biamp SPA-RAIL48 Desono Ceiling Loudspeaker Accessories Instruction Manual

: June 13, 2024
: biamp

Table of Contents

SPA-RAIL48 Desono Ceiling Loudspeaker Accessories
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SPA-RAIL48 Desono Ceiling Loudspeaker Accessories

Desono™

PRELIMINARY
Ceiling Loudspeaker Accessories
48″ Tile Rails with Adapters

Installation Guide

Biamp offers 48″ tile rails for Desono ceiling loudspeakers. CM
and C-IC6 loudspeakers utilize adapters with the mounting
rails included with the loudspeakers. Please refer to the
appropriate Installation and Operation guide for additional
information on installation methods.

Note: Loudspeakers do not need to be placed in the center of the
large ceiling tile if there are other elements above the ceiling or in
the tile.

D Series Installation

1. Place 48″ tile rails with flat side in (as shown) the
appropriate distance apart and install the C-Ring.
Install the ceiling tile and loudspeaker per regular
installation practice. 24″ rails not needed.

CM Series Installation

Push a gasket onto the edge of one side of each tab on
both ends of the 24″ tile rail.
Note: These gasketed ends sit against the 48″ rails and
prevent any chattering during loudspeaker operation.
Place 48″ tile rails with flat side toward the opening the
appropriate distance apart and place the 24″ rails on the
flat of the larger rail with gaskets against the 48″ rail’s
vertical wall (as shown).
Push an adapter onto the rails close to each end of the
shorter rails capturing the vertical walls of each rail. The
fit will be tight (see detail for placement).
Place a tile bridge (included with the CM models) onto
each pair of adapters as shown, and align around the
opening in the ceiling tile.

A: 9300 S.W. Gemini Drive Beaverton, OR 97008 USA W: www.biamp.com

5. With the dog ears rotated in, install the
loudspeaker in the ceiling tile. Rotate the dog
ears out and down to fit into the channels in
the 24″ tile rails. Do not deform the ceiling by
tightening the dog ears too much.

C-IC6 Installation

Place 48″ tile rails with flat side in (as shown) the
appropriate distance apart and place the 24″ rails on the
flat of the larger rail. (Shown with tile in place)
Push an adapter onto the rails at each end of the
shorter rails capturing the vertical walls of each rail. The
fit will be tight (see circle detail).
Install the C-ring onto the 24″ rails; center on the
opening. Secure the C-ring with the provided screws.
With the dog ears rotated in, insert the loudspeaker up
through the C-ring and ceiling.
Rotate the dog ears out and down to fit onto the C-ring.
Do not deform the ceiling by tightening the dog ears too
much.

A: 9300 S.W. Gemini Drive Beaverton, OR 97008 USA W: www.biamp.com

Desono™ Ceiling Loudspeaker Accessories

48″ Tile Rails with Adapters

SPECIFICATIONS

H x W x D: 37 x 26 x 1248 mm[1.46″ x 1.02″ x 49.12″] Material / Finish: Zinc- plated 1.2mm steel (tile rails),
Black ABS (adapter), black rubber (gasket)
Quantity per kit: 2 sets of rails, adapters, gaskets
Unit Weight: 3.0 lbs (1.4 kg) pair

Scan this QR-code and navigate to
your loudspeaker model to download
the appropriate installation guide

bia.mp/DesonoCeiling_pubs