Flow RS3 8V Sedan FL Front Lip Splitter Winglets Pair Installation Guide
- June 13, 2024
- FLOW
Table of Contents
FITTING DIAGRAM
AUDI RS3 8V FL SEDAN V3: FRONT BOLT-ON INSTRUCTIONS
RS3 8V Sedan FL Front Lip Splitter Winglets Pair
INSTALLATION AND FITTING SERVICES
If you are having any difficulties please seek professional advice from the
listed International and Domestic Authorised Dealers on our website.
www.flowdesignsaustralia.com
CONFIGURATION 1
FRONT EXTENSIONS ONLY
- Insert bolts loosely into alocated brass thread locations.
- Slide extensions in and out to your liking.
- Use a 4mm hex key to hand tighten.
PLEASE NOTE : DO NOT OVERTIGHTEN – These bolts do not need to be very tight.
CONFIGURATION 2
FRONT WINGLETS ONLY
- Insert bolts loosely into alocated brass thread locations.
- Slide and pivot winglets to your liking.
- Use a 4mm hex key to hand tighten.
PLEASE NOTE : DO NOT OVERTIGHTEN – These bolts do not need to be very tight.
CONFIGURATION 3
FRONT EXTENSIONS AND WINGLETS
- Insert bolts loosely into alocated brass thread locations.
- Slide and pivot extensions and winglets to your liking.
- Use a 4mm hex key to hand tighten.
PLEASE NOTE : DO NOT OVERTIGHTEN – These bolts do not need to be very tight.
FITTING KIT
a| M6 BOLT
12mm LONG
X 8
PLEASE NOTE:
DRILLING NOT REQUIRED
TO FASTEN TO SPLITTER
DO NOT OVERTIGHTEN
---|---
b| M6 BOLT
20mm LONG
X 4
PLEASE NOTE:
DRILLING NOT REQUIRED
TO FASTEN TO SPLITTER
DO NOT OVERTIGHTEN
---|---
c
| M6 10mm BOLT
- BLACK CHICAGO
BOLT
X 2
DRILLING NOT REQUIRED
TO FASTEN TO SPLITTER
DO NOT OVERTIGHTEN
---|---
PLEASE NOTE
FOR ADD ON ACCESSORIES
DO NOT OVERTIGHTEN FASTENERS INTO BRASS FITTINGS HAND TIGHTEN ONLY
FLOW DESIGNS AUSTRALIA
ABN : 99 605 842 199
10 LONGSTAFF RD
BAYSWATER
VIC, 3153
TERMS AND CONDITIONS : MISUSE OF GOODS
This Product application is not intended for public road registered vehicles
within Australia.
Regulatons may vary from Countries outide of Australia.
Please check your Country’s and State’s road regulatons before installing on a
vehicle intended for public road use.
Flow Designs Australia PTY LTD will not be liable for any liabilities in
relation to any use of the goods other than in strict accordance with the
Company’s instructions and for the purpose and application for which the goods
were supplied by the Company.
The Client undertakes with the Company:
That it will acquaint itself with the requirements of all relevant government
or statutory and other authorities, bodies or corporations relating to the
goods and/or services and to the applications to which the goods and/or
services are to be put; That at all times while the goods are in its
possession or under its control it will comply with such requirements;
That it will procure that any purchaser of goods from it will also acquaint
itself with, and will comply with, such requirements;
That it will indemnify the Company against any liability resulting from a
breach of any such requirements.
www.flowdesignsaustralia.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>