RHINO RACING YD-2 C-LSD Differential Unit Centrifugal Limited Slip Instruction Manual
- June 13, 2024
- RHINO RACING
Table of Contents
RHINO RACING YD-2 C-LSD Differential Unit Centrifugal Limited Slip
OVERVIEW
- 4 pieces or 2 pieces on the opposite side optional V-shaped shrapnel (limited slip intervention fast or slow 0. 15/0. 2 different thickness)
- Please use a 7-8mm post to spread the leaf spring to 75-80°, then install it into the leaf spring slot.
INSTALLATION INSTRUCTION
- The full load is 4 sets of pinions. 2 or 4 sets of installation can be selected.
- 2 groups of limited slip strength are small, 4 groups of limited slip strength are strong) Choose according to the track or personal habits.
- After all gears are assembled, a little anti-wear oil needs to be applied to the surface of the gears.
- Notice! Because the pinion pin is only fixed at one end at this time, and the other end shakes to generate a large gap, which causes the 181 output shaft to be installed at the large gap position by mistake.
- Therefore, the second 18 output shaft needs to be carefully aligned with the gear during installation.
- Notice! If the gearbox cover is difficult to install, it is because the installation of the 18T output shaft is wrong, please check again whether the installation of the 18T output shaft is correct.
- Finally, install and fix the gearbox cover.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>