Ambrus 9270382_11784234 EntryDoor-Hardware-Installation-Trilingual Instruction Manual

: June 13, 2024
: Ambrus

Table of Contents

BEFORE YOU BEGIN
GETTING STARTED
ADDITIONAL QUESTIONS?
HARDWARE INCLUDED
INCLUDED
- Accessories Kit
TOOLS AND MATERIALS
INSTALLATION
DUMMY INSTALLATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Ambrus 9270382_11784234 EntryDoor-Hardware-Installation-Trilingual

Ambrus 9270382_11784234 EntryDoor-Hardware-Installation-
Trilingual

BEFORE YOU BEGIN

We recommend consulting a professional if you are unfamiliar with installing door hardware. Signature Hardware accepts no liability for any damage to the door, hardware, or for personal injury during installation.

Observe all local building codes.

Unpack and inspect the product for shipping damage.
If any damage is found, contact our Customer
Relations team via live chat at www.signaturehardware.com or by emailing support@signaturehardware.com.

GETTING STARTED

Ensure that you have gathered all the required materials that are needed for the installation.
NOTE: This doorset works on a minimum door thickness of 1-3/4” (44mm) and maximum door thickness of 2” (50mm)

ADDITIONAL QUESTIONS?

Still need help? Check out our Help Center at www.signaturehardware.com for product and warranty information, or contact us through live chat or by emailing support@signaturehardware.com.

HARDWARE INCLUDED

Deadbolt Latch Kit

Deadbolt Latch Kit

Passage Latch Kit

Passage Latch Kit

INCLUDED

Accessories Kit

TOOLS AND MATERIALS

Safety Glasses
Drill
Wood Chise
Phillips Screwdriver

INSTALLATION

Confirm that your door has 2 bore holes drilled into the door. This doorset works for both 2-3/8” and 2-3/4” backsets. Please check that your deadbolt and passage latch match the backset.

Bore Hole CTC distance: 5 1/2”
Bore Hole Size: 2 1/8”
Cross Bore Size: 1”
Drill a third, 15mm diameter hole located 2-1/4 inches (center to center) below the bottom bore hole.
Note: This hole is for mounting the two halves of the hardware together in the final assembly step.
Insert the passage and deadbolt latch into the appropriate cross bore on the edge of the door using the supplied screws. The passage latch inserts into the bottom hole and the deadbolt latch into the upper hole.
Do not tighten screws until installation is complete.
Insert the lock housing into the exterior escutcheon plate. Mount the exterior escutcheon plate to the exterior side of the door.
Add the interior escutcheon plate to the interior side of the door. The interior assembly and exterior assembly should fit into the deadbolt latch and passage latch.
Secure both escutcheon plates together and to the door by first installing the two Lock Housing screws.
These two screws insert through the interior escutcheon on either side of the thumb latch and fasten back into the lock housing.
Install post screw on interior escutcheon plate.
Before installing screws you will need to predrill holes into the door. Install screws into door through exterior escutcheon plate using the appropriate hardware. Tighten all fasteners, including screws through dead bolt and latch bolt on side edge of door.