BOSS Audio Systems MCK632WB.6 Weatherproof Receiver and Speaker User Manual

BOSS Audio Systems MCK632WB.6 Weatherproof Receiver and Speaker

PRECAUTIONS

Lithium Battery Cell Warnings

• Cell leakage may cause damage to the remote control.
• Do not throw cells into fire, as this may cause an explosion.
• Keep battery cells out of reach of children.

Use cautions

• To reduce the risk of fire, electric shock, and annoying interference, do not repair yourself. Please refer serving to qualified person.
• Some MP3/MA files may not be playable.
• Keep lower volumes to concentrate on traffic and road conditions for safety driving.
• If users’ car is under sunlight for sometime, please lower the temperature inside the car then start the player operation.
• If the battery is disconnected or discharged or changed, the preset memory will be erased and must be reprogrammed.
• Installation of unit is better at a horizontal position, or if it is at an angle, it may be not working at its best situation.
• Never use force or grip the display and the buttons tightly when removing or attaching,
• Be sure to lower the volume before switching off the unit or the ignition key.

INSTALLATION

Installation Procedures
First complete the electrical connections and then check for correctness.

Installation Opening

****This unit can be installed in any dashboard Having an opening as shown above .

• Only use speakers with 4 ohms impedance.

• Do not attach the control panel to the chassis before wiring is complete.

• The maximum current of the auto antenna is 200mA.

• Insert mounting collar into the dashboard and bend the mounting tabs out with a screwdriver. Make sure that lock lever is flush with the mounting collar( not projecting outward).

• Secure the rear of the unit. After fixing mounting bolt and power connector, fix the rear of the unit to the car body by bubber cushion.

Wiring Connections

Uninstall the Main Unit

• Remove the metal strap from the main unit.
• Remove the plastic trim out from the main unit.
• Insert a bracket key into the left and right side of the main unit and draw the unit out of the mounting sleeve.

CONTROL PANEL BUTTON LOCATIONS

OPERATION

POWER/SRC
Press the POWER button to turn on the unit,and long press it again to turn off the unit. When the unit turn on,short press POWER/SRC button to switch the unit between RADIO, USB, CARD, BT, AUX IN, modes (if there are USB and SD card inside the unit). 1/. If there is no USB & SD card, then it will be only radio, BT and Aux. When the user inserts a USB flash drive or SD Card, their respective logos will illuminate on the display.

(button 1 to 6) PRESET MEMORY BUTTONS In Radio mode
To memorize the frequency, press one of the six preset buttons (1-6) hold for more 2″S, the frequency is successfully stored. Therefore there are FM1, FM2,FM3, AM1 & AM2,each band can store 6 stations,so total 30 stations can be stored. To recall the preset momory station, press one of the preset buttons(1-6) plus the BND buttion for FM1, FM2, FM3.AM1 & AM2.

• During USB or SD card mode, press the ‘1/ >||‘ button to pause or resume music playback.
• Press the ‘2/INT’ button to play the first 10 seconds of each track, press again to stop the introduction scan, and play the current track.
• Press the ‘3/RPT’ button to repeat the current track, press again to stop repeat plaback and resume normal playback.
• Press the ‘4/RDM’ button to play all tracks in random order, press again to cancel random playback.
• During USB or SD card mode, press ‘5/-10’ button to go backward 10 tracks.
• Press ‘6/+10’ button to jump foward 10 tracks.
• During USB or SD card mode, long press ‘5/-10’ button to go back 1 folder.
• Long press ‘6/+ 10’ button to go up 1 folder. You can repeat this function depending o the number of folders. This button will have no function if the USB or SD card has no folders.

CLK

• Press the CLK button once to display the real time, With time appearing on the display.Press and hold
• CLK button for more than 2 seconds until the hour flashes. You can adjust the HOUR by pressing the >> button and < button. Then press the CLK button briefly, the minute will flash, you can adjust the
• MINUTE by pressing the >> button and I<< button.
• Finally press the CLK button to confirm the time adjustments.

SD CARD SLOT

• Press the , button to detach the front panel, and remove the front panel, then you can insert an
• SD card into this SD card slot, install and close the the front panel, this player will read and play the songs on the SD card automatically.
• To remove the SD card from the unit, press the button to detach and remove the front panel, then push the SD card with your finger nail, the SD card will be ejected.

