plug from the outlet, do not pull on the supply cord. Grasp the plug firmly and pull it to remove it.
17. No liability can be accepted for any damage caused by noncompliance with these instructions or any other improper use or mishandling.
18. This appliance is for household use only.
19. This appliance is not intended for use by persons (including children) with reduces physical, sensory, or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should be supervised to ensure they do not play with the appliance.
20. If the supply cord is damaged in any way, it must be replaced by the manufacturer or its service agent, or a similarly qualified person in order to avoid a hazard.
21. To prevent overheating of this appliance, keep the air inlets and outlets clean and free of anything that may cause blockage. Check all inlets and outlets from time to time to ensure it is clear of any dirt or dust accumulation. DO NOT COVER
22. This appliance is not intended to be operated by means of an external timer or a separate remote control system.
23. Continuous exposure to high-intensity infrared radiation at close proximity could be harmful to the eyes or skin. Although an infrared heating tube does not emit ultraviolet electromagnetic radiation, harmful burns could still result if an operator is in close contact with the heating tube being operated at high intensity. Because of the brilliant light emitted by the infrared heating tube at full intensity, is recommended that the eyes be shielded from the glare if observing the heating tube or radiant chamber for an extended period of time. Use suitable shaded lenses or dark glasses.
24. Do not use this heater in small rooms which are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
25. Parts of the heater may exceed 200°C. Contact with the heating tube, reflector, or mental parts near the heating tube, may cause severe BURNS.
26. NEVER place hands under the heating elements. ALWAYS allow the heating element to cool for at least 10 minutes before touching the heating tube or adjacent parts.
27. Observe that all applicable local and national electrical codes are met and a safe electrical ground system is installed before attempting to operate the heater. Refer to the proper installation procedures
28. This product contains recyclable materials. Do not dispose of this product as unsorted municipal waste. Please contact your local municipality for the nearest collection point.
29. Obey the same fire safety rules you observe when you work with hot plates, high-intensity infrared heaters, propane or acetylene torches, soldering irons, and other equipment that gets very hot.
30. Know where the nearest fire extinguisher is located and how to use it.
31. Know how to put out the fire from all types of material near the infrared heater.
32. Statement: heater is not located immediately below a socket outlet.
33. Children of less than 3 years should be kept away unless continuously supervised.
34. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
35. CAUTION! Some parts of this product can become very hot and cause burns! Particular attention has to be given where children and vulnerable people are present!

EQUIPMENT:

Infrared heater – 1 pc.
Operating instructions – 1 pc.
Warranty card (added to the instructions) – 1 pc.
A set of brackets for wall mounting (check the quantity and type with the vendor).

INTRODUCTION

The infrared heater contains an infrared heating tube and formed reflector a heating system that provides even heat distribution.
The infrared heater saves 30%-40% of electricity in comparison to traditional heaters.
Product Temperatures: 120°C.

ASSEMBLY INSTRUCTIONS

Wall mounted

1. Make holes on the wall where the heater is to be mounted with a pencil. Use a level to make sure the heater will be mounted straight.
2. Drill holes with a smaller diameter drill bit than the plastic anchor.
3. Insert the pointed end of the plastic anchor into the wall. Tap the anchor with a hammer until the anchor is flush with the wall.
4. Using a screwdriver attach the mounting bracket to the wall using the screws provided

The bracket can move up and down to 30°

Make sure the heater is level horizontally
The heater must be installed at least 1.8 m above the floor

THERMOSTAT CONTROLS

FUNCTION/OPERATION

Reflective heating technology replicates the sun’s healthy rays, directly warming the object or person in front of the heater. As the temperature of the heated surface rises, the warming effect is felt throughout the air and surrounding areas.
Reflective heaters are great for open and large rooms and actually save you energy by warming objects and not the entire room.
Reflective heating is both safe and healthy, it produces no odors, chemicals, or fumes and does not stir up dust. Remarkably efficient, our heater uses less power to create the same amount of heat as traditional heaters.

