CANRMNA IPL370A01 Pendant Light Instruction Manual
- June 4, 2024
- CANRMNA
Table of Contents
CANRMNA IPL370A01 Pendant Light
|
I NSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS READ ALL
INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
---|---
OUTILS ET MATERIAUX REQUIS:
Phillips Screwdriver
| Wire Cutters
---|---
Pliers|
Wrench
Wiring supplies as required by local electrical code
SAFETY PRECAUTIONS:
- TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
- THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
- CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
- TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION
-
Mount the mounting bracket to outlet box using outlet box screws (not included).
-
Screw the centre rod to the fixture.
-
Adjusting the length of flexible cord. For safety, do not release the knot inside canopy.
-
Connect the ground wires (bare copper or green) from your fixture to the ground wire (bare copper or green) or ground screw in the electrical box. Connect the black wire from the fixture to the black wire in the electrical box and connect the white wire from the fixture to the white wire in the electrical box.
-
Once wire connections are completed, carefully tuck wires and wire nuts into the electrical box making sure no bare wire (on the black and white) is visible at the wire nuts.
-
Attach fixture to mounting bracket by tightening the 2 screws.
-
Remove spinner nut from socket. Position glass on lamp and secure with spinner nut.
-
Install proper bulb type and wattage (not included).