VOLUME adjustment
In the radio mode, rotate the volume knob to increase or decree the volume level of the sound output. Press the volume knob, it will be switching the sequence as follows:

Rotate the VOL knob on the front panel or press the VOL+/- button on the remote contol to to adjust the selected item.

At the radio status,press and hold the VOL button to enter switch state of the US(USA) and EU (EUROPE frequency, then rotate the VOL knob to select US frequency or EU frequency, after selecting US or EU frequency, the system will switch to the selected frequency 3 seconds later.

FF( >>|) &12.FB(|<<)
In the radio mode:

• Long press the >> or < button for more than 2 seconds, the unit will switch to manual tuning mode, briefly press the >> or <‹ button to search the next or previous frequency step by step.
• Short press the >> or << button, the automatic search will start, it will search upward or downward for the strong signal radio station within the cuttent band. The auto searching will stop until find a station.

In the USB or SD card mode:

• Briefly press the >> or I<‹ button to play the the next or previou track.
• Press and hold the ›› or I<‹ button to fast forward or fast backward.

BND/AMS

In radio mode,short press the BD/AMS button repeatedly to select the one of the radio band: FM 1, FM 2,FM 3, AM1,AM2 in a cycle sequence. When you select a band, the word F1. F2, F3 for FM band, and A1, A2 for AM band will be shown on the LCD display.

Press the BND/AMS button for several seconds, the radio searches form the current frequency and check the signal strength until one cycle search is finished. When the 6 strongest stations will be stored into the corresponding preset number within the current band. Short press the AMS button on the remote control to scan each preset station in each band.

During USB or SD playback, short press the BD/AMS button to enter track search mode, then rotate the VOL knob to select the number of your favorite track with high speed, then press the SEL button to confirm and play the selected track. If no any operation in 5 seconds it will play the current track

MUTE
Short press the MUTE button to turn MUTE ON/OFF, when it is on, the MUTE will be flash on the LCD and no sound output. When short press again it will be cancelled.

USB PORT

AUX IN JACK

If you want to insert or remove the SD, reset the unit, remove the front panel from the head unit, press the button to detach the front panel.

RESET
To reset all parameters to factory default values. Press the § button to detach the control panel form the head unit and remove the control panel,then use a subject with a sharp point end to thrush the RESET hole.

BLUETOOTH OPERATION

Pair and Connect
Prior to using the Bluetooth device as a handsfree system for a Bluetooth- enabled mobile phone for the first time, you must pair and connect the two devices as follows:

• In any mode, prior to pairing and connecting, the BT logo flashes in the LCD indicating that no device is connected. To begin pairing, enable BT mode on your mobile phone.
• When the phone finds the car audio system, the “BOSS MR632UAB” will be displayed.
• Choose the BOSS MR632UAB from the device list to pair and connect with the car audio system. Upon confirming, the BT logo will stop flashing.
• When pairing is complete, the mobile phone audio will automatically transfer to the car audio system whenever a call is made or received, or when the mobile phone play  musIc.

Make a Call

• To make a call, dial the call directly from the paired mobile phone.
• To make a call with this Bluetooth handsfree system.
• When linking up the Bluetooth mobile phone to this car audio handsfree system, press the button to access the dial telephone number mode, then press the “ “, * and # button on the remote control to input the telephone number, the entered number will be shown on the LCD.
• If a number has been incorrectly input, press the DEL button or * button to delete it.
• Press the button to make outgoing call.

Redial Last Dialed Number
Press and hold the button on the control panel to redial the last dialed phone number.

Answer a Call

• When the mobile phone is called, the incoming telephone number displays in the LCD.
• To receive the call, press the button on the control panel or remote control.

Reject or End a Call

• To reject the call or end an active call, press the button.
• Switch Audio Between Car and Phone
• During a call, press the VOL knob/button to switch the audio source from the car audi system back to your mobile phone.

Adjust Talk Volume

• During a call, use VOL knob or VOL + and VOL – buttons to adjust the volume level.
• Use the MUTE button to mute sound.

Audio Streaming (A2DP)

• Press the U/SRC button to enter BT mode and display media in the LCD.
• When a mobile device is paired, music played through that device will automatically be heard through the car audio system.
• Press the >>| or I<< button to play the next or previous song/file on the mobile phone.
• Press the >|| button to pause or resume music plavback.

REMOTE CONTROL

Remove Insulating Sheet
The remote control comes with an insulating sheet attached to the underside of the remote control, as illustrated on the right. The remote control will not work until the insulating sheet is removed.

