Founders 8248401 Generation Lighting Post Instruction Manual
- June 13, 2024
- Founders
Table of Contents
Founders 8248401 Generation Lighting Post
SAVE THESE INSTRUCTIONS!
GENERAL PRODUCT INFORMATION
- These fixtures are intended to be installed utilizing compliant junction NEC boxes.
- This product is safety listed for wet locations.
- Incandescent version may be dimmed with a standard incandescent dimmer.
- LED LED version may be dimmed with a dimmer. Consult lamp manufacturer for additional information.
- This instruction shows a typical installation.
CAUTION RISK OF FIRE
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Install the Fixture
- Install the glass one panel at a time by rotating the glass and insert it into the side opening of the frame, rotate it back upright and insert it into the bottom stationary tab, position the panel in place, then bend the top tab to secure the panels in place.
- Connect the fixture to a suitable ground in accordance to local electrical codes.
- Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
- Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
- Secure the fixture to the post with post screws.
- Screw the lamp into socket. Refer to the label on the socket for Max Wattage Information.
- Place the cover on top of the fixture and secure it in place with the cover screws.
©2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort &
Co. logo is a registered trademark of Visual Comfort & Co.
Visual Comfort & Co. reserves the right to change specifications for product
improvements without notification.
Customer Support
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.generationlighting.com
References
Read User Manual Online (PDF format)
Loading......