Sanihair Trap 4106GDFX Hair Trap Installation Guide
- June 13, 2024
- Sanihair Trap
Table of Contents
Sanihair Trap 4106GDFX Hair Trap Installation Guide
RECOMMENDEND USE
The SANIHAIR hair trap is designed for use in hair salons where excessive hair
and lint pose a large risk of blocking pumps, and can incur high ongoing
service costs as a result. The installation of a hair trap on hair wash basin
drains provides a simple and efficient filter prior to a pump. This cost
effective solution gives an easy to maintain and proactive method of
preventing loss of business and extends the lifespan of the connected pumps.
The SAN I HAIR hair trap can be connected to up to 3 hair wash basins
- DO NOT dispose of solvents, paints, turps, caustic acid, or other corrosive acids or cleaners.
- DO NOT use cleaning products that produce excessive foam, this may cause motor damage to your pump connected to this hair trap.
- DO dispose of grey waste water from hair wash basins ONLY.
INSTALLATION
Below typical SANIHAIR hair trap installation picking up 2 x hair wash basins connected to the pump using 50mm DWV waste pipe. Make sure the hair wash basins are trapped as per the plumbing code.
DIMENSIONS
TECHNICAL CHARACTERISTICS
COMMISSIONING
- Once ALL connections are secure to your SANIHAIR hair trap switch the power on to the pump connected to the trap, run the cold water tap for short period and allow water to enter the hair trap which in turn will overflow to the pump.
- Your pump should immediately activate and begin discharging into the discharge pipe system. Initial run time is normally between 5-10 seconds. Duration of run time is generally determined by the length of travel in the pump out line.
- Pump operation will shut down after this time.
- Check all connections for leaks to both the hair trap and the pump as the final commissioning process.
NOTICE
⚠ Warranty only applied when the hair trap is connected to Saniflo SFA pumps
MAINTENANCE
To clean the filter basket remove the sealed screw top lid by loosening anti clock wise, once lid has been removed lift the basket by the attached handle whilst tilting the base of the basket slightly away from the protruding waste pipe, this will enable basket removal for cleaning.
Remove hair then rinse the basket before reinstalling, the frequency of cleaning will depend on number of hair wash basins connected and how busy the salon is.
WARRANTY
2 YEAR WARRANTY
This device is guaranteed for 2 years from the date of purchase and is subject
to ACL (2) 2010 and NZ CG Act 1993 if used for personal, domestic and
household use.
Installation in strict compliance with manufacturers installation.
Read more at pro.saniflo.co.nz/cms/47 /warrantyconditions.
WARRANTY CONDITIONS
This warranty will apply only under all of the following conditions:
- The item has been installed by a licensed plumber
- Failure is due to a fault in the manufacture of the product
- Proof of purchase (including the date of purchase) is provided
- The installation of the product is in accordance with the instructions provided.
SANIFLO’S DESIGN SERVICE
We know our products well and we also have extensive experience in where they
are used.
Contact us on technical@saniflo.com.au and we will help with your projects and
plans.
SFA Australia Pty Ltd
Tel: 1300 554 779
General enquiries
info@saniflo.com.au
Technical & project support
technical@saniflo.com.au
WWW.SANIFLO.COM.AU
SFA New Zealand Ltd
Tel: 0800107264
General enquiries
info@saniflo.com.nz
Technical & project support
technical@saniflo.co.nz
WWW.SANIFLO.CO.NZ
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>