Vesta 750CFM 30 Stainless Steel Under Cabinet User Manual
- June 13, 2024
- VESTA
Table of Contents
Vesta 750CFM 30 Stainless Steel Under Cabinet
Warning
-
Installation work and electric wiring (including switch location) must be done by the qualified person(s) in accordance with local applicable codes and standards. including fire-rated construction.
-
This hood may have sharp edges. Be careful to avoid cuts and abrasions during installation and cleaning.
-
The hood must be placed at a minimum distance of 60cm from the cook panel.
-
Sufficient air is needed for proper combustion and exhausting of gases through the chimney of fuel-burning equipment
to prevent back drafting. Follow the heating equipment manufacturer’s guidelines and safety standards such as those published by the National Fire Protection Association. and the American Society for Heating. Refrigeration and
Air Conditioning Engineer (ASHRAE). and the local code authorities. -
Ducted fans must always be vented to the outdoors.
-
This appliance is designed to be operated by adults. Children were not allowed to tamper with the controls or play with this appliance.
-
WARNING: To reduce the risk of fire or electric shock. do not use this fan with any solid-state speed control device.
-
When cutting or drilling into a wall or ceiling. do not damage electrical wiring and other hidden utilities.
WARNING – TO REDUCE THE RISK OF FIRE. USE ONLY THE METAL DUCTWORK TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP FIRE, OBSERVE THE FOLLOWING
- SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner, BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
- NEVER PICK UP A FLAMING PAN – You may be burned.
- DO NOT USE WATER. including wet dishcloths or towels – a violent steam explosive will result
- Use an extinguisher ONLY if:
- You know you have a Class ABC extinguisher, and you already know how to operate it;
- The fire is small and contained in the area where it started:
- The fire department is being called;
- You can fight the fire with your back to an exit.
WARNING – T O REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
- Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
- Always turn hood ON when cooking at high heat or when flambeing food.
- Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.
- Use proper pan size. Always use cookware appropriate for the size of the element.
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSON, KEEP IN MIND THE FOLLOWING:
- Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
- Before servicing or cleaning the unit, switch the power off at the service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.
Tools Needed
Parts & Accessories
Product Dimension
Installation
Feed the wires through the hole
- Slide the range hood under the cabinet and slide the vent adapter into the vent
- Secure with screws.
Connect round vent to vent adapter. Seal with aluminum foil tape.
Connect the wires:
- Black to Hotline
- White to Neutral line
- Green to Ground line
- Secure with “Twist-on Caps”
Operations
Introduction Of Control Panel
The hood is operated using 3 3-speed push button switch on the front panel.
- Press the “On/Off” button once, it will turn into the “start condition”. In this condition, press the “Slow”, “Medium” or “Fast” button, the motor will be turned on at slow, medium, or fast speed respectively. Press these three buttons again, it will stop working.
- When the cooker hood is working, press the “On/Off’ button, it will count down for one minute, after one minute, the cooker hood will stop working, or press the “On/Off’ button two times, and it will stop working.
- Press the “Light” button once, the light will turn on. Press it again, it will turn off.
Specifications
- Body Stainless Steel /lempered Glass
- Power Rating 120V/60Hz(USA & Canada standard)
- General Input Power 120W + SW of Light x\bltage of Light
- Motor Input Power 75W*2
- Motor Revolution 1350 RPM (± 10%)
- Levels Of Speed Control 3
- Maximum Airflow 750 CFM
- Air Pressure 150 Pa (200 Pa Maximum)
- Noise Level (dB/ sone) Approximately 35 / 0.7 to 67 / 6.5 (Lowest to highest Speed)
- Motor Type Single Chamber Ultra Quiet
- Fan Type Centrifugal / Sirocco
- Control Type Electronic louch Control
- Filtration Type Baffle Filter
- Illumination LED light 2Wx2
- Venting Size lop, 6 inches Round
- Interference Protection Radio Frequency Interference Protected
Subject to change without notice, please contact your local reseller for details.
Warranty
TO OBTAIN SERVICE UNDER WARRANTY
You must present proof of the original purchase date.
Please provide an original dated proof of purchase (sales receipt/invoice) in
order to obtain service under warranty.
Lifetime Motor Warranty
The motor, which is covered by a lifetime warranty, should be provided free of
charge by your local reseller given it failed
due to manufacturing defects. Subject to the conditions and limitations set
forth below, your local reseller should, at its option, either repair or
replace it with a new or refurbished motor to be functionally equivalent to
new. The consumer is responsible for all shipping costs.