1. Plug the power cord into a wall outlet, and make sure the power supply is the same as the rated.
2. Turn the selector-control knob on the right side of the heater to desired heating setting (OFF/LOW/MEDIUM/HIGH/CONSTANT ON.)

THERMOSTAT INSTRUCTIONS

• Before setting the thermostat, allow the heater to operate and warm up the room to desired temperatures. Set thermostat to constant on to start.
• When the desired temperature/comfort level is reached, lower the thermostat setting until the heater stops operating.
• turning the knob clockwise will increase the temperature setting, and Counterclockwise will lower the temperature setting.

The control will now aromatically maintain the pre-set temperature level by turning the heater ON and OFF.

CAUTION:
When the appliance is not operated for a long period of time, cleaning or maintenance is conducted or when the location of the heater is changed, the heater should be turned to OFF and unplugged from the electrical connection.
Periodic inspection and removal of dirt and contaminants will ensure that equipment can be operated safely.

CLEANING INSTRUCTIONS

Regular and careful cleaning helps your infrared heater operate efficiently for many trouble-free years. To clean your heater follow the steps below:

1. Unplug the power cord for your safety before cleaning your appliance.
2. Make sure the heater is cool before continuing
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. (CAUTION: DO NOT let liquids enter the heater)
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater.
5. DO NOT immerse the heater in water
6. Wait until the heater is completely dry before use.

Storage: Store the heater in a cool, dry location when not in use to prevent dust and dirt build up. Use packaging carton to store.

WARRANTY CARD

Dear Buyer! Congratulations on your purchase of the ARDESTO brand appliance, which was designed and manufactured in accordance with the highest quality standards, and we thank you for choosing this particular instrument.
We ask you to keep the coupon during the warranty period. When purchasing a product, require a full warranty card.

1. Warranty service is carried out only if there is a correctly and clearly filled original warranty card, which indicates: the product model, date of sale, serial number, warranty service period, and the seller’s seal. *

2. The service life of household appliances is 5 years.

3. The product is intended for consumer use. When using the product in commercial activities, the seller/manufacturer does not bear warranty obligations, after-sales service is performed on a paid basis.

4. Warranty repair is carried out within the period specified in the warranty card for the product in an authorized service center on the conditions and terms determined by
   applicable law.

5. The product is withdrawn from the warranty in case of violation by the consumer of the operating rules set forth in the instruction manual.

6. The product is removed from warranty service in the following cases:
   • misuse and non-consumer use;
   • mechanical damage;
   • damage caused by the ingress of foreign objects, substances, liquids, or insects;
   • damage caused by natural disasters (rain, wind, lightning, etc.), fire, domestic factors (excessive humidity, dust, aggressive environment, etc.)
   • damage caused by non-compliance of power and cable network parameters with state standards and other similar factors;
   • when operating equipment in the power supply network with a missing single ground loop;
   • in case of violation of seals installed on the product;
   • lack of serial number of the device, or inability to identify it.

7. The warranty does not cover consumables and accessories, as well as filters, shelves, drawers, stands, and other containers for storing products.

8. The warranty period is 12 months from the date of sale.

• Tear-off maintenance tickets are provided by an authorized service center.

The completeness of the product is checked. I have read the terms of the warranty service, no complaints.
Customer Signature _____
Warranty card
Product information: —————————-
Product: ——————————————–
Model: ———————————————-
Serial number: ————————————-
Seller Information: ———————————
Trade organization name: ————————
The address: —————————————-
Date of sale: —————————————
Seller stamp: —————————————
Coupon 3 Seller stamp
Date of the application: ——————————–
Cause of damage: —————————————
Date of completion: ————————————
Coupon 2 Seller stamp
Date of the application: ——————————–
Cause of damage: —————————————
Date of completion: ————————————
Coupon 1 Seller stamp
Date of the application: ——————————–
Cause of damage: —————————————
Date of completion: ————————————

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>