POWERTEQ F250 A Pillar Display Mount Instruction Manual
- June 13, 2024
- POWERTEQ
Table of Contents
POWERTEQ F250 A Pillar Display Mount
Product Information
The Gauge Mounting Arm is designed for installation on 2011-2016 F250-F350 vehicles. It is made of durable materials to ensure long-lasting performance. The package includes a Mounting Arm, Washer Bolt, Nut Dual Tab, and all the necessary tools for installation.
Product Usage Instructions
- Start by gathering the required tools: 7 mm Socket, 3 1/4 Drive Extension, 1/4 Drive Socket Wrench, Small 1/7 Flat-blade Screwdriver, and 3 mm Allen Wrench.
- Locate a suitable spot on your vehicle’s dashboard or instrument panel where you want to mount the gauge. Ensure it provides good visibility and accessibility.
- Take the Mounting Arm and align it with the chosen spot. Make sure it is securely positioned.
- Using the 7 mm Socket and the 3 1/4 Drive Extension, attach the Mounting Arm to the dashboard or instrument panel using the provided Washer Bolt. Tighten it firmly, but be careful not to over-tighten.
- Take the Nut Dual Tab and insert it into the designated slot on the Mounting Arm. This will secure the gauge in place.
- Now, prepare the gauge you want to mount on the Arm. Refer to the gauge’s instruction manual for specific installation steps.
- Once ready, carefully align the gauge with the Nut Dual Tab on the Mounting Arm and slide it into place. Ensure it fits securely.
- If necessary, use the Small 1/7 Flat-blade Screwdriver and the 3 mm Allen Wrench to make any adjustments or tighten any screws on the gauge.
- Double-check that the gauge is firmly mounted and properly aligned. Make sure it does not obstruct your view or interfere with any other controls.
- Once satisfied with the installation, test the gauge to ensure it is functioning correctly. Following these instructions will help you properly install and use the Gauge Mounting Arm on your 2011-2016 F250-F350 vehicle.
Materials
Required Tools
For 2011-2016 F250/F350
- 7 mm Socket
- 3 1/4” Drive Extension
- 1/4” Drive Socket Wrench
- Small 1/7” Flat-blade
- Screwdriver
3 mm Allen Wrench
Mounting Arm Installation
- On the driver’s side A-pillar grab handle, carefully remove the lower cover by prying it loose using a screwdriver.
- Remove the exposed bolt. Keep the cover and bolt should you wish to return the vehicle to stock.
- Using the hardware included with the mounting arm, install the flat washer on the bolt and insert the bolt through the mounting arm.
- Insert the mounting arm into the hole and use an Allen wrench to tighten the bolt into the pillar. The arm can be positioned in the desired position by loosening or tightening the bolt.
- Remove the dual tab and nut (black plastic parts) from the bag. If the dual tab and nut are screwed together, unscrew them slightly from one another until the nut moves freely.
- Snap the nut and dual tab over the ball on the mounting arm and tighten the nut (if the nut won’t go onto the ball, the tab and nut may need to be unscrewed further).
- Attach your device to the dual tab and secure the cord. Adjust the device position using the mounting bolt and/or the dual tab/nut.
Copyright© 2022
D10027100 Rev00 02/18/2022
For additional questions not found in the user guide call
Powerteq Technical Support : (801)-476-3343 6:00 am – 5:00 pm MST To
expedite your support call, please have your Vehicle Information, Part Number,
and Serial Number ready prior to calling Technical Support.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>