artika LED-51491 BK LED Vanity Bar Instruction Manual
- June 13, 2024
- artika
Table of Contents
artika LED-51491 BK LED Vanity Bar
Safety
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
-
Ladder
-
Safety glasses
-
Electrical tape
-
Phillips screwdriver
-
Flat blade screwdriver
-
Pliers
-
Wire strippers
Package Content
-
Frame
-
Diffuser
-
Fixture Pan
-
Mounting Unit
-
Fixture Screws
-
Set Screws
-
Mounting Screws
-
Wire Nuts
-
Anchor Screw
-
Anchor
Assembly Instructions
STE P 1
Use the mounting screws to attach the mounting unit to the junction box
STE P 2
Make the electrical connection from the junction box to the fixture. . Connect
the ground wire to the mounting unit using the preinstalled green ground
screw. Then, connect the positive, negative and ground wires with the supplied
wire nuts. . Secure with electrical tape.
Connect Clear, Brown, Gold or Black Parallel Wire without tracer (round &
smooth) or Black Fixture Wire to:
Black or Red Supply Wire or Insulated Wire (other than green) with copper
conductor.
Connect Clear, Brown, Gold or Black *Parallel Wire with tracer (square &
ridged) or White Fixture Wire to:
White Supply Wire or Insulated Wire (other than green) with silver conductor.
STE P 3
Secure the Fixture Pan with Fixture Screws to the mounting unit. And then use
Set screws to secure the Frame to the Fixture Pan
35W LED bulb included.
