Amazon Basics PBH-55473 8-Sheet Strip Cut Paper Instruction Manual
- June 13, 2024
- amazon basics
Table of Contents
Amazon Basics PBH-55473 8-Sheet Strip Cut Paper
Warning: Read Safety Instructions Before Using!
- Read all instructions carefully before installing or using the shredder.
- Avoid touching the feed slot with your hands.
- The product is not intended for use by children (the product is not a toy).
- Do not insert foreign objects into the feed slot.
- Do not spray or keep any aerosol products in or around the shredder.
- Keep loose clothing or jewelry away from the feed slot.
- Avoid getting hair near the feed slot.
- Always turn the shredder off and unplug the power cord from the AC outlet when not in use, before cleaning, moving, or emptying the waste basket.
- RISK OF FIRE. Never use any petroleum-based or flammable oils or lubricants in or around the machine as some oils can combust causing serious injury.
- NEVER dispose of flammable chemicals OR materials that have come into contact with flammable chemicals (for example, nail polish, acetone, and gasoline) in the shredder basket.
- Never shred large paper clips, window or insulated envelopes, continuous forms, newsprint, bound pages (for example notepads, checkbooks, magazines, etc…), transparencies, laminated documents, cardboard, any items with adhesives, hard materials or plastic (except Credit Cards and CDs).
- Do not hold a CD/DVD with your finger through the center ring while feeding into the shredder. Serious injury may occur.
- A socket outlet should be near the equipment and be easily accessible.
- Never let the waste basket become full. This will lead to shredded material being pulled back up into the shredder and cause jams.
- Never place the shredder near water or any heat source.
- Do not use the shredder if the power cord is damaged in any way.
- Do not attempt to service this product yourself as doing so may expose you to sharp cutting blades and/or electricity and will void the manufacturer’s warranty.
- Never try to clean or clear the shredder blade.
- Never shred beyond the specified sheet capacity. This may result in extensive damage to the Paper Shredder.
Operating Instructions
-
Sheet Capacity:
- 7 sheets of 80 gsm paper*
- 8 sheets of 70 gsm paper*
-
Paper Shred Size:
- Shreds paper into 6 mm wide strips
-
Paper Entry Width:
- 220 mm
-
Credit Card & CD Capacity:
- Shreds CDs into 4 pieces
- 1 at a time
-
Duty Cycle:
- 2 min. on / 15 min. off
-
Voltage:
- 220-240V/50-60Hz 0.8A
-
One Folded Sheet of Paper equals two (2) Sheets of Paper
-
Heavier paper, humidity, or other than rated voltage may reduce shredding capacity.
Installation
- Mount the shredder securely to the rim of the waste basket. (FIGURE 1)
- A socket outlet should be near the equipment and be easily accessible.
- Connect the power cord to any standard 220-240 volt wall AC outlet.
Caution:
- Shredders may have very sharp exposed blades on the underside.
- Care should be taken while mounting the shredder on the wastebasket.
Operation
Control Switch:
- AUTO: Automatically starts shredding when the paper is inserted. Feed paper straight. Shredder stops automatically once the paper has passed through.
- OFF: Turns off all shredder features. For safety, it’s recommended to set to “Off” when not in use or unattended.
- REV (REVERSE): Used to clear paper jams. Empty the wastebasket before attempting to clear a jam with this function.
Jam Remover / CD Destroyer:
- The forward setting can help clear paper jams by manually activating the shredder.
- To shred CDs/DVDs, lift the safety cover, press the CD Destroyer button, and feed one disc at a time into the slot. Release the button after the disc has been destroyed and close the cover.
Paper / Credit Card Entry:
- Ensure you do not exceed the maximum sheet count (8 sheets max). Feed paper straight and release.
- Insert only one credit card at a time into the middle of the feed slot.
Note:
- Always turn off and unplug the shredder when not in use.
- This shredder will shred staples and small paper clips. It is recommended that you remove paper clips whenever possible to extend the lifespan of your shredder.
- Only shred credit cards by feeding them vertically into the middle of the feed slot, releasing them when shredding begins. Never feed more than one credit card at a time.
- Overfeeding the shredder: Shredding beyond the specified sheet capacity can result in extensive damage to the shredder. Overfeeding will strain the machine and quickly wear and break the cutting blades and internal components.
- Overheating with extended use: In the event that the shredder has shredded continuously beyond the maximum running time and overheating, the unit will automatically shut off. If this happens, switch the shredder off for 15 minutes or longer before resuming normal operation.
Maintenance
Warning: Not maintaining the shredder as instructed will void the manufacturer’s warranty.
Monthly Maintenance
- Oil the shredder blades monthly using vegetable, cooking oil, or shredder oil. This prolongs the blade’s lifespan.
Oiling Procedure:
- Turn off the shredder.
- Spread shredder oil across the feed slot.
- Activate the shredder in reverse mode for 3-5 seconds.
- Note: Shredder oil is NOT provided with the product.
Caution
- Do not spray or keep any aerosol products in or around the shredder.
- DO NOT USE CANNED AIR ON THE SHREDDER.
Cleaning:
- Never use anything flammable to clean the shredder. This may result in serious injury or damage to the product.
