Govee H6088 Cube Wall Sconces User Guide
- June 13, 2024
- Govee
Table of Contents
Govee H6088 Cube Wall Sconces
- Clean the surface and make sure there is no dust or debris on it.
- Determine the location of the power supply.
A. Power supply on the right (Arrow on the base points upwards and the base without cable on the leftmost side)
B. Power supply on the left
(Arrow on the base points downwards and the base without cable on the
rightmost side)
- Pull the cable under the base to lengthen it. Twirl the built-in handle to shorten the cable. Determine the distance between two lights by adjusting the cable under the base.
- Peel off the protective film of the adhesive tape. Determine the distance between each base and stick them all onto the wall. Firmly press each for more than 15 seconds.
- Start installing from the light that is far away from the power supply.
Attention: Installation errors might occur if you do not follow this sequence.
- As shown in the image, the cable under base N0.2 pass through the built-in cable clip of base N0.1 and is plugged into the input end of the light.
- After that, fit the base N0.1 into the slots on the light and slide upwards or downwards to fix the light onto the base. Twirl the built-in handle of base N0.2 clockwise to adjust the length of the cable.
- Repeat the steps of plugging the cable from next base into the input end and the cable of the corresponding base into the output end, and fixing the light onto the base.
- Plug the cable of the control box into the input end of the last light. Then plug the cable of the corresponding base into the output end. Fix the light onto the base.
- After connecting all lights, connect to the power adapter and plug into power. Enjoy!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>