MAGNAFLOW 19668 Overland Series Axle Back Exhaust System Instruction Manual
- June 13, 2024
- MAGNAFLOW
Table of Contents
INSTALLATION
INSTRUCTION
JEEP WRANGLER OVERLAND PART NO. 19668
BILL OF MATERIALS:
- MUFFLER ASSY.
- MIDPIPE ASSY.
- NDT RESONATOR
- PIPE CAP
SHOP SUPPLIES:
WEAR SAFTEY GLASSES READ INSTRUCTIONS THOROUGHLY BEFORE INSTALLING PRODUCT
SPRAY LUBRICANT
To ease removal of existing exhaust components (especially on older vehicles)
spray penetrating lubricant on all fasteners and hangers/insulators that will
be loosened or removed and let soak before disassembly.
MINIMUM REQUIRED TOOLS:
MAGNAFLOW RECOMMENDS PROFESSIONAL INSTALLATION ON ALL THEIR PRODUCTS
WARNING: When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust
system temperatures may cause severe burns. If working without a lift always
consult vehicle manual for correct lifting specifications. Always wear safety
glasses and ensure a safe work area. Serious injury or death could occur if
safety measures are not followed.
ATTENTION: Always install any supplied band or U-bolt clamps to the
proper torque specifications of 40-45 ft-lb for band clamps and 30-35 ft-lb
for U-bolt clamps. Over tightening will result in the clamps breaking and will
NOT be warranted by MagnaFlow.
INSTALLATION INSTRUCTION
Step 1. Remove the OEM system by loosening the over-axle TORCA clamp. Then disconnect the OE rubber hangers and remove the OE muffler.
Step 2. Next, slide the MagnaFlow axle-back into the OE over-axle pipe and loosely clamp to hold in place. Then slide the hangers into the factory rubber insulaters. Next attach the NDT resonator and clamp in place.
Step 3. Once a final position has been chosen for the new exhaust system, evenly tighten all clamps from front to rear using the torque specifications on page one of the instructions. Inspect all fasteners after 25-50 miles of operation and re-tighten if necessary.
MAGNAFLOW: 1901 Corporate Centre Dr – Oceanside, CA 92056 |
1(800)990-0905
Technical Support: 1(800) 959-9226 | Email:
moreinfo@magnaflow.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>