Replace Lithium Battery Cell

• When the lithium cell battery becomes weak, replace it as illustrated on the right.
• Press and hold the movable block in the direction indicated by arrow 1. At the same time, pull the cell holder out of the remote control in the direction indicated by arrow 2.
• Replace the old cell with a new one, making sure the (+) polarity is facing upward.
• Re-insert the cell holder into the remote control.

Remote Control Operation

• Position the emitting window of the remote control toward the sensor window of the unit.
• The operation angle for front panel remote control reception is about 30 degrees.
• The distance between the emitting window of the remote control and the sensor window of the unit should remain less than 5 meters.

Button Names and Locations

• Power button
• BAND or button

• or 1 button

• + 10 or 6 button
• INT (intro) or 2 button
• MUTE or DEL button
• – 10 or 5 button
• RPT (repeat) or 3 button
• AMS (automatic music search) or 9 button
• LOUD (loudness) or 8 button
• CLK (clock) or button
• VOL (volume) button
• SEL (select) button
• PREV (previous) button
• RDM (random) or 4 button
• ST (stereo) or 7 button
• NEXT button
• SRC (source) or * button
• EQ(Equalizer) or 0 button
• LOC (local) # button

TROUBLESHOOTING

If you suspect something is wrong immediately switch power off. Do not use the unit in abnormal condition, for example without sound, or with smoke or foul smell, can cause fire or electric shock Immediately stop using it and call the store where you purchased it. Never try to repair the unit yourself because it is dangerous to do so.

SPECIFICATIONS

General

• Power supply Requirement : DC 12V
• Maximum power output : 50W X 4CH
• Speaker impedance : 4 – 8 Ohm
• Unit Dimensions(WxHxD) : 7.0 X2.0 X 3.8 inch
• Weight: 1.54 Lb (0.7 kg)
• Fuse: 15 A

RADIO

FM
Frequency Range USA / EUROPE: 87.5 MHz – 107.9 MHz / 87.5 MHz – 108.0MHz
Channel step: 200 KHz / 50 KHz

AM
Frequency Range USA/ EUROPE: 530 KHz – 1710 KHz / 522-1620 KHz
Channel step: 10 KHz / 9 KHz

USB/Card

• Usable Audio Formats………………… MP3/WMA
• Pre-amp Output………………………Front and Rear
• Frequency Response………………..20 Hz – 20 KHz
• S/N Ratio ……………………………..60dB

ВТ
BT Profile supports………………….Headset, Handsfree and A2DP & AVRCP profiles
Range of frequency…………………. 2.4GHz spectrum

Boss Audio System

• 3451 Lunar Court
• Oxnard, CA 93030
• www.bossaudio.com
• 805.322.8794
• tech support: www.bossaudio.com/support/technical-support

FAQs

What is the BOSS Audio Systems MCK632WB.6?

The BOSS Audio Systems MCK632WB.6 is a weatherproof marine receiver and speaker package designed for use on boats and other marine vehicles.

Is this package easy to install on a boat?

Yes, this package is designed for easy installation on boats and comes with mounting hardware and instructions for setup.

What is the power output of the receiver?

The receiver in this package has a maximum power output of 600 watts per channel.

Are the speakers also weatherproof?

Yes, the speakers in the BOSS Audio Systems MCK632WB.6 package are weatherproof and built to withstand marine conditions.

Can I connect my smartphone to this system via Bluetooth?

Yes, this system features Bluetooth connectivity, allowing you to wirelessly stream music from your smartphone or other Bluetooth devices.

Is there a USB port for media playback?

Yes, the receiver has a built-in USB port for playing music from USB drives or charging your devices.

What is the size of the display screen on the receiver?

The receiver features a X-inch color display screen for easy navigation and control.

Can I listen to AM and FM radio with this system?

Yes, the receiver includes AM/FM radio functionality with presets for your favorite stations.

Are there EQ controls for adjusting the sound?

Yes, the receiver has built-in EQ controls to customize the sound to your preferences.

Is a remote control included with this package?

Yes, a wireless remote control is included, allowing you to control the system from a distance.

Can I use this system with other marine electronics?

Yes, the BOSS Audio Systems MCK632WB.6 is compatible with other marine electronics and can be integrated into your boat's audio setup.

Download This PDF Link:BOSS Audio Systems MCK632WB.6 Weatherproof Receiver and Speaker User Manual

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>