Trim Illusion Door Handle Cover Instruction Manual
- June 13, 2024
- Trim Illusion
Table of Contents
Trim Illusion Door Handle Cover Instruction Manual
-
Carefully test fit product on application site before removing the double-sided tape or the protective film
Some of our door handles are installed using our patented “Snap-On” technology. When test fitting, they may appear to not fit, hold the covers next to the door handles to confirm they are the same. Be sure not to push handle covers fully into place before removing double-sided tape film. -
Inspect application site to make sure it is free of dirt, oil, grease, or wax. Clean the application site with water-based solutions like Isopropyl Alcohol or Windex to avoid damaging the finish then dry the surface well.
-
Apply included or preferred adhesive promoter to application site. Promoter is only needed on areas that will contact the tape.
-
Remove protective film from double sided tape. In case of residue on the finish, please use a microfiber cloth and alcohol to clean the surface. 5. Carefully align product on application site, pressing firmly over entire site to ensure proper adhesion.
Snap-On door handle covers will need to be pushed onto the handle until they snap into place.
Please read instructions carefully before installing.
For best results, do not attempt installation in cold temperatures. Install in
50°F or above for glue to properly adhere part to surface.
PATENT(S): This Product is covered by one or more patents. Visit
trimillusion.com/patents or scan QR code
for active unexpired patent info.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>