CleanSkin Digital Shock Pump User Manual
- June 13, 2024
- CleanSkin
Table of Contents
CleanSkin Digital Shock Pump
Remove the battery insulation sheet before use (fig 1)
Button Functions
- Button “A” Power/Change units (PSI? BAR? KG/CM2)
Operation Mode Start-Up
1. Manual start-up Press Button “A”.
2. Automatic start-up When pressure is above 5 psi the digital gauge will turn on automatically.
Trouble shooting
To reset the gauge press and hold Button A for 9 seconds to return the gauge to zero(0). (fig 2)
Battery Replacement
- Unscrew the 4 screws that are on the back of the gauge base
- Lift out the gauge cap
- Take out LCD digital gauge
- Open battery cap and replace the new 3V battery(CR2032). Please note that the positive pole (+) should face towards the battery cap and be inserted correctly.
- Please make sure the O-ring in the bottom of the gauge is still there when replacing the battery
WARNING: KEEP OUT OF REACH OF CHILDREN
This product contains a Lithium Button/Coin Cell Battery. Swallowing can lead
to chemical burns, perforation of soft tissue and severe or fatal injuries
within 2 hours of ingestion. If swallowed or placed inside any part of the
body seek medical attention immediately.
Battery Disposal
- Please ensure safe disposal of discharged button/coin batteries immediately.
- Place sticky tape around both sides of the battery and dispose of it immediately in an outside bin, out of reach of children, or recycle safely.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>