HAIL 954A-L3106B LED Instruction Manual
- June 13, 2024
- HAIL
Table of Contents
HAIL 954A-L3106B LED
Product Information:
- Product Name: HAIL
- Model: 954A-L3106B
- Power: 5W
- Color Temperature: 3000K
- Luminous Flux: 480lm
- Input Voltage: 220-240V~
- Frequency: 50/60 HZ
- IP Rating: IP65
- Impact Resistance Rating: IK08
- Light Source: LED
- Energy Efficiency Class: F
Product Usage Instructions
- Ensure that the power supply is within the specified input voltage range (220-240V~ 50/60 HZ).
- Mount the product in a suitable location, ensuring the IP65 rating provides protection against dust and water.
- Connect the product to the power supply.
- To turn on the product, switch it to the ‘ON’ position.
- If available, adjust the detection area of the daylight and motion sensor according to your preference.
- If necessary, apply silicone grease to the product for maintenance purposes.
- To select different modes or settings, refer to the provided instructions specific to your model.
Note: This product contains a light source with energy efficiency class F. Please consider the energy consumption and efficiency of this product when using it.
SPECIFICATION
DIMENSION
Should the diffuser break, the product cannot be used and you should contact the manufacturer for its replacement.
Electronic equipment sensitive to voltage surges.
This product contains a light source with energy efficiency class F.
- The safety of this luminaire is guaranteed only if you comply with these instructions; remember to conserve in a safe place.
- Ensure adequate voltage and frequency is supplied to the equipment.
- Disconnect from the main power before performing or any maintenance.
- The installation should be carried out by qualified personnel.
- The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
- Suitable for indoor and outdoor use, taking the indicated IP rating into consideration.
Keep away from direct contact to the ground and chemical substances
Do not use water high pressure cleaners.
INFORMACION IMPORTANTE
Technical data: see fixture label
SAFETY INSTRUCTIONS
- Electrical appliances must only be connected by competent persons.
- Important! Before commencing installation work disconnect the mains cable from the power supply – remove fuse or turn switch to “OFF”! The power supply connection must be done with the suitable connecting box, as seen on illustrations.
- This luminaire is only suitable for use in living areas (not for areas subject to moisture) and may be used only in accordance with its particular design. The maximum permissible ambient temperature is 25°C.
- Do not attach luminaires to surfaces which are damp, freshly painted, or otherwise electrically conductive.
- Connect the wires of the luminaire to the wires of the same colour that come from the wall or ceiling.
- Use support systems that are in accordance to the weight of the luminaire.
- Keep the wires and connections separated from any heat source.
- To avoid damage to concealed wiring during installation, establish the direction of the supply cable before drilling fixing holes.
- Keep these instructions in a safe place.
- Use sleeves to cover the mains supply wiring to the fitting.
- Cleaning is limited to the outer surfaces, shades or protective glass, reflectors and covers. Gold-finish and brass luminaires must be only be cleaned with a soft cloth (do not use cleaning agents of any kind). It is important to ensure that no moisture enters the terminal compartment or reaches any live parts!
- As our products are subject to technical modifications, we cannot guarantee, that all information is always up to date. Please contact our technical department with any queries.
- (Type Y) If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
- Do not cover the luminaires with insulating material.
- Do not use luminaries with frayed or cracked glass, until it is replaced
- Not hang or supporting elements on the luminaires.
- If the flexible cable or cord of this luminaire is damaged, it should be be replaced only by the manufacturer or its service or equivalent qualified or a person of equivalent qualification in order to avoid any risk.
SYMBOLOGY
SUPPLY CONNECTION
NOVOLUX Lighting, SL.
C/ Ramón Berenguer, 8 (Polígono Industrial Can Vinyals)
08130 Sta. Perpetua de Mogoda – BARCELONA – España/Spain/Espagne ESPAÑA-
PORTUGAL: Tel. +93 274 52 52 E-mail:
info@novoluxlighting.com REST OF THE WORLD:
Phone +34 93 516 20 05 E-mail:
export@novoluxlighting.com Fax +34 933
463 751 / 933 114 546
www.novoluxlighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>