- ALWAYS UNPLUG THE SHREDDER BEFORE CLEANING!
- Only clean the shredder by carefully wiping the unit with a dry soft cloth or towel.
- Do not clean or immerse the shredder in water. Having the unit wet may result in damage or malfunction to the electrical components. If the shredder happens to get wet, be sure to completely dry the unit immediately with a cloth or towel, before using.
Troubleshooting
If there is a problem with your shredder, check below for the symptoms and steps to resolve. If you continue to have problems, contact customer support. DO NOT ATTEMPT TO REPAIR BY OPENING THE SHREDDER HEAD. This will completely render the manufacturer’s warranty void.
- The shredder does not work at all.
- Make sure the unit is plugged in and that the outlet is in good working order.
- Overheating with extended use: In the event that the shredder has shredded continuously beyond the maximum running time and overheated, the unit will automatically shut off. If this happens, switch the shredder off for 15 minutes or longer before resuming normal operation.
- If using a plastic bag to line the wastebasket, please remove it. This may cause the shredder not to operate properly.
- The activation sensor of the shredder is located near the center of the feed slot. Be sure to feed directly into the center area to activate the machine (especially applies to smaller pieces of paper or credit cards).
- The shredder runs in “Rev (Reverse)” mode but not in “Auto (On)” mode. While in “Auto” mode, the motor will not start running until the paper is inserted into the feed slot. Set the unit to “Auto” and insert paper to shred. The sensor that activates the shredder in Auto mode is located directly in the center of the slot. If the paper you are inserting is narrow, it may not be activating the optical sensor. It is also possible that the feed slot has become blocked with paper. Insert an index card or any rigid sheet of cardstock (old greeting card or folded file folder), directly in the center of the feed slot, while applying force to help push the jammed paper through. This will usually clear any paper blockage.
- How to clear a paper jam in the shredder.
- Switch the shredder to Reverse (REV) mode. While in Reverse, the shredder will back up and loosen the jammed paper. If required, you may need to tug and remove several sheets to effectively clear the machine. When jammed paper is loosened or removed, switch back to the Auto-On mode to continue shredding. Repeat the above steps if needed.
- With stubborn situations where the reverse function does not help, you may loosen the jammed paper with shredder oil (cooking oil is acceptable, DO NOT USE AEROSOL). Start by drizzling oil into the feed slot where the paper is jammed. Let it soak for about 30 minutes to completely saturate. Return the shredder back to Auto-On mode. If required, an index card or a rigid sheet of cardstock (old greeting card or folded file fold-er) can be fed into the shredder to help push the jammed paper through.
Power switch in the auto position
Use thick paper stock or greeting card to push the jam through
- The shredder is constantly running while in “Auto (On)” mode.
- It is possible that the activation sensor, which starts the shredder, has become blocked with paper. Insert an index card or any rigid sheet of cardstock (old greeting card or folded file folder), directly in the center of the feed slot, while applying force to help push the jammed paper through. This will usually clear any paper blocking the activation sensor and feed slot.
- The activation sensor is being triggered by dust, debris, or oil. A cotton swab may be used to clean the sensor. DO NOT USE CANNED AIR. The activation sensor of the shredder is located around the center of the feed slot.
2018. All rights reserved. Amazon and the AmazonBasics logo are trademarks of Amazon.com, lnc. or its affiliates. All other trademarks are the property of their respective owners.
FREQUENTLY ASKED QUESTIONS
What should I be aware of before using the shredder?
Always read all instructions before using. Avoid touching the feed slot with hands and ensure that children don't treat it as a toy.
Can foreign objects be inserted into the feed slot?
No. Never insert foreign objects, aerosol products, or flammable chemicals.
How should I handle the shredder around clothing, jewelry, and hair?
Keep loose clothing, jewelry, and hair away from the feed slot to prevent accidents.
How many sheets can the shredder handle at once?
It can handle 7 sheets of 80 gsm paper or 8 sheets of 70 gsm paper.
Can it shred CDs and credit cards?
Yes, it can shred CDs into 4 pieces (one at a time) and credit cards.
How do I clear a paper jam?
Switch the shredder to Reverse (REV) mode. For stubborn jams, you might need to use shredder oil or manually push the jam through with a card.
How often should I oil the shredder?
It is recommended to oil the shredder blades monthly.
How should I clean the shredder?
Wipe it with a dry soft cloth or towel. Do not use water or flammable cleaning agents.
My shredder doesn't work. What should I check?
Ensure it's plugged in and the outlet is functional. Check for overheating or obstructions like plastic bags. Make sure to feed paper directly into the center of the slot.
The shredder operates in 'Reverse' but not 'Auto'. Why?
The activation sensor may not be detecting the paper. Ensure you feed paper in the center. If the paper is narrow, it might not activate the sensor.
The shredder runs continuously in Auto mode. How can I fix it?
The activation sensor might be blocked by paper or debris. Clean it with a cotton swab, avoiding aerosol sprays.
Does opening the shredder for repairs affect the warranty?
Yes, attempting to service or open the shredder yourself will void the manufacturer's warranty.
VIDEO – PRODUCT OVERVIEW
DOWNLOAD THE PDF LINK:Amazon Basics PBH-55473 8-Sheet Strip Cut Paper Instruction Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>