IKEA LED2104R3 TRÅDFRI LED Bulb GU10 345 Lumen Smart wireless Dimmable Warm White User Guide
- June 13, 2024
- Ikea
Table of Contents
- IKEA LED2104R3 TRÅDFRI LED Bulb GU10 345 Lumen Smart wireless Dimmable
- Product Information
- Product Usage Instructions
- USING INSTRUCTIONS
- RESET YOUR DEVICE
- TECHNICAL DATA
- Installation Instructions
- Battery Installation
- More Information
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
IKEA LED2104R3 TRÅDFRI LED Bulb GU10 345 Lumen Smart wireless Dimmable
Warm White
Product Information
- Product Name: LED2104R3
- Manufacturer: IKEA of Sweden AB
Product Usage Instructions
- Before using the light source, you need to pair it with a steering device.
- Ensure that the light source is installed and the main power switch is turned on.
- Hold the steering device within 5 cm (2 inches) of the light source you want to add.
- Press and hold the pairing button on the steering device for at least 10 seconds.
- A red light will shine steadily on the steering device, indicating pairing mode.
- The light source will dim and flash once to confirm successful pairing.
- You can pair up to 10 light sources with one steering device.
- Pair the light sources one at a time, ensuring they are not close to each other.
- If the light sources are close, disconnect those that have already been paired from the main power switch.
- CAUTION: Do not use with standard dimmers. Only use the control provided with or specified by these instructions. This bulb is only controllable by IKEA Smart lighting products.
- To reset the device, toggle the main switch 6 times.
Note: The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. Please recycle the item in accordance with local environmental regulations. Contact your IKEA store for more information.
USING INSTRUCTIONS
ADD LIGHT SOURCES TO YOUR STEERING DEVICE
Before you can use your light source you’ll need to pair it with a steering device. To add more light sources, just repeat the steps below:
- Make sure that your light source is installed and the main power switch is turned on.
- Hold the steering device close to the light source you want to add (no more than 5 cm away).
- Press and hold the pairing button for at least 10 seconds. A red light will shine steadily on the steering device. Your light source will begin to dim and finally flash one time to indicate that it has been successfully paired.
Up to 10 light sources can be paired with 1 steering device.
Make sure to pair them one at a time. If the light sources are close to each
other, disconnect those that have already been paired from the main power
switch.
CAUTION: DO NOT USE WITH STANDARD DIMMERS. Only use the control provided with or specified by these instructions to control this bulb. This bulb will not operate properly when connected to a standard (incandescent) dimmer or dimming control. Only controllable by IKEA Smart lighting products.
RESET YOUR DEVICE
- Toggle the main switch 6 times.
TECHNICAL DATA
- Operating frequency: 2405 – 2480 MHz
- Output power: 10 dBm
Installation Instructions
Battery Installation
More Information
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN
Disposal
The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or landfills and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.
© Inter IKEA Systems B.V. 2022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>