UGAS 86354 Gas Lantern Instruction Manual

Instruction manual
Model 86354/3004879

Gas lantern

Introduction

To get the most out of your new gas lantern, please read through these instructions before use. Please also save the instructions in case you need to refer to them at a later date.
The product contains:

1. Metal mesh
2. Decorative stones
3. Lantern

Nominal heat output
(kW)(Hs)| 0.7
Gas consumption (g/h)| 51
Nozzle size (mm)| 0.2
Only use cartridges that are approved in accordance with EN 417.

special safety instructions

The lantern must only be used outdoors and in well-ventilated areas!
The lantern must not be exposed to precipitation and must be protected from the elements during use and storage.
The lantern must be placed on a firm, level surface before being lit.
This surface must be non-flammable, e.g.
flagstones, paving stones or packed earth.
There must be no combustible objects such as grass, plants or rubbish under or near the lantern.
Keep the lantern at a safe distance from combustible materials during use.
nOte! Keep children at a safe distance from the lantern. Do not move the lantern whilst it is lit or hot.
Never use the lantern indoors.
WarnInG! Keep children and pets at a safe distance from the lantern.
The gas canister must be changed outside at a safe distance from naked flames and other sources of ignition.
If you discover a leak, turn off the gas supply immediately and avoid naked flames and other sources of ignition. Wait a few minutes until the area has aired.

Use

1.  Unscrew the thread located at the bottom of the lantern.
2. Insert the gas canister into the thread. Press the canister up against the metal pin to pierce the canister and open the gas supply.
3. Then screw the gas canister securely into the lantern.
4. Put the decorative stones and metal mesh in position.
5. Turn the knob and light the lantern with a lighter.
6. Turn the knob in the opposite direction to shut off the gas supply and extinguish the flame.

NB: always leave the gas canister in the lantern and only remove it when replacing it.
Warning: If the burner cannot be lit, turn off the regulator. Wait five minutes before you try to light it again by following the ignition procedure.
NB: If the gas canister is screwed on too hard, you can use pliers to release it again. It is important not to screw it on using a tool, but only by hand.

storage

The lantern may only be stored indoors if the gas canister has been removed from the lantern. Store the lantern in a dry location sheltered from the wind and rain.

service centre

Note: Please quote the product model number in connection with all inquiries.
The model number is shown on the front of this manual and on the product rating plate.
• www.schou.com
Manufactured in P.R.C.
Manufacturer:
Schou Company A/S
Nordager 31
DK-6000 Kolding
All rights reserved. The content of this manual may not be reproduced, either in full or in part, in any way by electronic or mechanical means, e.g. photocopying or publication, translated or saved in an information storage and retrieval system without written permission from Schou Company A/S.

EU DECLARATION OF CONFORMITY

Manufacturer:|
---|---
Company name:| Schou Company A/5
Address| Nordager 31
Postcode| 6000
City| Kolding
Country| Denmark
This Declaration of Conformity Is Issued under he sole responsibility of the manufacturer, which hereby declares that the product
Product identification:| Gas lantern
P.I.N. no.: 0063DM7586
Art. no. 300489- 86534 Brand: UGAS
Is in conformity with the provisions of the following EU Directive(s) (Including all applicable amendments)
Reference no.| Title
(EU) 2016/426| Regulation of the European Parliament and of the Council on appliances burning gaseous fuels
References to standards and/or technical specifications applicable to this declaration of conformity, or parts thereof:
Harmonised standard no.| Title of standard
EN 521:2019+AC:2019| Specifications for dedicated liquefied petroleum gas appliances -Portable vapour pressure liquefied petroleum gas appliances.
Other standards and/or technical specifications
Standard or technical specification| Title of standard or technical specification
EU type examination| Kiwa Nederlands, Wilmersdorf 50, NL-7300 Apeldoorn. Notified body no. 0063
(1) Where possible, reference Is to be made to he applicable parts or provisions of the standard or the technical specification.
Kolding 18/10/2020
Kirsten Vibeke Jensen
CSR & Compliance Manager

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>