One Vear Parts Warranty
For one year from the date of the original purchase, your local reseller will
provide free-of-charge, non-consumable replacement parts or components that
failed due to manufacturing defects. Subject to the conditions and limitations
set forth below, your local reseller will, at its option, either repair or
replace any part of its products that prove defective by reason of improper
workmanship or materials. Repaired parts or replacement products will be
provided by your local reseller on an exchange basis, and will be either new
or refurbished to be functionally equivalent to new. The consumer is
responsible for all shipping costs. Consumable parts not covered by this
warranty include but are not limited to Light bulbs, metal, aluminum, and
charcoal filters.
Who is Covered
This warranty is extended to the original purchaser for products purchased for
ordinary home use.
This Warranty Will Be Voided When
Product damage through negligence, improper installation, accident, or abuse.
misuse. natural disaster. insufficient or excessive electrical supply,
abnormal mechanical or environmental conditions, or any unauthorized
disassembly, repair, modification, or failure to follow installation
instructions. When a product is used commercially or other than its intended
purpose. Damaged because of improper connection with equipment of other
manufacturers. Repaired or modified by anyone other than your local reseller’s
authorized agents. This limited warranty also does not apply to any product on
which the original identification information has been altered, obliterated or
removed, has not been handled or packaged correctly, or has been sold as
second-hand.
What is Not Covered
Consumable parts such as light bulbs, and metal and charcoal filters. The
natural wear of finish, and wear due to improper maintenance, use of corrosive
and abrasive cleaning products, pads, and oven cleaner products. Chips, dents
or cracks due to abuse. misuse. freight damage. or improper installation.
Damage of product caused by accident, fire. floods or acts of God. The
manufacturer and/or distributor/reseller is not liable for this. and does not
cover under warranty, any loss of properties or any costs associated with
removing, servicing, installing, or determining the source of problems with
this product.
This warranty is valid in the country of the original purchase at retail. It
is non-transferable and applies only to the original purchaser and does not
extend to subsequent owners of this product. Any applicable implied
warranties, including the warranty of merchantability, are limited in duration
to a period of express warranty as provided herein beginning with the date of
original purchase at retail, and, no warranties, whether express or implied.
shall apply to this product thereafter.
To obtain warranty service, you may contact your local reseller from which you
purchased this product. Please confirm the terms of your local reseller’s
policies prior to contacting us. Typically, you must include product
identification information. including the model number and serial number with
a detailed description of the problem you are experiencing. You must also
include proof of the date of original retail purchase as evidence that the
product is within the applicable warranty period.
Disclaimer
-
Carefully inspect all items for damages before accepting delivery. Note any damages on the freight bill or express receipt. Request the name and signature of the carrier’s agent and keep a copy to support your claim. Upon acceptance of items, the owner assumes responsibility for their safe arrival. Report damages to
the carrier and file a claim immediately. Failure to do so may result in the denial of your claim. The carrier will furnish you with the necessary forms for filing a claim. -
Damages caused during transit are not covered under our warranty. Please contact us to file an insurance claim.
-
Please inspect the contents of the package(s) carefully upon receiving it! We must be notified of any damages and/or missing parts within five (5) days of your receipt of the package(s). Claims will not be accepted after five (5) days.
NOTE: Items were thoroughly tested and carefully packed in our factory before shipping. -
Products must be returned in good working condition with ALL original parts and documentation packed in ALL original cartons, fillers, and shipping cartons. A restocking fee of 15% will be charged for all approved return(s). Exchanges or returns may not be accepted if any packaging is missing.
-
Make sure to inspect the hood for damages and defects before installation. Appearance flaws of the hood found after installation and not affecting hood performance are not covered under our warranty for returns or exchanges. Service visits not covered under warranty will carry a service charge.
-
Before Installation: Return for exchange or refund (please see above for acceptable returns).After Installation: NO exchange or refund.
Service Contact
Thank you for choosing Vesta as your preferred provider for kitchen
appliances. We are committed to providing you with exceptional customer
service and support.
If you require assistance with any of our products, please do not hesitate to
contact us. You can reach our customer service team by choosing one of the
methods below and one of our representatives will respond to you promptly.
Thank you for your business, and we look forward to serving you soon
- Phone: 905-727-8688 9:30 am-5:00 pm (Eastern Time), Monday to Friday. except holidays
- Email: service@vesta.kitchen
- Online form: https://www.vesta.kitchen/service
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>