GATORBACK 2022-C Navigator Mud Flap Set Anodized Rear Instruction Manual
- June 13, 2024
- GATORBACK
Table of Contents
2022-C Navigator Mud Flap Set Anodized Rear
Instruction Manual
2022-C Navigator Mud Flap Set Anodized Rear
IMPORTANT:
Manufacturer is not responsible for negligent use of vehicle with mud flaps
installed, including over-tightening of screws and bolts causing damage to
vehicle or mud flaps.
TOOLS REQUIRED- FLAPS
PARTS BAG # 770593
a) (10) Caps crew, 1/4”-20 x 1”, SS Balk Ox. Part #014073 b) (12) Washer,
Flat 0.281” x 1”, 18ga, SS Blk Ox. Part #018069
c) (2) Washer, Lock 1/4” SS, Part #024000 d) (2) Nut, Hex 1/4-20, SS Part
025000 e) (8) Spring Nut 1/4-20 x 0.54” Reach Part #028010 f) (10) Washer,
Nylon 0.281”x0.885”x0.062” Part #054080 g) (2) Durashield 5/8” X13” Protection Tape Part #766424
INSTALLATION
(For ease of installation it is suggested that the wheel be removed)
- Before you install your Mud Flap Set, see the diagram and parts list for all necessary parts.
- Remove the four factory push pins located on the inner fender.
- Pull back the liner and install spring nuts (e) to the tabs that hold the liner in place.
- Hold the mud flap in place and use a marker to mark about 1/4” above the mud flap.
- Install dragstrip (g) from the mark down the edge of the vehicle. This protects the paint and body from the mud flap.
- Loosely install mud flap holes #1 to #4 to spring nuts (e) using a capscrew (a), flat washer (b), and nylon washer (f).
- Push the mud flap hole #5 against the factory liner and drill a 1/4” hole through the mud flap hole into the factory liner.
- Loosely install mud flap hole #5 to liner using a capscrew (a), flat washer (b), and nylon washer (f) and secure using a flat washer (b), lock washer (c) and hex nut (d).
- Using a square or another levelling tool, ensure that the mud flap is level. Tighten all fasteners.
- Repeat procedure on passenger side.
Please check out our YouTube channel to see an install video for this application.