EONEBATW-B ZigBee Smart Thermostat User Guide

EONEBATW-B ZigBee Smart Thermostat

Product Information

Product Usage Instructions

To use the EONEBATW/B ZigBee Smart Thermostat, please follow the steps below:

1. Ensure that the thermostat is powered by the included Li-ion battery (3.7V).
2. Connect the control box (ECB62ZB) to the power supply using L, N 230V AC.
3. Make sure the control box components (EMODZB, EREL1ZB12A, Relay Module) are properly connected.
4. Refer to your boiler’s instructions to connect the thermostat to the boiler using the provided Boiler – Boiler connection*.
5. Place the temperature sensor in a suitable location to accurately measure the room temperature.
6. If required, connect the occupancy sensor or ON/OFF contact to the designated input terminals (S1, S2).
7. Configure the thermostat settings and desired heating mode using the wireless communication (ZigBee) and the provided controls.
8. Monitor and adjust the thermostat settings as needed to maintain the desired temperature.

For more information and support, please visit www.engocontrols.com.

CONNECTION

ZigBee Smart Thermostat

FEATURES

LEGEND

• Battery powered
• Fuse
• L, N: 230V AC power supply
• COM, NO, NC: Voltage-free output
• Boiler – Boiler connection * – Boiler’s contacts for ON/OFF thermostat (according to the boiler’s instructions)
• Ground (electricity)
• Pump
• Valve actuator
• Temperature sensor
• Thermoelectric actuator
• Wireless communication
• Heating mode
• S Occupancy sensor or ON/OFF contact
• S1, S2 Input terminals
• SL 230V AC voltage output

www.engocontrols.com.

References

• ENGO Controls - Sterowanie ogrzewaniem

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>