flow-med Calm Charge Hand Warmer And Power Bank Instruction Manual

flow-med Calm Charge Hand Warmer And Power Bank

Product Information

4 LEDs:
100%)

Product Usage Instructions

1. Plug the USB cable into a USB power supply and the USB-C plug into the USB-C socket of your CalmCharge.
2. Plug the USB power supply unit into a mains socket.
3. Depending on the power source (USB power supply), the device is charged and ready for operation in approximately 4 to 8 hours.
4. The charging status is indicated by the 4 Blue LEDs: 1 LED represents 25% charge, 2 LEDs represent 50% charge, 3 LEDs represent 75% charge, and 4 LEDs represent 100% charge.

Maintenance:

• Wipe with a damp cloth or suede cloth.
• Do not use aggressive cleaning agents or water.

Warnings:

• The disposal of this electronic product and the built-in lithium-ion battery must be carried out exclusively in accordance with the locally applicable regulations.
• Do not dispose of it with household waste.

INSTRUCTION FOR USE

Starting up

1. Plug the USB cable into a USB power supply and the USB-C plug into the USB-C socket of your CalmCharge.
2. Then plug the USB power supply unit into a mains socket.
   • Depending on the power source (USB power supply), the device is charged and ready for operation in approx.
   • 4 to 8 hours. i4 Blue LEDs show the charging status (1 LED 25%, 2 LED 50%, 3 LED 75%, 4 LED 100%)

Operation POWER BANK

• Briefly press the ON/OFF button to switch on the charging function.
  • i4 Blue LEDs show the power status (1 LED 25%, 2 LED 50%, 3 LED 75%, 4 LED 100%)
• Connect mobile devices such as smartphones, smartwatches, EarPods, hearing aids, hearing aid charging stations, humidifiers, and many more to the sockets 2x USB-A or USB-C with the enclosed USB cable.
• You can charge or operate all DC 5V USB devices up to 22.5 watts with the POWER BANK.
• The Power Bank will automatically turn off when the battery is empty (the 4 blue LEDs switch off) or press the ON/OFF button twice briefly.

Operation HAND WARMER

• Hold the ON/OFF button for 3 seconds to turn on the HAND WARMER function. orange LED light-up
• In about one minute, the two aluminum heating surfaces heat up to approx. 45°C (113°F). You can use the pleasant warmth between your hands or wear it on your body.
• The hand warmer will turn off automatically after 30 minutes or press and hold the ON/OFF button for 3 seconds.

Maintenance

Wipe with a damp cloth or suede cloth. Do not use aggressive cleaning agents or water.

Warnings

Converting, opening, or modifying the product impairs product safety. Caution Risk of injury! Handle the product with care. It can be damaged by shocks, impacts or falling from even a low height. Keep the product away from moisture and extreme heat. Never immerse the product in water or other liquids. Batteries do not belong in the hands of children. Do not heat the battery above 60°C (140°F) and do not throw it into fire: risk of explosion and fire! Do not short-circuit the battery. Never discharge the battery completely, this will shorten its lifetime. If the battery is to be stored for a longer period of time, a residual capacity of approx. 30% is recommended.
This device is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience and/or knowledge unless they have been given supervision or instruction concerning the use of the device by a person responsible for their safety!

Disposal

The disposal of this electronic product and the built-in lithium-ion battery must be carried out exclusively in accordance with the locally applicable regulations! This device has the WEEE-Reg. No. DE 47525015 and is accepted as electronic waste at the designated collection points. Do not dispose of it with household waste!

• flow-med GmbH

• Weinberger 10

• 73773 Aichwald

• Germany

• Item No. 106 00000,

• Model: WELL-HW01 Document No. IFU_10600000_2023-06-06
  © 2010-2023 flow-med GmbH. All rights reserved.

• www.flow-med.com.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>