NIVEL Parts 01-098 Fishing Pole Holder Installation Guide
- June 13, 2024
- NIVEL Parts
Table of Contents
NIVEL Parts 01-098 Fishing Pole Holder
Product Information
- Product Name: Fishing Pole Holder
- Model Number: 01-098
- Compatibility: Requires rear grab bar (grab bar not included)
Included in the package:
- Fishing Pole Holder
- Mounting Bracket
- Hardware Pack
Tools Needed:
- Cordless Drill
-
3 Phillips Tip
- 13mm Wrench
- 13mm Socket
- 11/32 Drill Bit
- Marking Pen
- Level
Note: Professional installation is recommended. If you choose to install the product yourself, exercise caution, care, and patience as it involves drilling holes into your cart’s body.
Product Usage Instructions
- To begin, attach the mounting bracket to the fishing rod holder’s upper mounting holes using the provided 10mm x 60mm countersunk bolts.
- Place the rod holder with the bracket on the outside of the grab bar at the desired height. Take into account that if the holder is mounted too high, low-hanging objects could damage the rods. If mounted too low, the rods could scrape the ground.
- While the rod holder is in position, mark two holes in the bracket as shown. Use a small level to ensure the rod holder is correctly positioned.
- Using an 11/32 drill bit, drill through the marked locations all the way through the grab bar tubing. Attach the rod holder to the grab bar using the provided 8mm x 40mm bolts.
Once the installation is complete, your fishing pole holder is ready to use.
Hardware Pack Contents:
- 2 – 8mm x 70mm Countersunk #3 Phillips
- 6 – 8mm Flat Washers
- 4 – 8mm Lock Nuts
- 2 – 8mm x 40mm Hex Head Bolts
- included: Fishing Pole Holder Mounting Bracket HW Pack
Tools needed
- Cordless Drill #3 Phillips Tip
- 13mm Wrench 13mm Socket
- 11/32 Drill Bit Marking Pen Level
- Professional installation is recommended. If you choose to not have this product installed by a professional, we highly recommend that you exercise caution, care, and patience when installing this product as it involves drilling holes into your cart’s body.
installation instructions
- To begin, attach the mounting bracket to the fishing rod holder’s upper mounting holes using the 10mm x 60mm countersunk bolts.
- Place rod holder w/bracket on the outside of grab bar at desired height.
- NOTE: Take into account that if the holder is mounted too high, low-hanging objects could damage the rods. Mounted too low and the rods could scrap the ground.
- While the rod holder is in position, mark two holes in the bracket as shown. Use a small level to ensure the rod holder is correctly positioned.
- Using an 11/32” bit, drill marked locations all the way through grab bar tubing. Attach rod holder to grab bar using 8mm x 40mm bolts.
Hardware Pack
- 2 – 8mm x 70mm Countersunk #3 Phillips
- 6 – 8mm Flat Washers
- 4 – 8mm Lock Nuts
- 2 – 8mm x 40mm Hex Head Bolts
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>