HOVERFLY H600 GKS Kids Electric Scooter User Manual
- June 14, 2024
- HOVERFLY
Table of Contents
- H600 GKS Kids Electric Scooter
- Don’t Ride Until You Read This
- Unpack
- Get To Know Your Scooter
- Assemble Your Scooter
- Charge Your Scooter
- Scooter Console Functions
- Riding Tips
- Maintenance & Repair
- Battery Information
- Troubleshooting
- HOVERFLY www.hoverflys.com
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
GKS
KIDS ELECTRIC SCOOTER
USER MANUAL
H600 GKS Kids Electric Scooter
Congratulations on your purchase!
This user manual will help you assemble and operate your new electric
scooter. Be sure to read ALL OF THE INFORMATION in this manual before riding.
NOTE TO ALL RIDERS UNDER 18 YEARS OF AGE;
It’s very important that you get parental permission before riding your
electric scooter.
Don’t Ride Until You Read This
ALWAYS wear a helmet when riding your electric scooter.
Make sure your scooter has a full battery before taking it out to ride.
Always be aware of local road laws, and follow them.
Do not ride the scooter under the influence of drugs or alcohol.
Always respect pedestrians.
Do not ride under wet conditions. The scooter may slide from under your feet
causing injury.Wet conditions may damage the electronics and void the
warranty.
Warning Message
-
Avoid water – The scooter is not waterproof. The electronics may be damaged due to water and water damage is not covered by our warranty.
Riding in wet conditions is also very dangerous and may result in injury. -
Abuse – We do not cover physical damage due to negligent care and extreme riding.
-
Whenever you ride the HOVERFLY electric scooter, you risk severe injury or even death from loss of control collisions, and falls. Use caution and ride at your own risk.
-
Do not modify the product from the manufacturer’s original design.
-
Keep hands and all body parts away from moving parts while operating the scooter.
-
Before riding – be sure to check the scooter over and make sure the scooter is operating correctly before each use.
-
Before riding – be sure to check that the braking system is functioning properly; also be sure to check that all safety labels are in place and you understand the safety warnings.
-
Before riding – be sure that any and all axle guards, chain guards, or other covers or guards supplied by the manufacturer are in place and in serviceable condition.
-
Before riding – be sure to check that the tires are in good condition, inflated properly, and have sufficient tread remaining.
-
Never exceed the 55 kg maximum load rating.
-
The electric scooter should never be used by children under the age of 6.
-
Maximum Speed – Your electric scooter goes the maximum speed of 12 km / h.
Unpack
You should find each of these items in your box:
- Scooter Front & Rear Wheel Compartment
- Tiller & Handlebars
- Approved Power Adapter / Charging Unit
- 4 mm Allen wrench
- 6 mm Allen wrench
- 4 Screws
Remove all packing material, then inspect each item for any accidental damage that may have occurred during shipping.
Get To Know Your Scooter
Specifications
Top Speed: 12km /h
Max Weight: 55kg
Battery Charger: DC 29.4V 0.4A
Distance per Charge: 6.5 km
Charge Time: 5 Hours
Battery Type: 25,2V 2.0AH
Motor Power: 150W
Power Requirements: AC 110 ~ 240V 50 /80Hz
Product Size: 67.5x25x22.8cm
Assemble Your Scooter
ASSEMBLE FRONT AND REAR WHEEL COMPARTMENTS
Assemble the fronf wheel compartment and rear wheel compartment together, Take
the 4 screws and use the Bmm Allen Wrench to tighten the screws. Once the
screws are tightened, open the kickstand and straighten the scooter out.
INSERT TILLER INTO THE HEAD TUBE WITH WRENCH
Take the tiller component and insert the tiller into the head tube, use the
4mm Allen wrench to tighten. REMOVE SCREW FROM BLOCK ON TOP OF THE
TILLER
Use 4mm Allen wrench to remove the screws from the block on the top of the
tiller, put the handlebar on and cover with the top of the block. Tighten the
screws. Test the scooter after yoi/ye finished assembling.
Charge Your Scooter
Before using the scooter, you must fully charge the battery.
- Open the rubber charging port cover.
- Insert the charging plug into the port.
- The charger box will have a green light when fully charged and a red light when charging.
- When you are done charging be sure to cover the charging port to keep it clear of dust and debris.
- Charging Time: 5 hours
Scooter Console Functions
To power the scooter on, you must place your foot on the front button and
kick to start.
To accelerate the scooter, you must place your first foot on the front
button and kick to start. Once you have the scooter moving then place your
second foot on the back button to engage the electric motor to accelerate.
( Caution: While riding the scooter if you don’t wish to accelerate any
more remove your foot from the back button and the motor will turn off).
To brake, remove /our back foot from the back button and place /our foot
on the rear fender brake to slow down or stop.
Riding Tips
- You will want to start riding your scooter with one foot on the front button and one foot on the ground. Use your foot on the ground to push off.
- Press the rear fender foot brake with your foot to slow down or stop.
- The scooter performs best when on a smooth surface e.g. car parks, smooth roads, footpaths, & bike lanes.
- Always clean your scooter (wheels, platform, etc.), it’s a machine and it needs to be maintained.
- Be aware of the terrain you are riding on, watch out for curbs and obstacles!
Maintenance & Repair
If you regularly clean and maintain your electric scooter, it will extend its
life.
Cleaning and storage: If the electric scooter surface is dirty, wipe it
clean with a soft cloth.
DO NOT use alcohol, gasoline, kerosene, or other corrosive chemical
solvents to clean the scooter. It can severely damage the appearance and
structure of the scooter. Please do not use a pressure washer as it may also
cause damage to the electronics.
Storage: When you’e not using your scooter store in a dry and cool
location.
Avoid storing your scooter outdoors because sun exposure can damage its
appearance and may cause wear on the life of the battery and tires.
Battery Information
Only use the approved HOVERFLY power adapter to charge your scooter, others
may cause risk of fire & equipment may be damaged.
Improper disposal of used batteries may seriously pollute the environment.
Please comply with local disposal regulations.
Make sure to store your scooter and power adapter in conditions that do not
exceed 50 C or below-20 C.
Warning – Risk of Fire – No User Serviceable Parts, The prolonged
exposure to UV Rays, Rain and the Elements may damage the enclosed materials,
store indoors when not in use.
Troubleshooting
We frequently update our user manuals at
HOVERFLYS.com, and reserve the rights to update and
change manuals online.
Please contact our customer service team if you are experiencing problems or
need more detailed information. They can be reached by mail:
support.au@hoverflys.com
Warranty
For warranty information, contact us by mail: support.au@hoverflys.com.
HOVERFLY www.hoverflys.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>