GREISINGER GTP-SG Temperature Transducer Instruction Manual

June 13, 2024
GREISINGER

GEISINGER GTP-SG Temperature Transducer

GREISINGER-GTP-SG-Temperature-Transducer-PRODUCT

General

The transducer is ready to use and specially designed for top hat rail mounting.

Safety instructions

This device has been designed and tested in accordance to the safety regulations for electronic devices. However, its trouble-free operation and reliability cannot be guaranteed unless the standard safety measures and special safety advises given in this manual will be adhered to when using it.

  1. Trouble-free operation and reliability of the device can only be guaranteed if it is not subjected to any other climatic conditions than those stated under “Specification”.Transporting the device from a cold to a warm environment condensation may result in a failure of the function.In such a case make sure the device temperature has adjusted to the ambient temperature before trying a new start-up.

  2. General instructions and safety regulations for electric, light, and heavy current plants, including domestic safety regulations (e.g. VDE), have to be observed.

  3. If the device is to be connected to other devices (e.g. via PC) the circuitry has to be designed most carefully. Internal connection in third-party devices (e.g. connection GND and earth) may result in not-permissible voltages impairing or destroying the device or another device connected.

  4. Whenever there may be a risk whatsoever involved in running it, the device has to be switched off immediately and to be marked accordingly to avoid re-starting. Operator safety may be a risk if:

    • there is visible damage to the device
    • the device is not working as specified
    • the device has been stored under unsuitable conditions for a long time
      In case of doubt, please return the device to the manufacturer for repair or maintenance.
  5. Warning: Do not use this product as a safety or emergency stop device or in any other application where failure of the product could result in personal injury or material damage.
    Failure to comply with these instructions could result in death or serious injury and material damage.

Housing

Assignment

GREISINGER-GTP-SG-Temperature-Transducer-
FIG-2 GREISINGER-GTP-SG-Temperature-Transducer-
FIG-3

Disposal instructions

  • This device must not be disposed of as “residual waste”.
  • To dispose of this device, please send it directly to us (adequately stamped).
  • We will dispose of it appropriately and environmentally friendly.

Specification

  • Sensor element:
    • Pt100, NiCr-Ni
    • Pt100 (RT 420), RT420
  • Measuring range:
  • please refer to a type of plate
  • please refer to the type of plate
  • Output signal:
    • please refer to the type of plate
    • 4-20mA
  • Accuracy electronic: (at nominal temperature)
    • < ±0.2% FS (Full Scale) Pt100
    • < ±0,2% FS (Full Scale) ±0,5°C NiCr-Ni
    • range < 250°C: < ±0.25°C
    • range > 250°C: < ±0.1% FS (Full Scale)
  • Temperature coefficient:
    • 0.05 % / °C
    • 0.01 % / °C
  • Auxiliary energy: (supply voltage)
    • 12 … 30V DC
    • 18 … 30V DC (0-10V output)
    • 8 … 35V DC
  • Permissible impedance: (current output)
    • 4-20mA: < ( (Uv-12V) / 0.02) Ohm
    • 0-20mA: < 150 Ohm
    • < ((Uv – 8V) / 23)*1000 Ohm
  • Permissible load: (voltage output)
    • 3000 Ohm

  • Reverse voltage protection:
    • max. 50V dauernd
    • max. 35V
  • Nominal temperature:
    • +25 °C
    • +23 °C ± 2°C
  • Operating temperature:
    • 0 … +70 °C
    • -20 … +70 °C
  • Storage temperature:
    • -20 … +70 °C
    • -20 … +70 °C
  • Relative humidity:
    • 0 .. 95% r.H. noncondensing
    • 0 .. 95% r.H. noncondensing
  • Dimensions/housing:
    • approx. 22.5 x 78 x105 (H x W x D), for top hat rail mounting
  • Connecting terminals:
    • For cable with max. 1.5mm² cross-section
  • EMC:
  • The device corresponds to the essential protection ratings established in the Regulations of the Council for the Approximation of Legislation for the member countries regarding electromagnetic compatibility (2004/108/EG). In accordance with EN 61326 (appendix B, class B), performance criterion D

93128 Regenstauf, Hans-Sachs-Straße 26

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

GREISINGER User Manuals

Related Manuals